DDLL中存在的包络现象及其解决方法

数字延迟锁定环路 (DDLL)中存在的包络现象是导致低动态环境下 GPS伪距测量精度难以提高的重要原因。文中从实验中发现这种现象 ,通过大量仿真复现了这一现象并找到产生这一现象的原因 ,最后从理论上进行分析并给出解决问题的方法。     

CCSDS建议的再生伪码测距性能分析

CCSDS(国际空间数据系统咨询委员会)于2009年3月发布了伪码测距的蓝皮书,规定了再生伪码测距的技术要求。我国正在研制的深空应答机和深空站测控设备要求具备再生伪码测距功能,同时为了实现国际联网,伪码测距系统需满足CCSDS建议的要求。为给我国深空测控设备伪码测距系统的研制提供设计依据,通过分析伪码特性和伪码捕获跟踪方法,推导得到伪码测距的捕获性能和跟踪性能。分析得到的性能与CCSDS建议书一致,可作为我国深空应答机和深空站测控设备伪码测距系统设计的参考。     

GPS不完整星座定位方法研究

为了提高钟差预测模型辅助接收机定位解算的效果,从灰色系统的角度对接收机钟差序列进行探讨,提出了基于灰色理论的钟差预测模型。文中首先给出了新模型的基本思想和具体实现步骤,然后将基于该模型的钟差预测值引入到GPS接收机中,辅助接收机在不完整星座条件下实现定位解算。基于GPS实测数据的验证分析表明,新模型不仅对钟差序列具有很好的预测效果;而且提高了接收机定位的连续性和可靠性,在仅有3颗卫星的条件下可以实现三维定位。同时,新方法无需增加额外设备,辅助方式简单方便,经济灵活。     

弧齿锥齿轮啮合迹方向角的主动设计方法

为了实现弧齿锥齿轮设计规定的啮合迹方向,以局部综合法为基础,结合轮齿接触分析技术和无约束优化方法,进行弧齿锥齿轮啮合迹方向角的主动设计,给出了1种实现齿面参考点处啮合迹目标方向角的设计方法。通过1对弧齿锥齿轮的实例演示,论证了该方法对弧齿锥齿轮啮合迹方向角进行主动设计的可行性。结果表明:局部综合法中的输入啮合迹方向角必须小于旋转轴平面中规定的角度;在调整啮合迹方向角的过程中,传动误差曲线没有发生畸变。     

典型CMOS存储器电离辐照效应

对电离辐照环境中典型CMOS存储器的辐照效应进行了研究。分析了SRAM,EEPROM,FLASH ROM存储器在^60Coγ射线辐照及辐照后不同退火过程中,CMOS存储器的集成度、辐照偏置、退火时间和温度与电离辐照效应的关系。结果发现：不加电（冷备份）状态的^60Coγ射线辐照过程中,存储器的逻辑状态翻转出现较正常工作状态推迟1个量级以上;随着集成度的提高,SRAM,EEPROM存储器的辐照敏感度降低;试验器件经不同剂量的^60Coγ射线辐照后在不同温度下退火,所有试验器件均出现了逻辑状态翻转。     

In-orbit assessment of laser retro-reflector efficiency onboard high orbiting satellites

The navigation and geodetic satellites that orbit the Earth at altitudes of approximately 20,000 km are tracked routinely by many of the Satellite Laser Ranging (SLR) stations of the International Laser Ranging Service (ILRS). In order to meet increasing demands on SLR stations for daytime and nighttime observations, any new mission needs to ensure a strong return signal so that the target is easily acquirable. The ILRS has therefore set a minimum effective cross-section of 100 million square metres for the on-board laser retro-reflector arrays (LRAs) and further recommends the use of ‘uncoated’ cubes in the arrays. Given the large number of GNSS satellites that are currently supported by SLR, it is informative to make an assessment of the relative efficiencies of the various LRAs employed. This paper uses the laser ranging observations themselves to deduce and then compare the efficiencies of the LRAs on the COMPASS-M1 navigation satellite, two satellites from the GPS and three from the GLONASS constellations, the two GIOVE test satellites from the upcoming Galileo constellation, the two Etalon geodetic spheres and the geosynchronous communications test satellite, ETS-8. All the LRAs on this set of satellites employ back-coated retro-reflector cubes, except those on the COMPASS-M1 and ETS-8 vehicles which are uncoated. A measure of return signal strength, and thus of LRA-efficiency, is calculated using the laser-range full-rate data archive from 2007 to 2010, scaled to remove the effects of variations in satellite range, atmospheric attenuation and retro-reflector target total surface area. Observations from five SLR stations are used in this study; they are Herstmonceux (UK), Yarragadee (Australia), Monument Peak and McDonald (USA) and Wettzell (Germany). Careful consideration is given to the treatment of the observations from each station in order to take account of local working practices and system upgrades. The results show that the uncoated retro-reflector cubes offer significant improvements in efficiency.     

