Application in prestiction friction compensation for angular velocity loop of inertially stabilized platforms

To overcome the influence of the nonlinear friction on the gimbaled servo-system of an inertial stabilized platforms(ISPs) with DC motor direct-drive, the methods of modeling and compensation of the nonlinear friction are proposed. Firstly, the inapplicability of LuGre model when trying to interpret the backward angular displacement in the prestiction regime is observed experimentally and the reason is deduced theoretically. Then, based on the dynamic model of direct-drive ISPs, a modified LuGre model is proposed to describe the characteristic of the friction in the prestiction regime. Furthermore, the state switch condition of the three friction regimes including presliding, gross sliding and prestiction is presented. Finally, a composite compensation controller including a nonlinear friction observer and a feedforward compensator based on the novel LuGre model is designed to restrain the nonlinear friction and to improve the control precision. Experimental results indicate that compared with those of the conventional proportion–integration–differentiation(PID) control method and the PID plus LuGre model-based friction compensation method, the dwell-time has decreased from 0.2 s to almost 0 s, the position error decreased to 86.7%and the peak-to-peak value of position error decreased to 80% after the novel compensation controller is added. It concludes that the composite compensation controller can greatly improve the control precision of the dynamic sealed ISPs.     

放映氙灯稳流及稳纹波电路研究

本文简要介绍了放映氙灯电源的现状,详细研究了由中国民航学院三维显示技术研究所最新研制成功的放映氙灯电源中的稳流及稳纹波电路的设计思想和工作原理。理论分析和实验结果表明,本文设计的稳流及稳纹波电路显著地提高了氙灯电源的可靠性及减小了氙灯电流的纹波系数且操作简便,利于推广应用。     

自旋火箭姿态运动的稳定性分析和数学仿真

本文主要对自旋火箭姿态运动的稳定性进行了分析,并给出了数学仿真结果。飞行试验结果表明,稳定性分析和数学仿真是正确、可靠的。     

Modelling ignition probability with pairwise mixing-reaction model for flame particle tracking

Reduced order models for ignition analysis can offer insights into ignition processes and facilitate the combustor optimization. In this study, a Pairwise Mixing-Reaction (PMR) model is formulated to model the interaction between the flame particle and the surrounding cell mixture during Lagrangian flame particle tracking. Specifically, the model accounts for the two-way coupling of mass and energy between the flame particle and the surrounding shell layer by modelling the corresponding turbulent mixing, chemical reaction and evaporation process if present. The state of a flame particle, e.g., burnt, hot gas or extinguished, is determined based on particle temperature. This model can properly describe the ignition process with a spark kernel being initiated in a nonflammable region, which is of practical importance in certain turbine engines and has not been rigorously accounted for by the existing models based on the estimation of local Karlovitz number. The model is integrated into an ignition probability analysis platform and is demonstrated for a methane/air bluff-body flame with the flow and fuel/air mixing characteristics being extracted from a non-reacting simulation. The results show that for the spark location being at the extreme fuel-lean outer shear layer of the recirculation zone, PMR can yield ignition events with a significant number of active flame particles. The mechanisms for the survival of the initial flame particles and the entrainment of the survived flame particles into the recirculation zone are analyzed. The results also show that the ignition probability map from PMR agrees well with the experimental observation: a high ignition probability in the shear layer of the recirculation zone near the mean stoichiometric surface, and low ignition probabilities inside the recirculation zone and the top stagnation region of the recirculation zone. The parametric study shows that the predicted shape of the ignition progress factor and ignition probability is in general insensitive to the model parameters and the model is adequate for quantifying the regions with high ignition probabilities.     

陀螺敏感轴交叉耦合对稳定平台角速度的影响分析

光电稳定平台中的陀螺装调误差影响平台角速度的测量精度。研究了速率陀螺稳定平台角速度的计算方法,重点是陀螺敏感轴交叉耦合情况下平台角速度的计算。得到了稳定平台角速度的理论计算公式,在此基础上,得到了理想情况和陀螺敏感轴交叉耦合情况下的测量计算公式。仿真和试验表明,对陀螺敏感轴的交叉耦合进行补偿,可以有效改善视线角速度的测量精度。     

