月食过程月表太阳辐照和温度变化模拟

月食对月球轨道探测器的温度有重要的影响,分析月食时月表的太阳辐照和温度,具有重要意义。文章给出了通用的月表温度模型和月食时月表太阳辐照模型,根据某次月食的天文参数,用太阳辐照模型可求出月表任一点在月食时的太阳直接辐照变化过程,代入温度模型可求出任一点的温度变化过程。此模型和方法可用于对任何一次月食的分析,并以2007年8月28日的月食为例,模拟了该次月食的表面太阳直接辐照和温度的变化过程。     

Results from the ESA SREM monitors and comparison with existing radiation belt models

The Standard Radiation Environment Monitor (SREM) is a simple particle detector developed for wide application on ESA satellites. It measures high-energy protons and electrons of the space environment with a 20° angular resolution and limited spectral information. Of the ten SREMs that have been manufactured, four have so far flown. The first model on STRV-1c functioned well until an early spacecraft failure. The other three are on-board, the ESA spacecraft INTEGRAL, ROSETTA and PROBA-1. Another model is flying on GIOVE-B, launched in April 2008 with three L-2 science missions to follow: both Herschel and Planck in 2008, and GAIA in 2011). The diverse orbits of these spacecraft and the common calibration of the monitors provides a unique dataset covering a wide range of B-L* space, providing a direct comparison of the radiation levels in the belts at different locations, and the effects of geomagnetic shielding. Data from the PROBA/SREM and INTEGRAL/IREM are compared with existing radiation belt models.     

三结太阳电池高能电子损伤模拟及仿真分析

利用wx AMPS软件构建了高效Ga In P/Ga As/Ge太阳电池的中电池模型,并对电池抗辐照性能进行模拟研究。模拟发现,当辐照缺陷密度较小时,缺陷对中电池的电性能影响较小;当缺陷密度较大时,电性能的下降与电子注量值的对数成正比。计算电池的I-V和量子效率谱(QE曲线)可知,电池电性能的下降直接对应于量子效率的下降、饱和暗电流的增强以及并联电阻的衰降。模拟结果与试验结果的对比显示,在各子电池均匀损伤的假定下,1 Me V电子辐照的缺陷引入率约为0.81。     

典型卫星轨道的位移损伤剂量计算与分析

位移损伤剂量是评估电子元器件在轨发生位移损伤导致性能退化的重要参数。文章首先给出了位移损伤剂量的等效原理和计算方法,即用位移损伤等效注量来表征卫星轨道带电粒子导致的位移损伤剂量;之后分别采用3种不同的太阳质子注量模型,计算了典型大椭圆轨道的位移损伤等效注量,并结合计算结果对不同模型的特点和适用性进行了分析;其后针对4种典型卫星轨道,计算了不同飞行寿命期内的位移损伤等效注量,发现不同轨道的位移损伤剂量有较大差异,并结合空间带电粒子辐射环境分布特点及卫星轨道参数等分析了差异的产生原因;最后,分析不同的太阳质子注量预估方法对位移损伤剂量计算结果的影响,总结了不同轨道、不同飞行寿命情况下卫星经受的带电粒子辐射环境的严酷程度。研究结果可为卫星内部元器件位移损伤效应防护工作提供参考。     

红外光脉冲照射对目标红外特性调制的研究

针对目标的探测、识别以及目标红外特征的模拟,提出采用人工红外光源脉冲照射目标的方法。以目标红外辐射特性形成的机理为依据,建立人工红外光源脉冲照射目标的物理模型;确定氙灯为红外光源,建立了目标红外辐射的计算模型,并对红外光脉冲照射时目标的红外特性进行了仿真计算与分析。结果表明:人工红外光脉冲照射可以对目标红外特性进行调制,在相同条件下,光源照射功率越大,照射距离越近,调制的效果越好;垂直照射比平行照射效果好。     

MD-140导电胶粘剂性能测试及分析

文章简要介绍了航天器常用导电胶粘剂的成分和功能原理,研究了MD-140 导电胶粘剂的基本性能以及经过温度循环试验、粒子辐照试验后其力学性能、导热性能和导电性能的变化情况。从导电胶粘剂内部结构角度出发,对其性能的环境退化机理进行分析探讨。结果表明:高低温循环试验后,导电胶的黏结性能变强,导电性能变差,导热性能变化不显著;粒子辐照试验后,导电胶的黏结性能和导电性能变差,导热性能变化不显著。     

电子照射对硅漂移探测器性能的影响

由于高能电子辐射的长期照射,新一代太阳X射线探测器硅漂移传感器的探测性能可能发生变化.通过用电子放射源模拟空间电子对硅漂移探测器进行辐射照射试验,以测试电子照射对传感器能量分辨率、效率、信号幅度等性能的影响.试验结果表明,长期的电子照射造成硅漂移探测器面损伤和体损伤,使其漏电流增大,信号幅度减小,能量分辨率也受到照射的影响,而探测效率未发生变化.     

A model of the effects of heavy ion radiation on human tissue

In heavy ion radiotherapy and space travel humans are exposed to energetic heavy ions (C, Si, Fe and others). This type of irradiation often produces more severe biological effects per unit dose than more common X-rays. A new Monte Carlo model generates a physical space with the complex geometry of human tissue or a cell culture based model of tissue, which is affected by the passage of ionizing radiation. For irradiation, the model relies on a physical code for the ion track structure; for tissues, cellular maps are derived from two- or three-dimensional confocal microscopy images using image segmentation algorithm, which defines cells as pixilated volumes. The model is used to study tissue-specific statistics of direct ion hits and the remote ion action on cells. As an application of the technique, we considered the spatial pattern of apoptotic cells after heavy ion irradiation. The pattern of apoptosis is modeled as a stochastic process, which is defined by the action cross section taken from available experimental data. To characterize the degree of apoptosis, an autocorrelation function that describes the spatial correlation of apoptotic cells is introduced. The values of the autocorrelation function demonstrate the effect of the directionality of the radiation track on the spatial arrangements of inactivated cells in tissue. This effect is intrinsic only to high linear-energy-transfer radiation.     

电子辐照对聚乙烯热缩套管力学性能的影响

利用45 keV,1 MeV和2 MeV电子分别对聚乙烯热缩套管进行辐照实验,研究不同能量电子辐照对聚乙烯热缩套管力学性能的影响,并分析电子辐照下材料的损伤效应机理,建立力学性能退化规律。结果表明：实验选定的3种能量电子辐照都会造成聚乙烯的降解,材料脆化产生裂纹,从而导致其力学性能下降;但是由于这3种能量电子穿透深度不同,45 keV电子只能造成聚乙烯热缩套管表层材料损伤,力学性能最大下降量只有30%~40%,而1 MeV和2 MeV电子却会导致套管力学性能完全丧失,力学性能下降接近100%。