2DCf／SiC-Si复合材料的制备和性能研究

针对短时高温抗氧化的具体环境,采用先驱体转化工艺制备2D Cf/SiC-Si复合材料.首先考察首周期裂解温度对2D Cf/SiC-Si材料力学性能的影响,结果表明,首周期采用1200℃裂解,所制备的2D Cf/SiC-Si复合材料界面结合较好,弯曲强度和断裂韧性分别达到305.4MPa和15.7 MPa·m1/2.在此基础上研究了Si粉含量对材料性能的影响.结果表明,随着Si含量的增加,2D Cf/SiC-Si材料的力学性能稍有降低,而抗氧化性能明显提高,主要原因在于材料中游离碳含量的降低和Si氧化后生成的具有封填裂纹和隔氧作用的SiO2膜.     

一种无塔校准方法研究

在地面卫星测控系统中,目前使用较多的有塔校准技术具有一定的局限性,为了克服这种局限性,本文针对已有的卫星测控系统设备提出一种无塔校准方法,给出了具体无塔校相和无塔校零的实现方法.     

Satellite Constellation Design with Adaptively Continuous Ant System Algorithm

The ant system algorithm （ASA） has proved to be a novel meta-heuristic algorithm to solve many multivariable problems. In this paper, the earth coverage of satellite constellation is analyzed and a n ＋ 1^ -fold coverage rate is put forward to evaluate the coverage performance of a satellite constellation. An optimization model of constellation parameters is established on the basis of the coverage performance. As a newly developed method, ASA can be applied to optimize the constellation parameters. In order to improve the ASA, a rule for adaptive number of ants is proposed, by which the search range is obviously enlarged and the convergence speed increased. Simulation results have shown that the ASA is more quick and efficient than other methodV211.71s.     

带有太阳电池阵的卫星电源系统在轨测试方法

根据带有太阳帆板的地球同步卫星在轨测试需求,分析了星上电源系统的组成及技术状态;并以光照区可调节母线为例。给出了卫星电源系统在轨测试方法及相应的计算公式;最后,通过工程验证了该方法的正确性。     

印度自主研发的火箭低温级完成地面试验

据印度hindu网站2007年8月5日报道，印度本国研发的、将用于印度地球同步卫星运载火箭（GSLV）的低温级，于8月4日在泰米尔纳德的工厂完成了历时8min的地面试验。印度航天研究组织（ISRO）公布的消息称，低温级及其发动机的所有参数均正常。     

欧空局计划研发第二代“伽利略”卫星

据《国际飞行》2007年8月8日消息，在第一代卫星导航系统投入运行4年之前，欧空局（ESA）开始准备研发第二代“伽利略”卫星导航系统。     

基于北斗的车载接收机航向测量技术研究

研究一种BD2双天线的双频基线测量算法,实现了在车载动态条件下利用BD2卫星进行载体航向实时测量,满足军用车辆、无人机、船舶舰艇等载体高精度、快速实时、连续稳定长时间工作、低成本的要求,对算法实现进行了试验验证,取得了理想的成效,具有较强的工程实用价值。     

Attitude control system design and on-orbit performance analysis of nano-satellite––‘‘Tian Tuo 1’’

‘‘Tian Tuo 1'(TT-1) nano-satellite is the first single-board nano-satellite that was successfully launched in China. The main objective of TT-1 is technology demonstration and scientific measurements. The satellite carries out the significant exploration of single-board architecture feasibility validation, and it is tailored to the low-cost philosophy by adopting numerous commercialoff-the-shelf(COTS) components. The satellite is featured with three-axis stabilization control capability. A pitch bias momentum wheel and three magnetic coils are adopted as control actuators.The sun sensors, magnetometers and a three-axis gyro are employed as the measurement sensors.The quaternion estimator(QUEST) and unscented Kalman filter(UKF) method are adopted for the nano-satellite attitude determination. On-orbit data received by ground station is conducted to analysis the performance of attitude determination and control system(ADCS). The results show that the design of ADCS for TT-1 is suitable, robust and feasible.     

计算机网络的现状与发展趋势

Internet和Internet 2的最新发展值得关注。接入网技术可能代表未来通讯技术发展的潮流。多媒体信息传输是拓展金航网络应用的一种重要手段。     

数字域谱估计的GNSS系统信号带宽测试方法

针对传统的单载波扫频法不适于GNSS（全球导航卫星系统）信号生成通道的带宽测量的问题,提出了采用数字信号处理的信号带宽方法.对实际导航信号进行高速采样,在数字域对采样的导航信号和本地数字生成的理想导航信号进行频谱估计和计算,从而得到GNSS信号带宽.分别使用周期图法和Welch法谱估计,对提出的测试方法进行仿真.仿真结果表明,采用Welch法进行理想信号和实际信号谱估计,对谱估计后的结果进行计算,可以完成GNSS信号带宽精密测量,在Welch法估计参数设置合理的情况下,GNSS信号带宽估计的准确度可以达到99.9％以上.