Influence of uniaxial tensile pre-strain on forming limit curve by using biaxial tensile test

This paper focused on the effect of pre-strain on forming limit curves (FLC) of 5754-O aluminum alloy sheet through utilizing biaxial tensile approach. Based on Swift model and Yld2000-2d yield criterion, the dimensions of cruciform specimen was optimized through applying finite element method for increasing the strain at specimen center. After that, with the recommended specimen size, the cruciform specimen was tested under various stroke ratios to experimentally characterize the limit strains under different pre-strain levels. Subsequently, the biaxial tensile tests were simulated by Abaqus to obtain the limit strains and validate the material models. It can be observed in both experiments and simulations that the pre-strained uniaxial tension followed by plane tension or equi-biaxial tension can improve the formability of sheet metals. Besides, the strain path change affects the trend of first derivative of strain rate difference between neighboring points with respect to time. An early increase occurred and then fell back to the stable value, the steady evolution continued until to a new increase reaching the critical value. The M–K prediction approach was simulated to verify the influence of pre-strain on FLC. It can be found that the early increase peaks of the major strain incremental ratio rose with the amplitude of pre-strain. Finally, the phenomenon of pseudolocalization caused by the strain path change was explained through evolution of stress state inside the groove.     

考虑气穴影响的2D压力伺服阀稳定性

为研究双自由度（2D）压力伺服阀工作时的气穴现象对阀芯稳定性的影响，利用AMESim中的基本库和HCD库建立2D压力伺服阀各组件仿真模型。理论分析得出气穴现象会降低阀体中含气油液的有效体积弹性模量，得出考虑气穴影响的阀芯稳定性条件。仿真结果表明气穴现象会导致主阀芯到达稳定位置后出现振荡现象，影响主阀芯的穿越频率从21 Hz降低至6 Hz，限制主阀芯的频宽，适当增加主阀芯阻尼比能提高主阀芯工作稳定性。提出一种新型阻尼活塞结构，建立模型分析得出其能在不影响伺服阀频响、阀芯位移和抗污染能力情况下提高主阀芯阻尼比以提高阀芯工作稳定性，并且设计实验进行验证。实验结果表明，应用阻尼活塞将2D压力伺服阀压力输出波动从9%降低至2%，能够提高飞行器制动时刹车阀工作稳定性。     

氧化时间对2A12铝合金硬质阳极氧化膜性能的影响

氧化时间作为硬质阳极氧化的工艺参数之一,对硬质阳极氧化膜层性能有着很大影响。主要研究了不同氧化时间对2A12硬质阳极氧化膜厚度、硬度及耐腐蚀性的影响,并采用金相显微镜对氧化膜的表观形貌进行了分析。结果表明:所得硬质阳极氧化膜具有类似棱柱状的结构,氧化70min所得氧化膜综合性能最佳。     

压力对Fe_（16）N_2结构和磁性的影响

用基于密度泛函理论的第一性原理方法,系统地研究了压力对Fe16N2体系结构和磁性的影响。结果表明仅仅离N位最远的Fe Ⅲ拥有一个约为2.84μB的大磁矩,而FeⅠ和Fe Ⅱ原子没有大磁矩产生。此外,还发现从0到47 GPa,总磁矩和单胞体积随着压力的增加单调减小,然而,在48 GPa的压力作用下,伴随着单胞体积的剧减,体系总磁矩消失。     

中国民航旅客多渠道服务技术平台应用研究

国际航协IATA简化商务推广,对民航传统订票、机场柜台等旅客服务、业务流程产生了很大的影响。各航空公司纷纷将服务、便捷作为旅客服务产品下一步的发展要求。结合中国民航行业情况以及所在民航单位的产品建设,提出了以简化商务为突破点,以旅客为中心,围绕便捷的旅客出行服务,利用当前主流和最新的IT技术建立旅客多渠道服务技术平台的解决方案,以推动离港电子客票业务的发展、服务渠道的多样化。研究成果已应用在作者单位的系统平台建设中,经实践表明,旅客服务技术平台通过传统业务与最新IT技术结合,将传统旅客服务融入新兴服务模式,有较强的技术架构优势和特性．各类服务产品得以迅速发展,有效降低了航空公司的运营成本。     

一种基于自适应波束形成的导引头抗干扰方法

传统的反辐射雷达导引头天线通常具有较宽的波束,且具有固定的波束方向图,这就必然导致不同空域的目标辐射信号和干扰信号同时进入导引头接收系统,严重影响导引头的测向性能,无法适应未来复杂电磁环境下工作的需要.为此,提出一种基于自适应数字波束形成技术的主动抗干扰方法,并研究该方法在导引头系统中应用的可行性.仿真结果表明,采用该...     

