涡轮叶栅外换热系数计算

采用求解三维雷诺平均Navier-Stokes(N-S)方程和带转捩模型的二方程Shear stress transport(SST)湍流模型,完成了MARKⅡ,VKI两个高压涡轮导叶叶栅及一个VKI高压涡轮动叶叶栅的外换热系数计算.计算结果与试验数据的对比表明,发展的带转捩模型的数值方法明显地提高了外换热系数的计算精度.      

Aerodynamic performance of a low-Reynolds UAV with leading-edge protuberances inspired by humpback whale flippers

The aerodynamic forces and flowfield on a delta-wing Unmanned Aerial Vehicle (UAV) with specific airfoil are studied here. The leading-edge protuberances inspired from the flippers of the humpback whale is introduced in present work to watch its effect on stall delaying and drag reduction. Two installing factors, which are amplitude and wavelength of the protuberances, are considered to study the interaction of leading-edge variation and de-tached vortex. Three changes in both amplitude and wavelength are investigated herein. Generally, the modified models have larger stall angle of attack than that of the baseline model; the difference exists in the attainable lift coefficient and drag reduction.     

Effect of an end plate on surface pressure distributions of two swept wings

A series of wind tunnel tests was conducted to examine how an end plate affects the pressure distributions of two wings with leading edge(LE) sweep angles of 23° and 40°. All the experiments were carried out at a midchord Reynolds number of 8×10~5, covering an angle of attack(AOA) range from -2° to 14°. Static pressure distribution measurements were acquired over the upper surfaces of the wings along three chordwise rows and one spanwise direction at the wing quarter-chord line. The results of the tests confirm that at a particular AOA, increasing the sweep angle causes a noticeable decrease in the upper-surface suction pressure. Furthermore, as the sweep angle increases, the development of a laminar separation bubble near the LEs of the wings takes place at higher AOAs. On the other hand, spanwise pressure measurements show that increasing the wing sweep angle results in forming a stronger vortex on the quarter-chord line which has lower sensitivity to AOA variation and remains substantially attached to the wing surface for higher AOAs than that can be achieved in the case of a lower sweep angle. In addition, data obtained indicate that installing an end plate further reinforces the spanwise flow over the wing surface, thus affecting the pressure distribution.     

高超声速流动中噪声与湍流度的关系

在不可压缩流动中，湍流度对流动失稳与转捩的影响机制有很多研究成果，已发展了一些依据其大小预测流动转捩的模型应用于工程设计。但在高速可压缩流动中，湍流度很难测量，给该速域的流动转捩预测建模带来困难。近年来的研究表明，高速流场（马赫数≥3）中的噪声是影响流动转捩提前与推迟，甚至决定转捩途径的关键因素。但流场噪声与湍流度对流场的激励机制有没有内在联系，或流场噪声与湍流度理论上是否存在相互关联，迄今仍缺少理论分析结果。由于可压缩流场中噪声的测量相对容易，因此探讨流场噪声与湍流度之间的定量关系具有重要的理论意义和实用价值。讨论了Euler系统中各类双曲波特性，重点分析了流场声波中脉动压力与脉动速度的本质联系，从理论上得到了声压级与声致湍流度的关系。同时，为了对影响湍流度的因素有更全面的认识，导出了非声扰动与非声致湍流度的关系。为建立高速流动转捩预测模型和探讨天地一致性问题，奠定了一定的研究基础。     

Thermal behavior of an isolator with mode transition inducing back-pressure of a dual-mode scramjet

Combustion mode transition is a valuable and challenging research area in dual-mode scramjet engines. The thermal behavior of an isolator with mode transition inducing back-pressure is investigated by direct-connect dual-mode scramjet experiments and theoretical analysis. Combustion experiments are conducted under the incoming airflow conditions of total temperature 1270 K and Mach 2. A small increment of the fuel equivalence ratio is scheduled to trigger mode transition. Correspondingly, the variation of the coolant flow rate is very small. Based on the mea-sured wall pressures, the heat-transfer model can quantify the thermal state variation of the engine with active cooling. Compared with the combustor, mode transition has a greater effect on the iso-lator thermal behavior, and it significantly changes the isolator heat-flux and wall temperature. To further study the isolator thermal behavior from flight Mach 4 to Mach 7, a theoretical analysis is carried out. Around the critical point of combustion mode transition, sudden changes of the isola-tor flowfield and thermal state are discussed.     

端羧基丁腈橡胶改性环氧形状记忆聚合物

以甲基四氢邻苯二甲酸酐(METHPA)为固化剂,利用端羧基丁腈橡胶(CTBN)改性环氧树脂(EP)制备形状记忆聚合物。研究了形状记忆环氧树脂的力学性能、玻璃化转变温度和形状记忆性能。研究表明,形状记忆环氧树脂的韧性得到明显的提高,Tg得到了相应的下降,形状记忆性能良好,形状固定率皆在97%以上,形状回复率约达100%。     

梯形翼高升力构型的数值模拟技术

基于雷诺平均Navier-Stokes(RANS)方程和结构网格技术,采用亚跨超声速平台(TRIP3.0),数值模拟了美国国家航空航天局(NASA)梯形翼构型。研究了控制方程、网格密度、流动转捩和初始条件等不同影响因素对气动特性的影响。风洞试验是2002年在NASA Langley 14ft×22ft亚声速风洞中完成的,试验结果包括了基本气动力和力矩、表面压力系数和边界层速度型分布。计算结果与试验数据的比较表明:求解完全的RANS方程,提高了翼梢涡的模拟精度;网格密度主要影响翼梢涡的强度;转捩模型提高了边界层的模拟精度,进而提高了升力系数、俯仰力矩系数的模拟精度;最大升力系数及失速迎角对初始条件具有依赖性。     

过渡区侧向喷流干扰的并行DSMC数值模拟研究

在高空低密度环境,空间飞行器的控制面效率下降较快,反作用控制系统(RCS)作为改变飞行姿态或轨道的直接力系得到大量应用,为了精确预测高空RCS喷流与稀薄大气的干扰效应,本文建立了直角与表面非结构网格混合结构的DSMC数值算法以及网格自适应算法,保证了碰撞分子是在自适应后的亚网格内选取,提高了计算精度.采用静态随机负载平衡技术构建了并行DSMC代码,计算分析了不同压比条件下的三维平板模型侧向喷流与稀薄大气的干扰流场.计算的复杂流场结构和表面流动特征、分离长度与低密度风洞试验有较好的一致性.在保持来流参数不变的情况下,喷流干扰区的分离长度及喷流透射高度随着喷流压比的增大而增大.随着来流稀薄度的增加,来流对喷流的影响越来越弱,而喷流自身的影响区域却越来越大.     

γ-Re_θ转捩模型的标定研究

介绍了γ-Reθ转捩模型,补充了相应的关联函数。基于平板的试验数据在中国空气动力研究与发展中心(CARDC)的trip软件平台上对该关联函数进行了标定,并研究了关联函数的变化对转捩结果的影响规律。通过修正与SST湍流模型的结合,改进了转捩位置后壁面摩擦阻力系数偏低的状况。     

瞬间射流作用下的混压式进气道起动特性研究

针对冲压发动机转级过程中可能出现的混压式进气道不起动现象,提出了一种新的瞬间射流调节方式,并开展了非定常数值模拟.结果表明,利用储气腔内高压气体的瞬间喷射,可以实现进气道不起动流场的再起动,且气体质量最少需要0.011 kg,射流作用时间最多持续27ms,具有较高的工程应用价值.深入研究发现,射流引起的进气道溢流是实现...