湿热环境下复合材料孔板压缩性能的研究

采用压缩试验的方法,对含孔机织碳纤维环氧复合材料层板进行了湿热环境下的压缩试验,研究了湿热环境对其压缩性能的影响。分析了复合材料孔板的吸湿特性、压缩强度、破坏模式及动态力学性能。结果表明:机织碳纤维环氧复合材料吸湿率较低,其饱和吸湿率仅为0.88%左右。湿热环境会降低由基体性能主导的压缩强度,130℃下湿态试样的开孔压缩强度保持率约为70%。含孔复合材料层合板的破坏模式均为过孔破坏,破坏均发生在应力集中的区域,并且断裂都是沿着应力集中最大的方向扩展。侧面断口主要为剪切失效,有分层和屈曲的特征。吸湿后复合材料的DMA Tg为125℃,比干态时下降了16℃。     

Energy absorption features of 3-D braided rectangular composite under different strain rates compressive loading

There are huge potential applications of 3-D braided composite in aerospace engineering because of the non-delamination feature of the composite under impact loading. This paper presents the analysis of energy absorption features of 3-D braided composite under compression with different strain rates. The 3-D 4-step rectangular braided composite coupons were tested on a material tester MTS 810.23 and a split Hopkinson pressure bar (SHPB) apparatus to obtain out-of-plane and in-plane compression stress vs. strain curves at quasi-static and high strain rate state. The failure modes and energy absorption features of the 3-D braided composite under different strain rates were analyzed both in time domain and frequency domain. The energy absorbed by the 3-D braided composite increases with the strain rate. From fast Fourier transform (FFT) analysis of compression stress vs. time histories, the power of energy absorption of the 3-D braided composite increases with strain rate and mostly concentrate on the high frequency region. While for quasi-static compression, the power distributes in very narrow frequency region and also is less than that in high strain rates. This feature corresponds to the different damage and energy absorption mechanisms of the 3-D braided composite under quasi-static and high strain rate compression.     

当代金属类阻尼材料及其应用

论述了金属类阻尼材料的减振降噪机理，介绍了具有代表性的各种阻尼材料的物理机械性能，以及它们的应用情况等。     

SOI结构材料红外吸收光谱的研究

用ＳＩＭＯＸ（Ｓｅｐａｒａｔｉｏｎｂｙ　Ｉｍｐｌａｎｔｅｄ　Ｏｘｙｇｅｎ，即氧注入隔离）技术制备ＳＯＩ－ＣＭＯＳ用的ＳＯＩ（Ｓｉｌｉｃｏｎ　ＯｎＩｎｓｕ　ｌａｔｏｒ，即绝缘体上长单晶硅膜）样品；对ＳＯＩ样品红外吸收光谱的分析，从而计算了ＳＯＩ结构材料中ＳｉＯ２埋层的厚度；测试样品不同点的红外吸收光谱，可考察样品ＳｉＯ２埋层厚度的不均匀性，据此，并可分析与之相关的ＳＯＩ样品的质量参数．这种分析方法，是一种无损的检测手段，具有实用价值．     

正电子素的络合作用

本文介绍了正电子素及其络合作用。讨论了正电子素络合反应速度常数的测量方法。比较了几种线性自由能的表达式。     

冲击载荷下受轴向约束的点阵材料夹芯简支梁

对受到均布冲击载荷的轴向不可移点阵材料夹芯简支梁进行了刚塑性动力响应理论分析和弹塑性有限元分析.首先给出了夹芯梁在外包和内接屈服条件下中点最大挠度的理论预测值,并与有限元结果进行了比较,有限元计算结果介于两种屈服条件给出的理论预测结果之间,有限元计算的支座处最大转角与外包屈服条件给出的理论预测结果接近.然后考察了点阵材料夹芯梁的抗冲击性能和吸能效果.结果表明:夹芯梁的最大挠度和塑性耗散能对杆元与面板夹角及相对密度十分敏感,设计合理的夹芯梁具有很好的吸能效果和抗冲击性能.     

影响氢原子钟长期稳定度的系统效应分析

进一步改进氢钟的频率稳定度，需要了解影响频率稳定度的各个过程及其影响的相对大小。讨论影响氢钟频率稳定度的各种系统过程。这种分析能够使钟的研制者和用户去识别稳定度的限制因素并加以选择以便改进。     

Correlation between the cosmic noise absorption calculated from the SARINET data and the energetic particles measured by MEPED: Simultaneous observations over SAMA region

The cosmic noise absorption is presented in terms of two-dimensional images obtained from the imaging riometers operated at the Southern Space Observatory (geographic coordinate: 29.4° S, 53.1° W), in São Martinho da Serra, Brazil, Concepcion (geographic coordinate: 36.5° S, 73.0° W) and Punta Arenas (geographic coordinate: 53.0° S, 70.5° W) in Chile, which belong to the South American Riometer Network and are located at the central and periphery regions of the South American Magnetic Anomaly. Correlations are performed between the maximum cosmic noise absorption observed at these stations and the energetic electron flux in two energy channels (>30 and >300 keV) and the proton flux in three energy channels (80–240, 800–2500 and >6900 keV) as measured by the Medium Energy Proton and Electron Detector, during a moderate geomagnetic storm that occurred on September 3, 2008. The results show high correlations between the cosmic noise absorption detected at São Martinho da Serra and the flux of protons with energy between 80 and 240 keV, and the flux of electrons with energies higher than 300 keV, while an additional ionization at Concepcion was correlated with electrons of energies higher than 30 keV. The cosmic noise absorption detected at Punta Arenas was probably caused by the increase of the protons flux with energy between 80 and 240 keV.     

H+辐照前后C-SiC 涂层的红外吸收光谱研究

对在不锈钢基体上用离子束混合技术沉积的C－SiC涂层，进行了二次离子质谱（SIMS）及傅氏变换红外吸收光谱（FI－IR）的分析。研究了不锈钢基体涂覆H＋辐照前后的氢浓度分布以及H^ 辐照前后涂层的红外光谱振动吸收峰的变化，对SiC涂层阻氢的机理进行了探讨。     

推进剂组分对聚醚聚氨酯粘合剂热氧降解的影响(Ⅰ)硝酸酯增塑剂的影响

采用傅立叶红外光谱和核磁共振技术,研究了硝化甘油（ＮＧ）和１,２,４－丁三醇三硝酸酯（ＢＴＴＮ）两种硝酸酯增塑后的聚醚聚氨酯在空气中９０°Ｃ下的热氧降解。结果表明：ＮＧ,ＢＴＴＮ在聚氨酯粘合剂中的分解产物主要为醇类。这些小分子醇参与了聚氨酯硬段的重聚合反应,形成氨基甲酸酯结构;硝酸酯对聚氨酯粘合剂的热氧降解表现出某种稳定作用,并改变了软段产物结构,使甲酸酯和叔碳结构相对增加;硝酸酯分解产生的ＮＯ２自由基可能与软段降解产生的过氧化氢反应形成硝酸,从而加速了硝酸酯的水解。