Aerodynamics of smart flap under ground effect

Aerodynamic characteristics of two-dimensional smart flap under the ground effect have been assessed by a numerical simulation. In this process, a pressure-based implicit procedure to solve Navier–Stokes equations on a nonorthogonal mesh with collocated finite volume formulation is used. The boundedness criteria for this procedure are determined from the Normalized Variable Diagram (NVD) scheme. The procedure incorporates the k–ε eddy–viscosity turbulence model. Cantilever beam with uniformly varying load with roller support at the free end is considered for the configuration of the smart flap. The method is first validated against experimental data. Then, the algorithm is applied for turbulent aerodynamic flows around airfoil with smart and conventional flaps for different attack angle, flap angle and ground clearance where the results of two flaps are compared. The comparisons show that the quality of the solution is considerable.     

快速响应侦察的测控通信与地面站布设研究

快速响应侦察是空间快速响应技术的一个重要应用,而合理布设地面站以保障侦察卫星的发射测控和快速数据回收是侦察任务顺利完成的基础。通过分析近地快速覆盖轨道和近地重复覆盖轨道的对地覆盖特性,针对发射测控和快速数据回收提出了地面站的布设原则,结合我国领土特点给出了这2类轨道的地面站布设方案,并求解了该方案所能提供的发射测控弧段长度和侦察数据返回时间。分析表明,在我国境内布设地面站以保障快速响应侦察卫星的发射测控和快速数据回收是可行的,其数据返回时间小于1个轨道周期。     

Solar Irradiance Variability Since 1978

Since November 1978 a set of total solar irradiance (TSI) measurements from space is available, yielding a time series of more than 25 years. Presently, there are three TSI composites available, called PMOD, ACRIM and IRMB, which are all constructed from the same original data, but use different procedures to correct for sensitivity changes. The PMOD composite is the only one which also corrects the early HF data for degradation. The results from the detailed analysis of the VIRGO radiometry allow a good understanding of the effects influencing the long-term behaviour of classical radiometers in space. Thus, a re-analysis of the behaviour of HF/NIMBUS-7 and ACRIM-I/SMM was indicated. For the former the situation is complicated by the fact that there are no in-flight means to determine changes due to exposure to solar radiation by comparison with a less exposed radiometer on the same spacecraft. The geometry and optical property of the cavity of HF is, however, very similar to the PMO6-type radiometers, so the behaviour of the PMO6V radiometers on VIRGO can be used as a model. ACRIM-I had to be revised mainly due to a henceforth undetected early increase and a more detailed analysis of its degradation. The results are not only important for solar radiometry from space, but they also provide a more reliable TSI during cycle 21. The differences between the revised PMOD composite and the ACRIM and IRMB are discussed by comparison with a TSI reconstruction from Kitt-Peak magnetograms. As the PMOD composite is the only one which has reliable data for cycle 21, the behaviour of the three solar cycles can now be compared and the similarities and differences discussed.     

超黄蜂直升机换装国产桨叶的动力学分析

本文介绍了超黄蜂直升机换装国产桨叶的动力学分析,给出了超黄蜂直升机装原型机桨叶和换装国产直8A 型机桨叶的飞行振动水平的实测结果,对超黄蜂直升机换装国产桨叶前、后的振动水平进行了对比分析;对照 ADS-27的要求,计算了振动影响指数、1次/转的振动水平和仪表板的振动水平,并进行了超黄蜂直升机换装国产桨叶前、后振动水平的 ADS-27符合性对比分析;本文还介绍了超黄蜂直升机装原型机桨叶和换装国产直8A 型机桨叶的“地面共振”计算结果,进行了“地面共振”对比分析。通过振动水平对比测量、分析和“地面共振”对比计算分析,对超黄蜂直升机换装国产直8A 型机主、尾桨叶的方案是否可行,得出了明确的动力学分析结论,为保证超黄蜂直升机换装国产桨叶的飞行安全提供了依据。     

液体火箭发动机地面试车故障检测的自适应阈值算法

提出一种自适应阈值故障检测算法,其检测阈值由实时估计的参数均值、标准差及由训练算法得到的带宽系数计算。用某发动机22次点火试验的试车数据进行离线故障检测,结果表明其综合性能优于红线系统和SAFD算法。     

尖脊(Caret)进气道地面气动特性试验研究

在地面静止状态下试验研究了尖脊进气道气动特性以及唇口厚度对进气道性能影响 ,给出了进气道各侧壁沿程静压分布及其出口总压分布图谱 ,研究了进气口流动特点及其对出口总压畸变流场的影响。试验表明 ,Caret进气道进口存在一大一小的反向旋转涡 ,该旋涡的作用使得进气道高、低压区均旋转了 90°以上。进口下唇口和外唇口厚度对地面静止状态下的进气道总压恢复系数和总压畸变指数有较大的影响 ,为进气唇口厚度的选择提供了依据。     

载荷谱实测机翼地面标定技术浅论

就飞机载荷谱实测机翼地面标定的原理、标定方法及标定数据处理进行了较详尽的阐述。对飞机载荷谱实测的前期工作有较强的指导意义。     

太阳同步卫星双星组网维持策略

某准共面星座由两颗相位差为 180°的太阳同步卫星组成。在对其进行轨道维持时 ,需综合考虑相位差和地面轨迹范围两方面的限制。然而 ,由于这两颗卫星的轨道倾角存在差异 ,使得在轨道维持过程中不能同时满足相位差和地面轨迹的要求。为解决上述问题 ,本文提出了调整地面参考轨迹的方法 ,实践证明有效。     

高超声速飞行器控制面热防护系统地面试验研究

针对高超声速飞行器控制面研发手段中极其重要的地面试验技术,以X-37轨道飞行器为例,介绍了国外的最新研究进展和关键技术解决途径,以及指导地面试验研究的方法,并针对控制面方案在评估和鉴定中必不可少的高温模态试验,进行了综述和分析。     

地面检测设备中数字逻辑电路干扰的分析和抑制

为了提高电子设备的性能,数字逻辑电路的设计必须十分可靠,通常设计数字逻辑电路只研究输入和输出的静态逻辑关系,这样设计出来的电路有时不可避免会产生毛刺,这些毛刺是事先没有估计的,因为设计者缺乏对数字逻辑电路过渡过程的考虑。本文提出了一种实用毛刺判别法,利用转移值表的方法分析一类时序电路,并从几个实例说明转移值法能够事先判别毛刺存在与否,使设计更加完善。本文还分析了开关对逻辑电路产生干扰的原因和抑制方法。并讨论了抑制毛刺的实用方法,指出竞争的可利用性。