Determination of station positions and velocities from laser ranging observations to Ajisai,Starlette and Stella satellites

The positions and velocities of the four Satellite Laser Ranging (SLR) stations: Yarragadee (7090), Greenbelt (7105), Graz (7839) and Herstmonceux (7840) from 5-year (2001–2005) SLR data of low orbiting satellites (LEO): Ajisai, Starlette and Stella were determined. The orbits of these satellites were computed from the data provided by 20 SLR stations. All orbital computations were performed by means of NASA Goddard’s GEODYN-II program. The geocentric coordinates were transformed to the topocentric North–South, East–West and Vertical components in reference to ITRF2005. The influence of the number of normal points per orbital arc and the empirical acceleration coefficients on the quality of station coordinates was studied. To get standard deviation of the coordinates determination lower than 1 cm, the number of the normal points per site had to be greater than 50. The computed positions and velocities were compared to those derived from LAGEOS-1/LAGEOS-2 data. Three parameters were used for this comparison: station coordinates stability, differences from ITRF2005 positions and velocities. The stability of coordinates of LEO satellites is significantly worse (17.8 mm) than those of LAGEOS (7.6 mm), the better results are for Ajisai (15.4 mm) than for Starlette/Stella (20.4 mm). The difference in positions between the computed values and ITRF2005 were little bit worse for Starlette/Stella (6.6 mm) than for LAGEOS (4.6 mm), the results for Ajisai were five times worse (29.7 mm) probably due to center of mass correction of this satellite. The station velocities with some exceptions were on the same level (≈1 mm/year) for all satellites. The results presented in this work show that results from Starlette/Stella are better than those from Ajisai for station coordinates determination. We can applied the data from LEO satellites, especially Starlette and Stella for determination of the SLR station coordinates but with two times lower accuracy than when using LAGEOS data.     

脉冲激光测距误差标定及不确定度分析CSCD

以脉冲激光测距机的测距误差标定为背景,通过对测距误差解析表达式的推导,给出了系统各不确定度分量对测距误差的影响,计算了信号延迟时间、探测器和激光二极管响应时间、晶振频率、大气折射率等不确定度分量。通过对某已标定激光测距机实验验证表明:该装置在500m^20 000m测距范围内,测量重复性引入的相对标准不确定度最大值为0.67m,满足该类激光测距机测量不确定度5m(k=2)的校准测试需求。因此,利用该解析表达式可以实现对脉冲激光测距误差的有效评估,这对于脉冲激光测距测试系统、脉冲激光测距机的设计具有重要的指导意义。     

An Investigation into Vertical Bias Effects

ABSTRACT

In three experiments, after exploring a virtual environment (VE), adult participants made spatial judgments about the location of target objects that were higher and lower than their perceived test location within the VE. In Experiment 1, the locations of the target objects were inferred from verbal instructions. The main results were a tendency to judge objects as closer to the horizontal plane than their true locations, and more efficient downward than upward judgments. Both effects generally accord with findings reported by Wilson et al. (2004a Wilson, P. N., Foreman, N., Stanton, D. and Duffy, H. 2004a. Memory for targets in a multilevel simulated environment: Evidence for vertical asymmetry in spatial memory. Memory & Cognition, 32: 283–297. [Crossref] , [Google Scholar], 2004b Wilson, P. N., Foreman, N., Stanton, D. and Duffy, H. 2004b. Memory for targets in a multi-level simulated-environment: A comparison between able-bodied and physically disabled children. British Journal of Psychology, 95: 325–338.  [Google Scholar]). In Experiments 2 and 3, which were closely modeled on the design of the Wilson et al. studies, regression to the horizontal plane was noted but no downward bias was observed. A misperception in the viewing height between the floors and ceilings of the virtual rooms was apparent in both experiments. The results from the present study together with earlier investigations suggest different hierarchical encoding of between-axis and within-axis information.     

基于一致关联数最大化的航迹关联算法

航迹关联(TTTA)是多传感器数据融合系统的核心模块之一,是系统误差估计和航迹融合的前提和基础。传感器存在的固有系统误差使得目标位置状态估计与真值发生偏离,容易诱发TTTA错误。传统的基于全局最小距离准则的TTTA算法,需要获得较高精度的系统误差估计,来对航迹数据进行误差补偿。针对传感器具有系统误差环境下的TTTA问题,在对TTTA进行间接评估的基础上,定义了一致关联数的概念,提出了一致关联数最大化的TTTA准则,并在稳健交替迭代的框架下完成算法设计。与距离函数不同,一致关联数是一个离散量,放松了对系统误差估计精度的要求。最后,仿真实验验证了所提算法的有效性。