双肋式微型气动阀的数值计算与实验

 针对现有微型三角阀效率低的问题,提出双肋式气动阀这一新型微阀,通过两级带圆弧过渡的收敛形肋条,在减小正向气流压力损失的同时,引导逆向气流分为3股后再呈“Y”形汇聚,产生强烈的相互撞击而抵消部分动能,从而减小逆向流量以提高效率。通过数值计算对双肋式气动阀的作用原理进行了分析与验证;加工了特征尺寸为1 mm的三角阀、梯形阀与双肋阀实验件,并设计了相应的实验方案,在微流体实验平台上进行了对比实验。结果表明双肋阀能大幅提高效率：对不可压流,双肋阀可将效率从普通阀的2%～3%提升至14%左右;对可压流,双肋阀能将效率从2%提升至约13%。     

载荷多次作用下的共因失效系统可靠性模型

研究了随机载荷作用次数对系统可靠性的影响,指出传统的可靠性模型并不能很好地反映载荷作用次数对系统可靠性的影响,运用载荷-强度干涉模型和顺序统计量理论建立了随机载荷多次作用下的共因失效系统可靠性模型.考虑系统中零件的失效相关性,在不作失效独立假设的前提下,运用系统级载荷-强度干涉模型建立了共因失效系统可靠性模型.根据随机载荷作用的统计学意义,运用顺序统计量理论建立了载荷多次作用时等效载荷的累积分布函数和概率密度函数,在此基础上,建立了随机载荷多次作用下的共因失效串联系统、并联系统以及k/n系统可靠性模型.     

吸气模式激光推进空气等离子体光谱

利用实验室自行研制的紫外预电离CO2激光器进行了激光等离子体实验,实验采用底面直径均为60mm,焦距分别为5 mm和10 mm的两种抛物面光船。介绍了激光等离子体光谱和明显的特征谱线,以及激光等离子体温度估计模型;分析了两种光船对激光等离子体的影响。实验表明:相同底面直径10 mm焦距光船产生的等离子体信号峰值和持续时间均略大于5 mm焦距光船;10 mm焦距光船产生的等离子体温度明显高于5 mm的,最大温度产生时间比5 mm光船要晚一些。     

交错肋结构形式对换热和流阻特性的影响试验研究

通过试验,研究了不同结构的交错肋对换热及流阻特性的影响。试验结果表明:努塞尔数和流阻系数,随着肋宽的增大而都增大,随着肋间距的增大而都减小,随着肋倾角的增大而都增大。综合换热效果为1.3~2.5。     

The Genesis Solar Wind Concentrator Target: Mass Fractionation Characterised by Neon Isotopes

The concentrator on Genesis provided samples of increased fluences of solar wind ions for precise determination of the oxygen isotopic composition. The concentration process caused mass fractionation as a function of the radial target position. This fractionation was measured using Ne released by UV laser ablation and compared with modelled Ne data, obtained from ion-trajectory simulations. Measured data show that the concentrator performed as expected and indicate a radially symmetric concentration process. Measured concentration factors are up to ∼30 at the target centre. The total range of isotopic fractionation along the target radius is 3.8%/amu, with monotonically decreasing ²⁰Ne/²²Ne towards the centre, which differs from model predictions. We discuss potential reasons and propose future attempts to overcome these disagreements.     

Fe/O Ratios in Interplanetary Shock Accelerated Particles

It is widely accepted that diffusive shock acceleration is an important process in the heliosphere, in particular in producing the energetic particles associated with interplanetary shocks driven by coronal mass ejections. In its simplest formulation shock acceleration is expected to accelerate ions with higher mass to charge ratios less efficiently than those with lower mass to charge. Thus it is anticipated that the Fe/O ratio in shock-accelerated ion populations will decrease with increasing energy above some energy. We examine the circumstances of five interplanetary shocks that have been reported to have associated populations in which Fe/O increases with increasing energy. In each event, the situation is complex, with particle contributions from other sources in addition to the shock. Furthermore, we show that the Fe/O ratio in shock-accelerated ions can decrease even when the shock is traveling through an Fe-rich ambient ion population. Thus, although shock acceleration of an Fe-rich suprathermal population has been proposed to explain large Fe-rich solar particle events, we find no support for this proposal in these observations.     

圆管内表面周向三维裂纹应力强度因子的新解法

对圆管内表面周向三维裂纹应力强度因子的求解,发展了传统的能量差率方法,同时研究了新兴的双重边界元理论,并运用这两种新解法,分别获得了关于裂纹张开位移的伯努利方程的半数值半工程封闭解和基于非连续裂尖奇异单元离散的应力强度因子数值解。并讨论了应力强度因子与裂纹形状a/c及裂纹深度a的关系,两者比较分析发现,其计算结果规律是一致的,且能量差率方法更保守,也更安全。     

联合应用现代优化方法与S2流面计算进行多级涡轮的气动设计

本文联合应用S2流面正问题计算和多级局部优化设计对某三级涡轮进行多级气动优化设计。优化联合采用人工神经网络和遗传算法,流场计算采用全三维粘性流N-S方程求解,计算网格采用H-O-H型网格,即入口段、出口段采用H型网格,叶片区域采用O型网格。通过优化,总效率提高1.1%,总体性能提高,达到设计要求。     

二次流喷射对喷管流场性能的影响

采用有限体积法求解二维守恒型雷诺平均N-S方程,数值模拟了单膨胀斜面喷管内外流场,研究了二次流喷射对单膨胀斜面喷管非设计状态性能的影响,给出了性能随喷射流量、喷射总压和喷射角度的变化规律。计算结果表明,在喷管下斜板尾缘进行二次流喷射可以提高喷管非设计状态性能,喷射流量和喷射角度是影响喷管性能提高的主要因素,并存在最优的喷射流量和喷射角度,喷射总压对喷管性能影响较小。     

粉末燃料冲压发动机理论性能分析

研究粉末燃料冲压发动机的理论性能,采用编制的热力计算软件,分别对以硼粉、铝粉、镁粉为燃料的发动机性能进行了计算,分析了不同参数对发动机比冲的影响趋势,为进一步研究及发动机设计奠定了基础。通过与常规液体燃料冲压发动机及固体火箭冲压发动机进行比较,说明了粉末燃料冲压发动机在比冲及体积比冲方面的优势。鉴于金属粉末燃烧产物中凝相物质含量高的特点,研究了两相流损失对发动机性能的影响。