含间隙运动控制系统中的定位抖动和 速率波动原因分析及解决措施

针对一类含间隙大惯量非直驱转动系统中出现的速率波动现象,利用描述函数法和计算仿真的方法进行了原因分析.在通常的解决措施如双电机消隙、机械消隙方法之外,针对一类间隙可测量的运动控制系统,提出了解决该类问题的新思路,即通过间隙的间接测量,利用反馈机制进行间隙补偿,并用小增益定理证明了其稳定性.实现了部分电气消隙的作用,在适当降低跟踪精度的情况下,消除了定位抖动,提高了速率平稳性.     

一种线运动扰动环境下基于惯性凝固系抗干扰自对准优化算法研究

传统惯性凝固性对准技术可有效隔离角运动干扰环境对捷联惯导自对准精度的影响,但对线运动环境下的抗干扰能力不足.据此,在深入分析线运动干扰对捷联惯导惯性凝固系下自对准精度影响途径之上,对线运动干扰环境划分为速度周期波动、突跳以及速度短期线性漂移.提出采用积分降噪、载体惯性系速度递推拟合与基于带遗忘因子递推最小二乘的速度慢漂提取技术相结合的抗干扰自对准优化算法,并进行了试验验证.试验结果表明,本算法可在5min内实现1.3mil的抗干扰自对准精度.     

利用机载GNSS-R的有效波高反演技术

采用自主研发的多源多宿GNSS-R(Global Navigation Satellite System-Reflections,全球导航卫星系统反射信号)海洋环境遥感探测系统,在天津渤海湾特定区域进行了3次机载校飞试验,获得了大量有效GNSS-R信号数据,对自然条件下的海面有效波高进行了反演处理。该系统通过对接收的GNSS直达信号和海面反射信号进行相关运算处理,可以获得DDM(Delay-Doppler Mapping,时延—多普勒映射)图谱,再利用DCF(Derivative of the Correlation Function,相关函数的导数)在DDM图谱基础上进行相关功率波形的计算,进而通过计算DCF的函数波形宽度得到海面有效波高,验证了该方法的可行性。该方法具有全天时、全天候、高分辨率、低成本等优点,对全球范围内中小尺度海洋状态和物理现象的监测具有重要意义。     

In-orbit assessment of laser retro-reflector efficiency onboard high orbiting satellites

The navigation and geodetic satellites that orbit the Earth at altitudes of approximately 20,000 km are tracked routinely by many of the Satellite Laser Ranging (SLR) stations of the International Laser Ranging Service (ILRS). In order to meet increasing demands on SLR stations for daytime and nighttime observations, any new mission needs to ensure a strong return signal so that the target is easily acquirable. The ILRS has therefore set a minimum effective cross-section of 100 million square metres for the on-board laser retro-reflector arrays (LRAs) and further recommends the use of ‘uncoated’ cubes in the arrays. Given the large number of GNSS satellites that are currently supported by SLR, it is informative to make an assessment of the relative efficiencies of the various LRAs employed. This paper uses the laser ranging observations themselves to deduce and then compare the efficiencies of the LRAs on the COMPASS-M1 navigation satellite, two satellites from the GPS and three from the GLONASS constellations, the two GIOVE test satellites from the upcoming Galileo constellation, the two Etalon geodetic spheres and the geosynchronous communications test satellite, ETS-8. All the LRAs on this set of satellites employ back-coated retro-reflector cubes, except those on the COMPASS-M1 and ETS-8 vehicles which are uncoated. A measure of return signal strength, and thus of LRA-efficiency, is calculated using the laser-range full-rate data archive from 2007 to 2010, scaled to remove the effects of variations in satellite range, atmospheric attenuation and retro-reflector target total surface area. Observations from five SLR stations are used in this study; they are Herstmonceux (UK), Yarragadee (Australia), Monument Peak and McDonald (USA) and Wettzell (Germany). Careful consideration is given to the treatment of the observations from each station in order to take account of local working practices and system upgrades. The results show that the uncoated retro-reflector cubes offer significant improvements in efficiency.     

