首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   558篇
  免费   60篇
  国内免费   72篇
航空   327篇
航天技术   176篇
综合类   54篇
航天   133篇
  2024年   1篇
  2023年   10篇
  2022年   16篇
  2021年   25篇
  2020年   15篇
  2019年   24篇
  2018年   21篇
  2017年   23篇
  2016年   27篇
  2015年   18篇
  2014年   41篇
  2013年   46篇
  2012年   31篇
  2011年   46篇
  2010年   39篇
  2009年   41篇
  2008年   35篇
  2007年   40篇
  2006年   38篇
  2005年   30篇
  2004年   14篇
  2003年   19篇
  2002年   16篇
  2001年   7篇
  2000年   11篇
  1999年   8篇
  1998年   5篇
  1997年   6篇
  1996年   7篇
  1995年   7篇
  1994年   4篇
  1993年   10篇
  1992年   3篇
  1991年   2篇
  1990年   2篇
  1989年   2篇
排序方式: 共有690条查询结果,搜索用时 15 毫秒
681.
本文研究了采用分布式调谐质量阻尼器(TMD)对悬臂梁进行振动抑制的问题.首先建立了安装N个TMD的悬臂梁的动力学方程;然后通过有限单元法离散偏微分方程,使用Newmark-β法进行含TMD的悬臂梁动响应求解;最后基于数值计算模型,分别研究周期荷载与冲击荷载作用下,梁振动控制的效果.研究表明:TMD可以有效抑制悬臂梁振动...  相似文献   
682.
采用LES(large eddy simulation)+FW-H(Ffowcs Williams-Hawkings)方程,研究了圆柱表面使用不同PPI(pore number per inch)和厚度的多孔介质对圆柱尾迹及圆柱-翼型干涉噪声的影响,探索了多孔介质的降噪规律和机理。结果表明:多孔介质能稳定圆柱表面的剪切层,抑制旋涡脱落,从而削弱尾迹对下游翼型的影响,圆柱单音噪声最大可降79 dB,翼型单音峰值降低13.22 dB,宽频噪声降低20 dB;多孔材料PPI的变化对降噪效果影响较小,而厚度是影响流场模态、降噪效果及气动性能的一个关键参数;多孔材料厚度合适时,圆柱-翼型流场形态为“剪切层模态”,可有效降低湍流干涉噪声;多孔材料厚度较小时,发现了一种流场形态,即“剪切层-尾迹模态”,导致翼型噪声增大;合适的多孔介质厚度不仅降噪效果显著,对圆柱-翼型的气动性能也有改善作用。  相似文献   
683.
采用2种水稻密度的精量穴直播种植方式与人工移栽种植方式,对比研究了精量穴直播晚稻的产量形成特性.结果表明,2种密度的精量穴直播的实际产量比人工移栽的实际产量显著增加,分别增产2.75%~10.48%.精量穴直播较人工移栽的有效穗数多、结实率高.在孕穗期和齐穗期,精量穴直播的水稻叶片叶绿素含量显著高于人工移栽的,同时其光合速率也较高.  相似文献   
684.
未来智能化网络化多功能卫星系统技术发展思考   总被引:1,自引:1,他引:0       下载免费PDF全文
陈占胜 《上海航天》2021,38(3):63-67
我国卫星领域经过几十年的发展,现在正面临技术创新突破的关键时期。以美国“星链”为代表的大规模星座系统的出现,展现了互联网+航天时代的前景雏形。同时,人工智能技术迅猛发展,神经网络、机器学习和大数据挖掘等成果转化应用,可大幅提升卫星自主运行、星上数据处理以及多任务适应能力。本文通过对近年来国外典型卫星系统发展进行深入解剖,从未来卫星网络化、智能化和多功能特点分析技术发展布局、应用模式创新和研产模式转型等影响,提出适应上述改变的举措建议,为我国卫星技术创新发展提供有益参考。  相似文献   
685.
《中国航空学报》2022,35(12):102-116
Mechanically pumped two-phase loop (MPTL) which is a prominent two-phase heat transfer technology presents a promising prospect in thermal control for space payload. However, transient behavior of MPTL caused by phase-change and heat sources load-on/off in simulated space environment is rarely reported. In the present study, one MPTL setup was designed and constructed, and experimentally studied. Particularly, a novel two-phase thermally-controlled accumulator integrated with passive cooling measure and three capillary structures was designed as the temperature-control device. Dynamic behavior of the start-up, temperature control, and temperature adjustment were monitored; meanwhile, thermodynamic behavior within the proposed accumulator, the operating behavior as well as the heat and mass transfer behavior between the main loop and the accumulator were revealed. The results show that the fluid management function of the capillary structures for the novel accumulator is verified. The working point of the MPTL system can be adjusted by changing the temperature control point of the accumulator and it is little influenced by external heat flux and heat sources on/off. Pressure-drop oscillations which are manifested as fluctuations of temperature and pressure can be observed after phase changing due to the compressible volume within the accumulator and the negative-slope portion of the internal pressure.  相似文献   
686.
