Study of maximum electron density NmF2 at Karachi and Islamabad during solar minimum (1996) and solar maximum (2000) and its comparison with IRI

The monthly hourly medians of maximum electron density, N_mF₂, at two Pakistani ionospheric stations, Karachi and Islamabad, have been determined for solar minimum (1996) and solar maximum (2000) and compared with IRI predictions using the URSI coefficients. At night and pre-noon period the N_mF₂ values at both stations are almost equal during the 2 years. However, at post-noon the values at Karachi are considerably larger than those at Islamabad due to the equatorial or geomagnetic anomaly. Karachi (geomag. coord. 16.44°N, 139.08°E) lies near the region of the equatorial anomaly (+20 and −20 geomagnetic latitude), so most of the N_mF₂ values at Karachi are larger than those at Islamabad (geomag. coord. 24.46°N, 145.67°E). The maximum monthly values of N_mF₂ show a semi-annual variation at Karachi and Islamabad both during 1996 and 2000 as predicted by IRI.     

The geomagnetic solar flare effect identified by SIIG as an indicator of a solar flare observed by GOES satellites

This paper studies the efficiency of geomagnetic solar flare effects (gsfe) in X solar flare detection; so during the period 1999–2007 a comparison between solar flare (sf) observed by satellites of the Geostationary Operational Environmental Satellite (GOES) programme and gsfe published by the Service International des Indices Geomagnetiques (SIIG) is made.     

梯度热障涂层的设计

 采用电子束物理气相沉积方法 (EB PVD)制备了梯度热障涂层,其结构设计为NiCoCrAlY粘结层 /Al₂O₃ YSZ过渡层 /YSZ陶瓷层。YSZ陶瓷层的结构为柱状晶结构,Al₂O₃ YSZ梯度过渡层为梯度微孔结构。采用有限元方法对梯度热障涂层进行热应力分析,优化了Al₂O₃ YSZ梯度过渡层的组成。计算结果表明,梯度涂层的内应力显著降低,而且界面及其附近应力和应变变化较平缓。过渡层厚度的增加有利于降低涂层内应力和缓和涂层界面处的应力集中。     

航空燃气涡轮冷气掺混流动损失的数值研究

采用理论分析的研究方法,对不同冷气掺混形式造成的涡轮气动性能的变化进行了数值计算研究。针对气膜冷却所造成的流动损失,采用修正的Ito等压混合模型;而针对尾缘冷气喷射所造成的流动损失,则采用了修正的Schoberi流动损失模型。对于不同的冷却方式,假定它们之间对主流造成的流动损失是相互独立。以某高压涡轮导向器作为研究对象,分析了各种冷气参数和几何参数对冷气掺混过程的影响规律。研究结果表明,涡轮叶片气冷过程引起的叶栅总压损失随冷气入射角度、吹气比、混合层厚度的变化而显著变化,通过优化设计可以使气冷过程造成的流动损失最小。     

Solar Irradiance Variability Since 1978

Since November 1978 a set of total solar irradiance (TSI) measurements from space is available, yielding a time series of more than 25 years. Presently, there are three TSI composites available, called PMOD, ACRIM and IRMB, which are all constructed from the same original data, but use different procedures to correct for sensitivity changes. The PMOD composite is the only one which also corrects the early HF data for degradation. The results from the detailed analysis of the VIRGO radiometry allow a good understanding of the effects influencing the long-term behaviour of classical radiometers in space. Thus, a re-analysis of the behaviour of HF/NIMBUS-7 and ACRIM-I/SMM was indicated. For the former the situation is complicated by the fact that there are no in-flight means to determine changes due to exposure to solar radiation by comparison with a less exposed radiometer on the same spacecraft. The geometry and optical property of the cavity of HF is, however, very similar to the PMO6-type radiometers, so the behaviour of the PMO6V radiometers on VIRGO can be used as a model. ACRIM-I had to be revised mainly due to a henceforth undetected early increase and a more detailed analysis of its degradation. The results are not only important for solar radiometry from space, but they also provide a more reliable TSI during cycle 21. The differences between the revised PMOD composite and the ACRIM and IRMB are discussed by comparison with a TSI reconstruction from Kitt-Peak magnetograms. As the PMOD composite is the only one which has reliable data for cycle 21, the behaviour of the three solar cycles can now be compared and the similarities and differences discussed.     

EB-PVD制备箔材的厚度均匀性研究

从真空蒸镀中使用的小平面蒸发源理论出发,针对电子束物理气相沉积中为改善箔材厚度分布所须旋转大基板进行蒸镀的情况,建立了该过程的数学模型;并利用该模型对不同的坩埚位置所沉积的箔材厚度进行了定性分析,从而实现了对坩埚与基板相对位置的优化,使基板上沉积的箔材厚度分布可以达到最均匀的状态.最后通过K值的提出使理论和实际箔材厚度的结果趋于一致,即证明所建立的数学模型是合理的.     

测量围护结构含水率的同面散射场式电容传感器设计

目前常用的测量含水率的方法有微波法、红外线法和电容法.由于基于电容法的传感器具有分辨力高、响应速度快、体积小、结构简单等优点,被广泛应用.针对围护结构含水率测试深度的要求和测试特点,本文通过仿真和实验,对同面电容传感器探头的结构尺寸进行了优化设计,并采取了保护电极以提高其抗干扰能力;运用改进的充放电电容检测电路,设计出一种测量围护结构含水率的新型同面散射场式电容传感器,该传感器具有宽范围的测试深度和较高的测试灵敏度.     

天线窗材料热透波特性风洞测试方法

高超声速飞行器天线窗材料在等离子体包覆条件下的热响应和热透波特性测试,是分析天线窗材料特性、研究电磁波在等离子体和天线窗中传输特性的基础。针对等离子体和天线窗中电磁波传输特性,采用矢量网络分析仪和标准增益天线组成的电磁波传输测试系统,获得了一定频率的电磁波经过等离子体和高温天线窗之后的衰减;针对高温天线窗自身热响应特性和电磁波在其中的传输特性,研究了天线窗材料在一定热流作用下的温度分布和烧蚀特性,测试了烧蚀后处于高温状态且无等离子体覆盖的天线窗对电磁波的影响,分析了天线窗高温透波特性与常温透波特性的差异。所建立的方法,为在地面等离子体风洞中开展天线窗热透波特性研究、分析天线窗和等离子体耦合作用对电磁波传输特性的影响建立了基础。     

全站仪检测数据管理系统

介绍了全站仪检测数据管理系统。本系统以FoxPro for Windows为基础,采用模块结构,具有对检测数据录入修改,自动转换,成果计算,查询显示等功能,实现了系统数据管理和处理的一体化。     

回流燃烧室流动特性试验

为了揭示有/无燃烧状态下燃烧室热态和冷态流场的特征和流动特性,针对某型回流燃烧室单头部试验件,使用粒子图像测速仪（PIV）,测量燃烧室燃烧状态下不同截面处的热态流场,以及没有燃烧状态下不同截面处的冷态流场,探讨不同总压损失系数对回流燃烧室热态/冷态流场特征及流动特性的影响。研究表明:随着总压损失系数的增大,冷态条件下各截面流场结构基本保持不变,如射流孔穿透深度、射流角度、回流区位置及大小、流线等基本保持一致,但是各位置点速度大小逐渐增大。热态条件下各截面流场随着总压损失系数增大,流场结构也基本保持不变;相同总压损失系数时,热态流场与冷态流场存在差异,燃油喷射与气流的相对运动将会对燃烧室头部的流场结构造成影响,速度较冷态流动时略微增大。