Protecting Earth-orbiting spacecraft against micro-meteoroid/orbital debris impact damage using composite structural systems and materials: An overview

Spacecraft that are launched to operate in Earth orbit are susceptible to impacts by meteoroids and pieces of orbital debris (MMOD). The effect of a MMOD particle impact on a spacecraft depends on where the impact occurs, the size, composition, and speed of the impacting object, the function of the impacted system. In order to perform a risk analysis for a particular spacecraft under a specific mission profile, it is important to know whether or not the impacting particle (or its remnants) will exit the rear of an impacted spacecraft wall. A variety of different ballistic limit equations (BLEs) have been developed for many different types of structural wall configurations. BLEs can be used to optimize the design of spacecraft wall parameters so that the resulting configuration is able to withstand the anticipated variety of on-orbit high-speed impact scenarios. While the level of effort exerted in studying the response of metallic multi-wall systems to high speed particle impact is quite substantial, the extent of the effort to study composite material and composite structural systems under similar impact conditions has been much more limited. This paper presents an overview of the activities performed to assess the resiliency of composite structures and materials under high speed projectile impact. The activities reviewed will be those that have been aimed at increasing the level of protection afforded to spacecraft operating in the MMOD environment, and more specifically, on those activities performed to mitigate the mechanical and structural effects of an MMOD impact.     

Determination of station positions and velocities from laser ranging observations to Ajisai,Starlette and Stella satellites

The positions and velocities of the four Satellite Laser Ranging (SLR) stations: Yarragadee (7090), Greenbelt (7105), Graz (7839) and Herstmonceux (7840) from 5-year (2001–2005) SLR data of low orbiting satellites (LEO): Ajisai, Starlette and Stella were determined. The orbits of these satellites were computed from the data provided by 20 SLR stations. All orbital computations were performed by means of NASA Goddard’s GEODYN-II program. The geocentric coordinates were transformed to the topocentric North–South, East–West and Vertical components in reference to ITRF2005. The influence of the number of normal points per orbital arc and the empirical acceleration coefficients on the quality of station coordinates was studied. To get standard deviation of the coordinates determination lower than 1 cm, the number of the normal points per site had to be greater than 50. The computed positions and velocities were compared to those derived from LAGEOS-1/LAGEOS-2 data. Three parameters were used for this comparison: station coordinates stability, differences from ITRF2005 positions and velocities. The stability of coordinates of LEO satellites is significantly worse (17.8 mm) than those of LAGEOS (7.6 mm), the better results are for Ajisai (15.4 mm) than for Starlette/Stella (20.4 mm). The difference in positions between the computed values and ITRF2005 were little bit worse for Starlette/Stella (6.6 mm) than for LAGEOS (4.6 mm), the results for Ajisai were five times worse (29.7 mm) probably due to center of mass correction of this satellite. The station velocities with some exceptions were on the same level (≈1 mm/year) for all satellites. The results presented in this work show that results from Starlette/Stella are better than those from Ajisai for station coordinates determination. We can applied the data from LEO satellites, especially Starlette and Stella for determination of the SLR station coordinates but with two times lower accuracy than when using LAGEOS data.     

Satellite and ground detection of very dense smoke clouds produced on the islands of the Paraná river delta that affected a large region in Central Argentina

