关于复合函数极限几个定理的探讨

本文对复合函数的极限做了细致的讨论，给出了6个定理。     

废气排放塔尾流区随机游动扩散模拟研究

本文对一种建筑结构与形式特异的废气排放源－过江隧道风井塔，进行了如下研究：（１）在环境风洞中通过风井塔后流场的测量，分析给出塔后尾流特征，并进行示踪气体扩散模拟试验和烟云照相；（２）在上述工作基础上，建立一个先进的随机游动扩散模式，模拟尾流区污染物扩散的基本规律，模式计算结果与实验结果吻合较好。建筑物的存在使得地面最大浓度增大３￣４倍，且出现位置离源更近。研究表明，随机游动方法研究对有明显湍流不均     

某起落架正常收／放系统失效原因分析

正确运用246雷达天线“正常或应急”液压操纵开关和液压马达壳体回油“正常或应急”开关的工作状态，关系到飞机液压操纵系统的安全性。若天线液压操纵开关和马达壳体回油开关配合不当，将引起飞机液压操纵系统失效。     

流动诱导空腔振荡及其声激励抑制的实验研究

实验研究了矩形空腔在外部高速气流作用下诱导的空腔内流支振荡问题，以及从空腔前缘加入纯音声激励以抑制空腔内流动振荡技术。实验发现，在一定的气流速度和空腔几何尺寸下，空腔内流动会出现强烈的自持振荡。采用前缘声激励，在某些声激励频率和适当强度下，通过控制腔口前缘剪切层的初期发展，可使原来处于振荡状态下空腔内的脉动压力级峰值降低１４ｄＢ以上，线性总声压级降低５ｄＢ。     

羊毛精纺织物服用性能优选的多属性模糊决策

本文应用多属性目标决策的方法,评判不同规格毛织面料的"满意度",客观地提供一个重要的优选辅助依据。     

钢筋砼条基及独立柱基有效高度的实用计算公式

为了便于广大工程实践人员对基础有效高度的确定，根据规范GB50010－2002及GB50007－2002推导求解出基础有效高度的实用计算公式及计算表格。     

人工释能法求解线性代数方程组

本文建立求解线性代数方程组的人工释能法迭代格式,并给出该迭代格式收敛的充分必要条件和最佳释能时机,同时给出实现人工释能法的数值计算方法及其数值稳定性条件。     

燃烧室头部进气规律对煤粉燃烧效率的影响

用实验方法研究了火焰筒式煤粉燃烧室头部进气规律对燃烧效率的影响。通过对6种结构的头部配气方案的分析比较,得出了煤粉燃烧室合理的头部配气方案,为今后煤粉燃烧室的设计和工作状态的选择提供了重要的实验依据。     

Study of GNSS-measured ionospheric total electron content variations generated by powerful HF-heating

The purpose of this work is to report the experimental evidences for the influence of perturbations in the electron density in the dayside mid-latitude ionosphere, that are caused by high-frequency heating of the F2 layer, on the GNSS signals. The experiments were carried out at the Sura heater (Radio Physical Research Institute, N. Novgorod). During the sessions of ionospheric heating with different time modulations of the radiated power the rays linking the navigational satellites with the ground receiver intersected the heated region. Variations in the total electron content (TEC) were studied; these variations are proportional to the reduced phases of navigational signals. It is shown that with the square-wave modulation of the radiated power (with periods of 1, 6, 10 and 15 min), perturbations with periods of the main modulation of heating and its harmonics appear in the spectrum of TEC variations. Examples are presented of identification of the heating-induced variations in TEC, including determination of the amplitudes and time characteristics of these variations.     

Aerodynamic performance enhancement for flapping airfoils by co-flow jet

Introducing active flow control into the design of flapping wing is an effective way to enhance its aerodynamic performance. In this paper, a novel active flow control technology called Co-Flow Jet (CFJ) is applied to flapping airfoils. The effect of CFJ on aerodynamic performance of flapping airfoils at low Reynolds number is numerically investigated using Unsteady Reynolds Averaged Navier-Stokes (URANS) simulation with Spalart-Allmaras (SA) turbulence model. Numerical methods are validated by a NACA6415-based CFJ airfoil case and a S809 pitching airfoil case. Then NACA6415 baseline airfoil and NACA6415-based CFJ airfoil with jet-off and jet-on are simulated in flapping motion, with Reynolds number 70,000 and reduced frequency 0.2. As a result, CFJ airfoils with jet-on generally have better lift and thrust characteristics than baseline airfoils and jet-off airfoil when C_μ is greater than 0.04, which results from the CFJ effect of reducing flow separation by injecting high-energy fluid into boundary layer. Besides, typical kinematic and geometric parameters, including the reduced frequency and the positions of the suction and injection slot, are systematically studied to figure out their influence on aerodynamic performance of the CFJ airfoil. And a variable C_μ jet control strategy is proposed to further improve effective propulsive efficiency. Compared with using constant C_μ, an increase of effective propulsive efficiency by 22.6% has been achieved by using prescribed variable C_μ for NACA6415-based CFJ airfoil at frequency 0.2. This study may provide some guidance to performance enhancement for Flapping wing Micro Air Vehicles (FMAV).