含固定转速驱动电机的挠性卫星自旋稳定性分析

分析一类含驱动电机挠性卫星的自旋稳定性,应用不变集定理证明了系统轨迹收敛于系统平衡点集,并通过构造正定的单调递减的类能量函数来判断各平衡点的稳定性质。获得的结论包括：由于挠性振动阻尼特性,在无外扰力矩作用时,含固定转速驱动电机的挠性卫星存在稳定的自旋;不含驱动电机的挠性卫星,稳定的自旋轴为其最大主惯量轴;驱动电机可改变挠性卫星的自旋轴,给出了稳定的自旋轴与电机转速方向夹角公式,该夹角为锐角;当电机转动角动量幅值远小于系统角动量时,稳定自旋轴接近最大主惯量轴;电机转动角动量幅值越接近系统角动量,稳定自旋轴越接近电机转动方向。文中也给出了稳定自旋轴平行电机转轴的条件。     

一种新型机载对地观测用三轴稳定平台陀螺安装方式

陀螺安装方式及相应的算法编排是稳定平台设计中的一项关键技术。针对机载对地观测用三轴稳定平台特点,提出了将方位陀螺安装在方位环上,俯仰陀螺和横滚陀螺安装在俯仰环上的陀螺安装方式。利用空间矢量分解理论分析了陀螺输出角速度信号的投影关系及电机控制信号的分配;基于稳定平台系统模型,对理想正交情况和考虑陀螺安装误差情况进行了仿真分析,验证了此种安装方式的可行性和优越性。分析表明,在同等条件下,所提出的安装方式减小了稳定平台的机械尺寸,降低了稳定平台的重量和功耗,实现了三维角速度的正交测量,简化了三轴解耦控制算法。研究结论可为其他三轴稳定平台结构设计和陀螺安装方式设计提供参考。     

Predicting lean blow-off of bluffbody stabilized flames based on Damköhler number

Lean Blow-Off(LBO) prediction is important to propulsion system design. In this paper,a hybrid method combining numerical simulation and Da(Damk?hler) model is proposed based on bluffbody stabilized flames. In the simulated reacting flow, Practical Reaction Zone(PRZ) is built based on OH radical concentration, and it is considered to be the critical zone that controls LBO.Da number is obtained based on the volume-averaged parameters of PRZ. The flow time scale(s_f)indicates the residence time of the fresh mixture flowing through the PRZ. It is obtained based on the characteristic length and volume-averaged axial velocity of the PRZ. The chemical time scale(s_c) indicates the shortest time needed to trigger the reaction of the mixture. It is obtained by commercial software CHEMKIN through monitoring the transient variation of the reactor temperature. The result shows that the average Da number under different LBO conditions is 1.135(the Da number under each LBO condition ranges from 0.673 to 1.351). This indicates that the flow time scale and chemical time scale are comparable. The combustion is in a critical state where LBO is easy to occur. With the increase of the fuel mass flow rate(the global fuel/air ratio increases from 0.004761 to 0.01095), s_f increases from 0.001268 s to 0.007249 s, and s_c decreases from 0.00124 s to0.00089 s. Accordingly, Da number increases from 1.023 to 8.145, which shows that the combustion becomes more stable. The above results show that the method proposed in the present study can properly predict the LBO limits of combustors, which provides important technical supports for combustor design and optimization.     

机载光电跟踪系统模糊控制的优化设计与仿真

 分析了机载光电跟踪系统的构成,并对机载光电跟踪系统的最主要组成部分——陀螺稳定平台框架系统设计了基于遗传算法的模糊控制器,通过遗传算法来优化模糊控制器的规则、参数以及量化因子和比例因子。并对系统进行了详细的仿真研究,仿真结果证明基于 GA的模糊控制器设计获得了良好的控制效果。     

自旋卫星红外地中脉冲丢失情况下姿态确定分析与应用

实际应用中,由于遥测故障或脉冲重叠等多种原因,获取姿态脉冲信息时,可能缺少某些测量脉冲,为姿态确定的方法选择造成一定难度。针对海上测量弧段,某自旋卫星在红外地中脉冲丢失,仅有地出脉冲以及太1、太2脉冲时的几何定姿方法问题,通过对其原理、概念进行分析,制定自旋卫星红外地中脉冲丢失情况下定姿的方案与方法。该方法主要用于海上实时姿态监视,应急情况下也可以用于姿态的粗控。该研究为航天测量船应用测控软件的设计提供了良好基础。