复合材料转动壳体动力特性分析

根据转动壳体的动力学方程,在利用DMAP对大型有限元软件MSC/NASTRAN二次开发的基础上,采用有限元方法对复合材料层合壳体转动状态下的动力特性进行了研究,分析了科氏力、离心力和横向剪力对固有频率的影响,并与实验结果进行了比较.结果显示由于科氏力的作用,即使在动坐标系下,层合壳体也会出现频率不等的前后行波,横向剪力使壳体的固有频率降低,且随着壳体厚径比的增加其影响显著增加.      

离心力场中TiC/FeNiCr复合材料 涂层的原位反应合成

以Fe₂O₃,Cr₂O₃,CrO₃,NiO,Al,Ti粉和C粉为原料,在离心力场中在碳钢基体表面原位反应合成了TiC-FeNiCr复合材料涂层.利用X射线衍射、金相照相、扫描电镜、X射线能谱分析等手段对涂层的显微结构和组织形貌进行了研究.测试了涂层的显微硬度及干滑动磨损条件下的耐磨性能.结果表明,涂层和碳钢基体能形成冶金结合.涂层由FeNiCr奥氏体和其中弥散分布的TiC硬质相组成.TiC颗粒晶粒尺寸小于3μm,形状呈多边形或花瓣状.涂层显微硬度约为Hv 500~Hv 800,TiC含量增加,涂层的显微硬度提高.涂层较碳钢具有优异的耐磨性能.      

含SiO2,ZrO2微粒复合镀镍层抗高温氧化性能

通过对含有SiO₂,ZrO₂微粒复合电沉积的研究,在Cu合金表面分别获得了含量(原子数分数)为11.3％ SiO₂,5.31％ ZrO₂微粒的Ni基复合镀层.通过在800℃、900℃条件下的高温氧化和热震循环试验,研究了这种复合镀镍层的高温氧化性能和界面结合特性.结果表明:经过40?h的高温氧化,2种复合镀镍层的抗氧化性能均达到抗氧化级,而且含SiO₂微粒的复合镀镍层的抗氧化性能优于含ZrO₂微粒的复合镀镍层;经过55次冷热循环,含SiO₂微粒的复合镀镍层与铜基体结合良好.     

Orbital phase spectroscopy of four high mass X-ray binary pulsars to study the stellar wind of the companion

Our work focuses on a comprehensive orbital phase-dependent spectroscopy of the four High Mass X-ray Binary Pulsars (HMXBPs) 4U 1538-52, GX 301-2, OAO 1657-415 and Vela X-1. We hereby report the measurements of the variation of the absorption column density and iron-line flux along with other spectral parameters over the binary orbit for the above-mentioned HMXBPs in elliptical orbits, as observed with the Rossi X-ray Timing Explorer (RXTE) and the BeppoSAX satellites. A spherically symmetric wind profile was used as a model to compare the observed column density variations. Out of the four pulsars, only in 4U 1538-52, we find the model having a reasonable corroboration with the observations, whereas in the remaining three the stellar wind seems to be clumpy and a smooth symmetric stellar wind model appears to be quite inadequate in explaining the data. Moreover, in GX 301-2, neither the presence of a disk nor a gas stream from the companion was validated. Furthermore, the spectral results obtained in the case of OAO 1657-415 and Vela X-1 were more or less similar to that of GX 301-2.     

复合材料结构三维有限元分析的材料参数

在调研现有文献复合材料结构三维数值分析中材料参数的基础上,阐述了基于单层板材料性能数据建立复合材料三维材料参数的方法.通过对复合材料π接头结构的三维数值模拟和试验,研究了三维材料参数中不确定参数对结构刚度预测的影响;分别采用三维修正的最大应力准则、最大应变准则、蔡-胡准则和Hashin准则评价π接头的初始破坏,结合试验数据,研究不同失效准则对复合材料π接头结构的适用范围以及材料参数对初始破坏强度预测的影响.研究工作可为一般层合复合材料结构的三维建模提供参考,并为深入理解复合材料π接头结构力学性能、准确预测其破坏强度提供理论支持.     