Intense fires were produced on the Paraná river delta islands, Argentina, during most part of 2008, by a combination of an exceptionally dry period and the farmers’ use of a fire land-cleaning technique. In April 2008, those fires significantly affected the nearby regions and their inhabitants, from Rosario city to Buenos Aires mega-city. In this work we present satellite as well as ground Aerosol Optical Depth (AOD) at 550 nm data obtained during the propagation of pollution clouds to the central zone of Argentina. The highest value (1.18) was registered at Buenos Aires by atmospheric remote sensing, using the satellite instrument MODIS/Terra on April 18th 2008 at 10:35 local time (= UT − 3 h). On the same day, ground air quality detectors also measured in this city the highest Total Suspended Particle (TSP) value of the month, 2.02 mg/m³. The AOD(550) daily variation at Rosario Astronomical Observatory, which is located near the Paraná riverside, was derived by combining solar ultraviolet erythemal irradiance data (measured with a YES biometre) with model calculations. On April 25th 2008, from 12:00 to 15:30 local time, a rather high and constant AOD(550) value was registered, with a mean value of (0.90 ± 0.21). Cities located on the side of the Rosario–Buenos Aires highway (San Nicolás, Baradero and San Pedro) were also affected, showing a mean AOD(550) between the Rosario and Buenos Aires values. The particulate matter was collected with gridded samplers placed on the Paraná river islands as well as at the Rosario Observatory. They were analysed with a Scanning Electron Microscope (SEM) and mainly showed a biological origin. Even if normally large particles travel small distances from the source, organic aerosol in the range of 40–100 μm and complex asymmetric structures were registered several kilometres away from the aerosol sources on the islands. Another event of intense UV index attenuation (98.6%) occurred on September 18th 2008, due to very dense smoke clouds that extended over the Rosario area for several hours. The clouds were driven away from the fires by East–northeast and East–southeast winds. The minimum value of this index measured around noon allows to derive a maximum AOD(550)_max = (3.65 ± 0.90) at 12:45 local time. Soot clouds extended over the Paraná river, transporting Burned Biomass Debris (BBD) that deposited on Rosario. In particular, burned leaves and small branches with dimensions of 1–20 cm were collected. The mean (BBD) particles deposited on the ground from 7:00 to 19:00 local time were (0.92 ± 0.20) BBD/(m² h).     

低轨卫星通信系统地面核心网设计与仿真

文章针对无星际链路的低轨卫星通信系统，利用OPNET软件设计了低轨卫星通信系统在透明转发模式下的核心网构成，并进行了性能仿真。首先介绍核心网的构成、功能和拓扑，在此基础上实现了呼叫处理和切换的仿真，统计了呼叫时延、切换时延等性能指标，分析了仿真结果，为低轨道卫星通信系统的设计奠定了一定的参考价值。     

球形粒子在流体中的跟随性

本文从Maxey和Riley的粒子运动基本方程出发,得到了球形固体粒子在相对流动雷诺数很小情形下的分析解。讨论了粒子跟随性对外力、初始条件和流场性质的依赖关系;对均匀湍流场,分析了不同密度比和扰动频率对跟随性的影响     

Vertical motions in Thailand after the 2004 Sumatra–Andaman Earthquake from GPS observations and its geophysical modelling

Following previous findings from ongoing GPS research in Thailand since 2004 we continue to exploit the GPS technique to monitor and model land motions induced by the Sumatra–Andaman Earthquake. Our latest results show that up to the end of 2010, Thailand has been co-seismically displaced and is subsequently undergoing a post-seismic horizontal deformation with total displacements (co-seismic plus post-seismic) ranging from 10.5 to 74.7 cm. We observed the largest horizontal displacements in the southern part of Thailand and moderate and small displacements in the central and northern parts. In addition to horizontal displacements throughout Thailand, continuous GPS measurements show that large parts of Thailand are subsiding at rates up to 1 cm/yr. It is the first time that such vertical post-seismic deformations at large distances (650–1500 km away from the Earthquake’s epicentre) have been recorded. We have investigated the physical processes leading to the observed subsidence. While after-slip on the subduction interface induces negligible or even slightly positive vertical motions, relaxation in the asthenosphere is associated with a sizable subsidence. Predictions from a 3D finite element model feature an asthenosphere with an effective viscosity of the order of 3 * 10¹⁸ Pas, fit the horizontal post-seismic data and the observed subsidence well. This model is then used to predict the subsidence over the whole seismic cycle. The subsidence should go on with a diminishing rate through the next two decades and its final magnitude should not exceed 10 cm in the Bangkok area.