俯仰振荡三角翼在非定常自由流中运动的实验

在南京航空航天大学已建成的国内首座非定常风洞内,研制了一套单自由度俯仰振荡实验装置,设计开发了一套对模型姿态和来流风速进行联合控制的软件。对一60°后掠三角翼模型进行了单独俯仰振荡运动和俯仰振荡与自由来流耦合运动的实验。实验结果表明:模型做单独俯仰振荡时,振动频率和振动幅值的影响只有在迟滞环出现后才起作用,而迟滞环的出现是由于翼面上的不同流态对外界扰动的反应时间不同造成的。非定常自由流对做俯仰振荡的三角翼气动特性有很大的影响,模型上仰过程中来流的减速,进一步提高了最大升力系数,推迟了失速迎角;模型下俯过程中来流的加速,则更进一步推迟了升力系数恢复到静态时的值。当翼面上产生破碎涡流时,非定常自由流的作用表现得更为明显。     

跨声速柔壁自适应风洞及试验技术研究

简述西北工业大学自适应壁风洞研究课题组在“八五”期间开展跨声速柔壁自适应壁风洞试验技术研究的主要研究工作成果。简介该校的高速柔壁自适应壁风洞的设计及主要参数，以及在该风洞中开展的低超声速消除波反射的研究、近声速的自适应壁风洞试验技术研究和跨声速自适应壁试验段优化设计的研究。     

CARDC 2.4m引射式跨声速风洞设计与运行调试

中国空气动力研究与发展中心研制了可更换喷嘴的中压气体引射器 ,利用现有中压气源驱动 ,建成一座增压回流引射式跨声速风洞。试验段截面尺寸 2 .4m×2 .4m ,M =0 .3～ 1 .2。稳定段最高工作压力为 0 .45MPa ,最高模型试验雷诺数Rec=1 5× 1 0 6(M =0 .90 ,C =0 .2 4m) ,稳定吹风时间≥ 1 5s。风洞气动回路上分别配置有多喷管引射器、栅指扩散段、跨声速试验段驻室抽气系统及特殊的主排气系统等装置。采用智能自适应解耦控制技术 ,实现总压和M数独立、快速、精确地控制。该气动布局与部段配置及其功能设计 ,在国内跨声速风洞中均是首次采用。     

用电离层特性参量提取等效风场信息

导出了利用中低纬电离层特性参量获取电离层F层峰区高度上等效风场（包含电场和风场信息在内）的基本方程，并尝试用该方法从电离层特性参量（峰高和临频）提取等效风场信息，利用武汉站DGS-256电离层数字测高仪数据及由美国Massachusetts Lowell大学最新版的剖面反演程序换算得到F层峰高，获得了武汉地区夏季至日点附近，冬季至日点附近，冬季地磁特别宁静的九天和冬季平均等效风场的初步特征，并利用Fejer经验电场模式计算冬季电场引起的垂直漂移，估计电场和风场对武汉地区的垂直等效风场的贡献大小，结果表明：等效风场呈现出白天与夜晚幅度和方向的差异。至日点附近冬季与夏季白天的幅度差异以及明显的凌晨凹陷现象；平均情况下，垂直等效风场幅度和方向的变化主要是由中性风引起，受电场的影响不大。     

The characteristics of sharp (small-scale) boundaries of solar wind plasma and magnetic field structures

We investigate properties of large (>20%) and sharp (<10 min) solar wind ion flux changes using INTERBALL-1 and WIND plasma and magnetic field measurements from 1996 to 1999. These ion flux changes are the boundaries of small-scale and middle-scale solar wind structures. We describe the behavior of the solar wind velocity, temperature and interplanetary magnetic field (IMF) during these sudden flux changes. Many of the largest ion flux changes occur during periods when the solar wind velocity is nearly constant, so these are mainly plasma density changes. The IMF magnitude and direction changes at these events can be either large or small. For about 55% of the ion flux changes, the sum of the thermal and magnetic pressure are in balance across the boundary. In many of the other cases, the thermal pressure change is significantly more than the magnetic pressure change. We also attempted to classify the types of discontinuities observed.     

