固冲发动机三维内流场数值计算与应用

利用三维隐式有限体积ＴＶＤ格式求解Ｎ－Ｓ／Ｅｕｌｅｒ方程组,数值模拟固体燃料冲压发动机（ＳＦＲＪ）突扩燃烧室、补燃室和喷管的统一内流场,研究了从亚声速到跨声速到超声速的整个工作过程,揭示了ＳＦＲＪ内复杂的流场结构,并与试验进行对比研究,数值结果与试验吻合很好。     

气相色谱测定偏二甲肼纯度方法的改进

研究了气相色谱内标法代替常规的标准工作曲线法测定偏二甲肼纯度（ＵＤＭＨ）。用内标与偏二甲肼混合样品,避免了微量进样不准确的缺陷。结果表明,该方法相对标准偏差接近于１％,回收率大于９８．０％。     

空客A320鲨鳍小翼燃油节油性能分析

通过对比已选装和未选装鲨鳍小翼飞机的燃油消耗率,找出了节油效率和鲨鳍小翼改装成本之间的平衡点,为选装鲨鳍小翼的决策提供技术支持和数据参考。     

膜分离器及其机载应用

为了满足飞机放火防爆要求，膜分离器作为机载油箱惰化系统的关键部件在国外军、民机已经装机使用，在国内膜分离器处于研制阶段，正逐步向军、民用飞机推广应用。分析了国内外现状，对膜分离器工作机理进行了阐述，详细论述了膜分离器研制过程中涉及到的膜材料、膜制备工艺、膜分离器，总结了影响膜分离器性能的主要参数；进行了膜分离器在机载惰化中应用的试验研究，总结了研发和应用中得到的经验，有利于膜分离器今后的研发和机载惰化中的应用。     

Thick exchange layer evaporation model with natural convection effect and evaporation experimental study for multicomponent droplet

In order to investigate the high-temperature evaporation characteristics of multicomponent liquid fuel, three kinds of blended fuel: n-heptane/n-decane/RP-3 aviation kerosene-ethanol were experimentally studied with and without forced convection. Further, based on zero-diffusion and infinite diffusion concept, this study expanded Thick Exchange Layer evaporation model with Natural Convection effect (NC-TEL) to multicomponent liquid fuels. The experimental results show that the droplet evaporation rate increases significantly with the increase of ambient temperature. Higher temperature leads to more significant relationships between the composition ratio and the evaporation rate. The effect of forced convection is not obviously under the circumstance in this paper. Then, the evaporation models were validated by experimental data. In general, the new NC-TEL model behaves better than the Ranz-Marshall (R-M) model, and the prediction accuracy at high temperature is improved by 8% to 35%. In lower temperature conditions, the prediction of zero-diffusion NC-TEL model is better than the infinite diffusion NC-TEL model. In high-temperature conditions, for n-heptane-ethanol droplet, the predictions of NC-TEL model are accurate, but for n-decane/RP-3 aviation kerosene-ethanol, the predictions are lower than experimental results. This may be caused by the micro-explosion phenomenon and the Marangoni phenomenon.     

基于EGView的SR20飞机的发动机爆震分析

基于EGView软件对SR20飞机出现的多起发动机CHT异常升高故障进行了分析，结果表明出现了早燃引发的爆震，进一步对爆震发生的几率以及如何减小爆震的强度和持续时间进行了研究，并就该机型在运行中减少爆震的发生提出了建议。     

Robust control for constant thrust rendezvous under thrust failure

A robust constant thrust rendezvous approach under thrust failure is proposed based on the relative motion dynamic model. Firstly, the design problem is cast into a convex optimization problem by introducing a Lyapunov function subject to linear matrix inequalities. Secondly, the robust controllers satisfying the requirements can be designed by solving this optimization problem.Then, a new algorithm of constant thrust fitting is proposed through the impulse compensation and the fuel consumption under the theoretical continuous thrust and the actual constant thrust is calculated and compared by using the method proposed in this paper. Finally, the proposed method having the advantage of saving fuel is proved and the actual constant thrust switch control laws are obtained through the isochronous interpolation method, meanwhile, an illustrative example is provided to show the effectiveness of the proposed control design method.     

氢燃料双模态燃烧室模态转换

为研究双模态燃烧室的模态转换规律,采用计算流体动力学(CFD)方法,对氢燃料模型燃烧室在不同当量油气比、飞行马赫数、燃料喷射方式下的流场进行了数值模拟,并与试验结果进行对比,两者相互吻合.研究结果表明:当量油气比提高、飞行马赫数降低及双面喷射燃料均使燃烧室更趋于亚燃工作模态.     

航空发动机燃烧室喷嘴内部燃油结焦研究

对在最严重热负荷时喷嘴内部燃油沉积率以及燃油性能参数的变化进行了试验研究。对1个相似的喷嘴试验件进行了传热试验,通过试验修正计算中关键的传热系数,建立了符合喷嘴实际的传热计算方法;用该方法推算发动机在真实条件下发生最严重热负荷的工况,然后进行了燃油沉积率试验,得到了燃油管道沉积率与温度的关系,同时得到了喷嘴和油滤上积沉的特征;对沉积物成分进行了分析,并测定了燃油油样进行性能参数。通过研究结果,提出了改善喷嘴燃油热安定性的措施。     

Design of an FPGA-based electronic flow regulator (EFR) for spacecraft propulsion system

This paper describes a scheme for electronically regulating the flow of propellant to the thruster from a high-pressure storage tank used in spacecraft application. Precise flow delivery of propellant to thrusters ensures propulsion system operation at best efficiency by maximizing the propellant and power utilization for the mission. The proposed field programmable gate array (FPGA) based electronic flow regulator (EFR) is used to ensure precise flow of propellant to the thrusters from a high-pressure storage tank used in spacecraft application. This paper presents hardware and software design of electronic flow regulator and implementation of the regulation logic onto an FPGA.