大型自由翻滚碎片的质心是在轨操作基坐标系下的不动点,也是碎片连体基下动力学参数向卫星坐标系转换的基准,对其精确识别是提高碎片动力学参数辨识精度的关键。提出基于惯性单元测量数据与双目视觉定位数据融合的大型空间碎片质心位置识别方法。基于无力矩欧拉方程,获取附着到空间碎片表面的惯性单元间转换关系,利用该转换关系对惯性单元冗余测量数据优化,再优化求解惯性单元到质心点距离;利用双目视觉获取惯性单元上标记点动态坐标,再利用惯性单元到质心点距离,基于三点定位原理识别大型空间碎片的质心位置。以加入高斯白噪声的惯性单元与双目视觉测量数据进行仿真,结果表明优化解算后惯性单元实时测量数据的误差降低到1%以下,解算的质心位置三轴误差小于0.47mm;开展了地面试验,结果表明,解算的质心位置三轴误差小于0.49mm。仿真和试验证明,该方法能够为大型空间碎片的消旋、捕获任务提供准确的数据基准。  相似文献   
687.
This study examines the occurrences rate of geomagnetic storms during the solar cycles (SCs) 20–24. It also investigates the solar sources at SCs 23 and 24. The Disturbed storm time (Dst) and Sunspot Number (SSN) data were used in the study. The study establishes that the magnitude of the rate of occurrences of geomagnetic storms is higher (lower) at the descending phases (minimum phases) of solar cycle. It as well reveals that severe and extreme geomagnetic storms (Dst < -250 nT) seldom occur at low solar activity but at very high solar activity and are mostly associated with coronal mass ejections (CMEs) when occurred. Storms caused by CME + CH-HSSW are more prominent during the descending phase than any other phase of the solar cycle. Solar minimum features more CH-HSSW- associated storms than any other phase. It was also revealed that all high intensity geomagnetic storms (strong, severe and extreme) are mostly associated with CMEs. However, CH-HSSW can occasionally generate strong storms during solar minimum. The results have proven that CMEs are the leading cause of geomagnetic storms at the ascending, maximum and the descending phases of the cycles 23 and 24 followed by CME + CH-HSSW. The results from this study indicate that the rate of occurrence of geomagnetic storms could be predicted in SC phases.  相似文献   
688.
战斗机全动翼面操纵系统中普遍存在间隙,其非线性特性不但影响系统地面振动试验数据的有效性,而且可能导致飞行器气动弹性稳定性边界产生偏差,因此有必要开展考虑间隙非线性的气动弹性响应分析研究。以全动翼面旋转方向间隙为研究对象,基于虚拟质量法线化模态振型,建立一组可以表达整个响应域变形的统一模态振型;采用有理函数拟合,将频域非定常气动力转换到时域;研究分析不同间隙参数对应的极限环响应特性。结果表明:当全动翼面结构系统中存在间隙时,在低于线性颤振边界的特定飞行区域,翼面会出现非线性极限环振荡现象,间隙参数会影响极限环振荡幅值、频率以及限环振荡的进入临界速压和发散临界速压。  相似文献   
689.
《中国航空学报》2023,36(3):212-219
Infrared camouflage based on artificial thermal metasurfaces has recently attracted significant attention. By eliminating thermal radiation differences between the object and the background, it is possible to hide a given object from infrared detection. Infrared camouflage is an important element that increases the survivability of aircraft and missiles, by reducing target susceptibility to infrared guided threats. Herein, a simple and practicable design is theoretically presented based on a multilayer film for infrared stealth, with distinctive advantages of scalability, flexible fabrication, and structural simplicity. The multilayer medium consists of silicon substrate, carbon layer and zinc sulfide film, the optical properties of which are determined by transfer matrix method. By locally changing the thickness of the coating film, the spatial tunability and continuity in thermal emission are demonstrated. A continuous change of emissive power is further obtained and consequently implemented to achieve thermal camouflage functionality. In addition, other functionalities, like thermal illusion and thermal coding, are demonstrated by thickness-engineered multilayer films.  相似文献   
690.
This paper investigates the ionospheric storm of December 19–21, 2015, which was initiated by two successive CME eruptions that caused a G3 space weather event. We used the in situ electron density (Ne) and electron temperature (Te) and the Total Electron Content (TEC) measurements from SWARM-A satellite, as well as the O/N2 observations from TIMED/GUVI to study the ionospheric impact. The observations reveal the longitudinal and hemispherical differences in the ionospheric response to the storm event. A positive ionospheric storm was observed over the American, African and Asian regions on 20 December, and the next day showed a negative storm. Both these exhibited hemispheric differences. A positive storm was observed over the East Pacific region on 21 December. It is seen that the net effect of both the disturbance dynamo electric field and composition differences become important in explaining the observed variability in topside ionospheric densities. In addition, we also discuss the Te variations that occurred as a consequence of the space weather event.  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号