Acceleration of interplanetary pick-up ions and anomalous cosmic rays

It may not be doubted anymore that anomalous cosmic rays (ACRs) are produced in the heliosphere from interplanetary pick-up ions through their acceleration at the solar wind termination shock. However, there is no general agreement in the community of heliospheric researchers concerning the mechanism of injection of the pick-up ions into the shock acceleration. We discuss here three possible ways for pick-up ions to be involved into the acceleration process at the termination shock: (1) preacceleration of pick-up ions in the whole region from the Sun up to the termination shock by solar wind turbulences and interplanetary shock waves, (2) local preacceleration of pick-up ions in a vicinity of the termination shock by shock surfing, and (3) formation of high-velocity tails in pick-up ion spectra consisting of secondary pick-up ions which are produced in the supersonic solar wind due to ionization of energetic neutral atoms entering from the inner heliosheath.     

飞机V型外倾双垂尾载荷校准技术

根据垂尾载荷校准及建模需求,对飞机V型外倾双垂尾结构受载情况进行了分析和简化,确定了校准试验载荷,研制了垂尾载荷校准试验专用龙门梁架。采用液压协调加载技术,完成了外倾双垂尾载荷校准试验,建立了满足测载要求的载荷模型。此种方法充分利用了左右垂尾外倾、双垂尾之间空间较大的特点,对左右垂尾对称施加向外的单点、多点载荷,加载载荷侧向分量左右自平衡,垂向分量依靠飞机自身重量即可平衡,飞机不需要复杂的固定与约束。试验中采用先搭建龙门框架,再停放飞机的方法,降低了试验风险、加快了试验进度,取得了良好的试验结果,对其他此类结构的载荷校准具有一定的借鉴作用。     

Effects of Mach numbers on Magnus induced surface pressure

Experimental and numerical methods were used to investigate the Magnus phenomena over a spinning projectile. The pressure force acting on the surface of a spinning projectile was measured for various cases by employing a relatively novel experimental technique. A set of miniature pressure sensors along with a data acquisition board, battery and storage memory were placed inside a spinning model and the surface pressure were obtained through a remotely controlled system. Circumferential pressures of the model for both rotational and static conditions were obtained at two different free stream Mach numbers of 0.4 and 0.8 and at different angles of attack. The results showed the ability of this new test method to measure the very small Magnus force via surface pressures over the projectile. The results provide a deep insight into the flow structure and illustrate changes in the cross-flow separation locations as a result of rotation. Similar results were obtained by the numerical simulations and were compared with the experimental data.     

基于Visual Basic的互感器负荷箱测量仪校准系统的实现

为解决互感器负荷箱测量仪同相分量和正交分量的校准问题,在分析互感器负荷箱测量仪工作原理的基础上,设计了基于电子/电工组合式的互感器负荷箱测量仪校准装置,并简要说明装置电工部分、电子部分以及上位机软件的实现。经省级计量研究院验证结果表明,该装置校准结果符合0.2级要求,可作为标准装置解决1级互感器负荷箱测量仪量值溯源问题。     

高超声速圆锥边界层失稳条纹结构实验研究

边界层转捩的准确预测是高超声速飞行面临的关键气动问题之一。为研究高超声速边界层失稳和转捩机理,以前缘半径1.6mm、半锥角7°的圆锥模型为研究对象,在FD-07高超声速风洞中采用红外热图技术开展边界层转捩实验测量。通过与工程计算结果对比,确认模型表面边界层流态。实验结果表明:有迎角条件下,模型表面中后段出现条纹结构,条纹结构的起始位置随着周向角的增加而向上游移动;随着迎角的增加,条纹起始位置向上游移动,条纹强度差异和条纹与模型中心线的夹角越来越大。实验获得的条纹结构与不同频率扰动波相互作用直接数值模拟获得的条纹结构现象一致。通过对比分析,认为边界层内不同频率扰动波相互作用是产生条纹结构的一种机制。