高速摄像三维图像分析技术与应用

高速摄像是光学测量的重要手段。分析了高速摄像三维图像分析技术的处理过程,重点讨论了像机标定、自动目标检测与跟踪技术、多目标匹配技术和三维姿态测量技术等关键环节所面临的问题及解决方法,并以无人机回收测量系统为例说明了高速摄像三维图像分析技术在无人机位姿参数测量中的应用,对构建高速摄像测量系统提供了参考。     

基于G2的卫星控制系统故障诊断的半物理仿真

研究一种基于G2的集故障注入、故障模拟和故障诊断为一体的半物理仿真系统,包括基于VxW orks的实时硬件模拟系统、星载姿轨控计算机、数管及遥控遥测模拟器和专用接口箱等.开发了基于G2的以某一类典型卫星控制系统为对象的故障诊断专家系统,并对G2外部接口进行了扩展设计.最后,以典型故障为例,在半物理仿真平台上进行了演示验证.     

“嫦娥二号”卫星L2点角动量管理

对“嫦娥二号”(CE-2)卫星进入环绕日地拉格朗日L2点的李萨如轨道后卫星喷气卸载所产生的影响进行了研究.提出了一种利用光压力矩辅助卫星太阳电池翼角度调整进行角动量管理的方法.在轨试验表明,太阳光压强度足够对飞行在L2点环绕轨道上的CE-2卫星进行角动量管理,可以大幅度减少动量轮在轨喷气卸载的次数,有利于CE-2卫星的轨道维持.     

Comparison of ionosphere characteristic parameters obtained by ionosonde with IRI-2007 model over Southeast Asia

In this work, the foF2 and hmF2 parameters at the conjugate points near the magnetic equator of Southeast Asia are studied and compared with the International Reference Ionosphere (IRI) model. Three ionosondes are installed nearly along the magnetic meridian of 100°E; one at the magnetic equator, namely Chumphon (10.72°N, 99.37°E, dip angle 3.0°N), and the other two at the magnetic conjugate points, namely Chiang Mai (18.76°N, 98.93°E, dip angle 12.7°N) and Kototabang (0.2°S, 100.30°E, dip angle 10.1°S). The monthly hourly medians of the foF2 and hmF2 parameters are calculated and compared with the predictions obtained from the IRI-2007 model from January 2004 to February 2007. Our results show that: the variations of foF2 and hmF2 predicted by the IRI-2007 model generally show the similar feature to the observed data. Both parameters generally show better agreement with the IRI predictions during daytime than during nighttime. For foF2, most of the results show that the IRI model overestimates the observed foF2 at the magnetic equator (Chumphon), underestimates at the northern crest (Chiang Mai) and is close to the measured ones at the southern crest of the EIA (Kototabang). For hmF2, the predicted hmF2 values are close to the hmF2(M3000F2_OBS) during daytime. During nighttime, the IRI model gives the underestimation at the magnetic equator and the overestimation at both EIA crests. The results are important for the future improvements of the IRI model for foF2 and hmF2 over Southeast Asia region.     

骨特异性转录因子Runx2对抗空间骨丢失效应的初步研究

为了构建稳定过表达Runx2 (骨特异性转录因子)的C2C12 (小鼠成肌细胞)和MG63 (前成骨细胞)细胞株, 并用于研究Runx2在对抗空间骨丢失效应中的作用. 利用实时定量聚合酶链式反应鉴定Runx2下游基因I型胶原、碱性磷酸酶表达情况, 在二维回转器中培养稳定细胞株, 通过定量聚合酶链式反应,观察在模拟失重效应下Runx2基因对其下游基因表达的影响. 结果表明, 通过筛选获得稳定转染的C2C12-Runx2和MG63-Runx2细胞株, 经鉴定都能过表达Runx2. 转染后的细胞 I 型胶原和碱性磷酸酶mRNA表达增高. 回转组与对照组相比, MG63, C2C12-Runx2, MG63-Runx2细胞的I型胶原和碱性磷酸酶mRNA表达降低, 但在模拟失重效应下, 转染细胞中I型胶原和碱性磷酸酶的mRNA表达下降程度明显低于未转染细胞株. 所构建的C2C12-Runx2和MG63-Runx2细胞株比较稳定, 并证实Runx2能部分对抗失重引起的成骨特异性分子的降低.