级间热分离条件下带有延伸喷管的固体火箭发动机尾部流场分析

通过数值方法求解二维轴对称N-S方程,对级间热分离条件下带有延伸喷管的固体火箭发动机尾部流场进行了数值分析。分析表明,展开前,受限尾流使延伸锥、发动机后封头及基础喷管外壁处于严重的热环境中;展开过程中,尾流作用在延伸锥上的气动力变化剧烈。计算结果对发动机的热防护设计及展开机构的驱动力设计提供了依据。     

基于非连续算子广义变分不等式强解的存在性

在算子不连续的情况下,利用FKKM定理和Weierstrass定理及标量化方法得到了广义向量变分不等式的强解存在性定理.     

Numerical modeling of inhomogeneous orographic wave influence on planetary waves in the middle atmosphere

Parameterization of dynamical and thermal effects of stationary orographic gravity waves (OGWs) generated by the Earth’s surface topography is incorporated into a numerical model of general circulation of the middle and upper atmosphere. Responses of atmospheric general circulation and characteristics of planetary waves at altitudes from the troposphere up to the thermosphere to the effects of OGWs propagating from the earth surface are studied. Changes in atmospheric circulation and amplitudes of planetary waves due to variations of OGW generation and propagation in different seasons are considered. It is shown that during solstices the main OGW dynamical and heat effects occur in the middle atmosphere of winter hemispheres, where changes in planetary wave amplitudes due to OGWs may reach up to 50%. During equinoxes OGW effects are distributed more homogeneously between northern and southern hemispheres.     

步进电机在真空低温下的驱动特性分析

文章对步进电机的特点、应用情况及误差补偿处理进行了分析,并提出了在真空低温环境下,除了按常规计算外还必须进行超常力矩试验。     

固体发动机喷管延伸锥展开前级间分离的热环境分析

通过FLUENT流场计算软件,采用RNGK k-ε湍流模型,针对带有延伸喷管的多级固体发动机级间热分离的热环境进行了数值分析。研究表明,延伸喷管尾流受到连接筒、前封头、延伸段的阻碍后,其流动特征变化显著,尤其在一级前封头的影响下形成回流,并在喷管内形成激波。计算得到的热环境参数,对发动机的热防护设计具有一定的参考价值。     

Simulating planetary wave propagation to the upper atmosphere during stratospheric warming events at different mountain wave scenarios

Parameterization schemes of atmospheric normal modes (NMs) and orographic gravity waves (OGWs) have been implemented into the mechanistic Middle and Upper Atmosphere Model (MUAM) simulating atmospheric general circulation. Based on the 12-members ensemble of runs with the MUAM, a composite of the stratospheric warming (SW) has been constructed using the UK Met Office data as the lower boundary conditions. The simulation results show that OGW amplitudes increase at altitudes above 30 km in the Northern Hemisphere after the SW event. At altitudes of about 50 km, OGWs have largest amplitudes over North American and European mountain systems before and during the composite SW, and over Himalayas after the SW. Simulations demonstrate substantial (up to 50–70%) variations of amplitudes of stationary planetary waves (PWs) during and after the SW in the mesosphere-lower thermosphere of the Northern Hemisphere. Westward travelling NMs have amplitude maxima not only in the Northern, but also in the Southern Hemisphere, where these modes have waveguides in the middle and upper atmosphere. Simulated variations of PW and NM amplitudes correspond to changes in the mean zonal wind, EP-fluxes and wave refractive index at different phases of the composite SW events. Inclusion of the parameterization of OGW effects leads to decreases in amplitudes (up to 15%) of almost all SPWs before and after the SW event and their increase (up to 40–60%) after the SW in the stratosphere and mesosphere at middle and high northern latitudes. It is suggested that observed changes in NM amplitudes in the Southern Hemisphere during SW could be caused by divergence of increased southward EP-flux. This EP-flux increases due to OGW drag before SW and extends into the Southern Hemisphere.     

空间低温杜瓦瓶凯夫拉支撑结构多约束优化设计

采用新型凯夫拉纤维作为某空间用小型低温杜瓦瓶的支撑材料，在验证其力学性能的基础上，设计了杜瓦瓶的支撑结构，建立了一种新的热力学耦合优化模型，给出支撑结构固有频率、热应力及发射环境下的约束条件，通过一种“离散点加密”新约束优化法计算出了支撑结构满足约束条件范围内的要求的最优设计参数。     

Numerical investigation of flow mechanisms of tandem impeller inside a centrifugal compressor

This study numerically investigated a single stage centrifugal compressor ‘‘Radiver’’ with a wedge diffuser and several tandem-designed impellers to explore the flow phenomena within the tandem impeller and the potential to enhance compressor performance. The results demonstrate that tandem design and clocking fraction (λ_s) significantly affects the compressor performance. The compressor stage with tandem impellers of Series A of boundary layer growth interruption alone are observed to have a widely operating range but efficiency and total pressure ratio penalty compared with that of conventional impeller. The tandem impeller with at least the same impeller efficiency as the conventional design is considered as a critical design criteria so that further modification process based on the flow characteristic of tandem impeller is necessary. In order to restrain the inducer wake and exducer shock losses, parameters modification of blade angle and thickness distributions are necessary and the modified tandem impeller of Series B is obtained. The modified tandem impeller with 25% clocking arrangement shows an 8.45% stall margin increase and maintains the total pressure ratio and efficiency as the conventional design, which proves the potential of tandem impeller to improve compressor stage performance. It is noteworthy that the tandem impellers of Radiver have not shown obviously balanced exit flow field and the fundamental mechanism of stall margin extending of tandem impeller lies on the improved impeller/diffuser matching performance resulting from the incidence angle variation at diffuser inlet.     

对转涡轮基本分析

对于对转涡轮基元级的特性,首先分析不同基元级的负荷特性应以单位叶列平均的负荷能力为准。其次,模拟常规级的经典分析,讨论了对转涡轮基元级的自变变量及定义了不同类型的典型对转涡轮基元级,按此可以很简明地得出它们在不同转速比下的负荷特性。同时,还初步比较了对转级与常规级的基元级效率。由此可见,对转涡轮的单位叶列负荷系数可比常规级有成倍的增长而且有更高的效率。