嫦娥五号轻量化高精度上升器结构设计

针对嫦娥五号上升器结构面临的轻量化设计要求严苛、有效载荷接口精度要求极高和有效载荷指向变化预示精度要求很高的难题,提出至顶向下的结构轻量化设计方法,使得上升器结构自重降低到整器重量的6.2%(47.758 kg);建立压紧和精度保持功能分离、双坐标系分级实现高精度的结构设计方法,实现相关有效载荷的结构安装接口精度达到400 mm×400 mm区域平面度小于或者等于0.05 mm;探索出综合了有效载荷自身和安装结构耦合效应的有效载荷在轨指向变化预示方法,实现准确、高效、快速地对有效载荷指向变化进行角秒级高精度评估。这些方法支持完成中国月面无人自动采样返回任务,并最终促进中国航天器结构技术的发展。     

嫦娥五号探测器自主着陆视觉避障方法与评价

对嫦娥五号探测器的视觉自主避障系统组成、方案及原理进行介绍。采用光学粗避障加激光精避障的两级接力避障模式,在光学粗避障阶段利用K均值聚类对图像障碍进行分割,对分割结果采用Delaunay三角剖分,并设计安全系数评价方法选择安全落点;在激光精避障阶段提出概率模型评价点云所示区域的着陆安全性。对两级避障的在轨图像利用上述方法进行仿真分析,并对着陆区域的安全性进行评价。结果显示两级避障均合理有效。     

Ariane 5 GTO debris mitigation using natural perturbations

GTO objects can potentially collide with operative satellites in LEO and GEO protected regions. Internationally accepted debris mitigation guidelines require that these objects exit these protected regions within 25?years, e.g. by re-entering and burning up in Earth’s atmosphere. In this paper, an inventory of the GTO debris generated from Ariane 5 launches in the period 2012–2017 is provided, and it is expected that none of these objects will re-enter within 25?years. For future launches, natural perturbations can be exploited to increase compliance with mitigation guidelines without the use of extra propellant or complex de-orbiting systems, which is attractive from an economic point of view. The lifetime of GTO objects is very sensitive to initial conditions and some environmental and body-related parameters, mainly due to the effect of solar gravity on the perigee altitude. As a consequence, the lifetime of a specific GTO object cannot be predicted accurately, but its probability of re-entering in less than 25?years can be estimated with proper accuracy by following a statistical approach. By propagating the orbits of over 800,000 simulated Ariane 5 GTO objects, it was found that the launch time leading to the highest probability of compliance with debris mitigation guidelines for GEO launches from Kourou corresponds to about 2 PM local time, regardless of the date of launch, which leads to compliance rates ranging from 60 to 100%. Current practice is to launch at around 5–9?PM, so a change in procedures would be required in order to reach a higher degree of compliance with debris mitigation guidelines, which was predicted to be on average below 20% for the objects generated in the period 2012–2017.     

Mesosphere/lower thermosphere wind regime parameters using a newly installed SKiYMET meteor radar at Kazan (56°N, 49°E)

New meteor radar (MR) horizontal wind data obtained during 2015–2018 at Kazan (56°N, 49°E) are presented. The measurements were carried out with a state-of-the-art SKiYMET meteor radar. Monthly mean vertical profiles of zonal and meridional components of the prevailing wind speeds, also amplitudes and phases of the components of diurnal (DT) and semidiurnal tide (SDT) winds are displayed as contour plots for a mean calendar year over the four recent years and compared with distributions of these parameters provided by the previous multiyear (1986–2002) meteor radar (MR) measurements at Kazan and by the recent HWM07 empirical model. The analysis shows that the SKiYMET zonal and meridional prevailing wind speeds are generally in good agreement, sharing the same seasonal features, with the earlier MR seasonal winds. Comparisons with the HWM07 model are not favourable: eastward solstitial cells as modelled are significantly larger, >30?m/s compared to 15–20?m/s. Also, reversal lines are too variable with height, and the positions of modelled cells (positive and negative) are unlike those of either MRs at Kazan or other MLT radars. Both MR systems provide the large SDT amplitudes, approximately 30?m/s and vertical wavelengths, approximately 55?km, for both components at middle latitudes in winter. They also show the well known strong SDT September feature (heights 85–100?km, the vertical wavelength ～55–60?km), and the weak summer SDT for 80–91?km. HWM07 shows unrealistic amplitudes and phases above 90?km by height and month: minimal amplitudes in equinoxes and no September feature.The weak DT of middle to high latitudes provide similar amplitude and phase structures from both MRs, 1986–2002 and 2015–2017: largest amplitudes (10–12 or 8–10?m/s) for the evanescent meridional tide in summer, peaking in late July; weakest (0–2, 2–4?m/s) at 80 to 92–96?km, when the tide is vertically propagating (January, February, November, December) with a vertical wavelength near 40?km. Again, HWM07 differs in amplitude and phase structures: showing peak amplitudes in equinoxes: April, 15?m/s at 88?km; October, 21?m/s at 89?km.Coupling of the MR wind parameters with the ERA5 wind parameters is studied for a case in 2016. It is shown that the prevailing winds and DT amplitudes and phases of both datasets can be simply linked together, but that the ERA5 SDT amplitudes are significantly underestimated at the top model levels of the ERA5 reanalysis project.     