新型高密度燃料性能研究

研究了新型高密度碳氢化合物HD-2与航空煤油的复配。通过对不同配比的燃料的密度、黏度、闪点、燃烧热值的测定比较,研究了复配燃料的基本性能;通过火箭一冲压组合发动机（RBCC）航空煤油点火燃烧性能实验,研究了不同HD-2添加含量的复配燃料的燃烧性能。基本性能测试实验和点火燃烧性能实验的结果表明：添加HD-2高密度碳氢化合...     

Thermoelectric Properties of Mg2Si1-xSnx Synthesized by Bulk Mechanical Alloying

Bulk mechanical alloying （BMA） has been successfully applied to solid-state synthesis of p-type and n-type thermoelectric materials Mg2Si1-xSnx （x = 0, 0.2, 0.4, 0.6, 0.8, 1） from element-powders at the room temperature in a relatively short time. The electrical conductivity, the Seebeck coefficient and the thermal conductivity of the Mg2Si1-xSnx are quite sensitive to the x-content. With the x-content rising, the electrical conductivity increases. When x = 0.6, it reaches the lowest and Mg2Si shows an n-type of semi-conducting However, when x = 0.2 and T 〉525 K, the Seebeck coefficient of the samples will change the opposite way. While x≥0.4, the samples present a p-type of semi-conducting. The figure of merit, Z of Mg2Si1-xSnx will be obtained in the range from 300 K to 700 K. When x = 0.6, Z proves to be higher than that of other samples at 300 K≤ T≤650 K.     

The Climate Response to the Astronomical Forcing

Links between climate and Earth’s orbit have been proposed for about 160 years. Two decisive advances towards an astronomical theory of palæoclimates were Milankovitch’s theory of insolation (1941) and independent findings, in 1976, of a double precession frequency peak in marine sediment data and from celestial mechanics calculations. The present chapter reviews three essential elements of any astronomical theory of climate: (1) to calculate the orbital elements, (2) to infer insolation changes from climatic precession, obliquity and eccentricity, and (3) to estimate the impact of these variations on climate. The Louvain-la-Neuve climate-ice sheet model has been an important instrument for confirming the relevance of Milankovitch’s theory, but it also evidences the critical role played by greenhouse gases during periods of low eccentricity. It is recognised today that climatic interactions at the global scale were involved in the processes of glacial inception and deglaciation. Three examples are given, related to the responses of the carbon cycle, hydrological cycle, and the terrestrial biosphere, respectively. The chapter concludes on an outlook on future research directions on this topic.     

两种信道编码记录方式在光盘应用中的对比

依据数字编码理论对几种光盘编码调制的结构参数性能进行了比较，着重分析了光盘的两种信道编码记录方式：用于磁光（ＭａｇｎｅｔｏＯｐｔｉｃａｌｄｉｓｋ－ＭＯ）光盘的游程长度受限（ＲｕｎＬｅｎｇｔｈＬｉｍｉｍｔｅｄ）脉宽调制（ＰｕｌｓｅＷｉｄｔｈＭｏｄｕｌａｔｉｏｎ）［ＲＬＬ（１，７）－ＰＷＭ］记录方式，及用于相变（ＰｈａｓｅＣｈａｎｇｅ－ＰＣ）光盘的游程长度受限（ＲｕｎＬｅｎｇｔｈＬｉｍｉｍｔｅｄ）脉位调制（ＰｕｌｓｅＰｏｓｉｔｉｏｎＭｏｄｕｌａｔｉｏｎ）［ＲＬＬ（２，７）－ＰＰＭ］记录方式，并结合记录介质的特点，阐明了两者并存的原因．