Orbital corrections by a single-input impulsive control applied along the geomagnetic field

This paper examines the possibility of regular orbital corrections for a satellite controlled by an impulsive force applied along the induction vector of the local geomagnetic field. The main purpose of the correcting considered in the paper is to eliminate the drift in secular variation of the relative orbital parameters over the orbital period. The obtained results are applied to the formation flying problem. The developed method is tested using numerical simulation.     

3,4-双(3',5'-二硝基苯-1'-基)氧化呋咱的热 行为和非等温热分解动力学研究

为了评价含能材料3,4-双(3',5 '-二硝基苯-l'-基)氧化呋咱(BDPF)的热稳定性和安全性,采用DSC、PDSC和'G/DTG方法对其进行了热行为及非等温热分解动力学研究.通过Kissinger和Ozawa's法得到常压下热分解反应的动力学参数(Ea和A)为180.46 kJ·mol-1和1015.29 s-...     

3,6-双(1-氢-1,2,3,4-四唑-5-氨基)-1,2,4,5-四嗪-1,4-丁二胺盐的制备和热分解动力学及热安全性

利用3,6-双(1-氢-1,2,3,4-四唑-5-氨基)-1,2,4,5-四嗪(BTATz)和1,4-丁二胺,在DMSO中合成出了标题化合物。采用元素分析和红外光谱分析,测定了其结构。用DSC和TG/DTG热分析仪,对标题化合物进行了热分解行为及热分解动力学研究。结果表明,化合物的热分解过程只有一个放热阶段,该阶段的非等温热分解反应动力学方程的活化能和指前因子分别为92.95 kJ/mol和1016.58s-1。采用MicroDSCⅢ量热仪中的连续比定压热容测定模式,测定了化合物的比定压热容,比定压热容随温度呈现二次方关系,且298.15 K下的标准摩尔热容为443.22 J/(mol.K)。计算得到化合物的自加速分解温度(TSADT)、热爆炸临界温度(Tb)和绝热至爆时间分别为521.55、536.73 K和36.97 s。     

四唑类盐的制备及其在固体推进剂中的应用初探

合成了5-苯基四唑、5-亚甲基二四唑，并通过元素分析及质谱方法对其进行了分析鉴定，制备了其铜、铅、锶盐；对3种金属盐在改性双基推进剂配方中的应用进行了探索性研究。初步研究表明，四唑类的金属盐类可以作为复合改性双基推进剂(CMDB)的含能燃烧催化剂。     

三维五向碳/酚醛编织复合材料的拉伸性能及破坏机理

 对不同编织角、不同体积含量的三维五向碳/酚醛编织复合材料进行了纵向（编织方向）拉伸实验和横向拉伸的对比实验,获得了这些编织复合材料的主要拉伸力学性能。实验后对拉伸试件的断口进行了照相和扫描电镜观察,分析了材料的变形及其破坏机理。实验结果表明: 编织角仍是影响三维五向编织复合材料拉伸力学性能的主要因素,并且复合工艺的质量对复合材料的力学性能有重要影响。此外,发现三维五向碳/酚醛编织复合材料的横向拉伸与纵向拉伸具有完全不同的破坏机制。