非线性系统的可控正则型和状态变换的求法

Zeitz引入了非线性控制系统的可控正则型,证明了由可控正则型描述的非线性系统是可控的,本文进一步给出了非线性系统正则化的条件和状态变换的算法,从而解决了通过状态变换证明非线性系统的可控性。     

压缩空气瓶内凝结水水位检测方法的探讨

由于压缩空气瓶在使用过程中会出现瓶内残留凝结水的现象,从而影响压缩空气瓶的容积,并产生化学腐蚀,影响气瓶的整体强度和耐压性能及其的寿命。为此,应掌握气瓶内凝结水水位情况,并且提高检测水位准确度。提出了一种利用气体状态方程来计算压缩空气瓶的冷凝水水位新见解,对压缩空气瓶的安全使用具有重要意义。     

某型涡轮螺桨发动机转子偏磨故障分析

 某型涡轮螺桨发动机曾发生过多起转子偏磨故障,工厂对此作过许多分析,本文在其基础上再对该项故障的原因和机理结合实际地作了进一步的比较、分析和论证,提出了排故措施。效果显著。     

Galileo real-time orbit determination with multi-frequency raw observations

Real-time GNSS-based applications require corresponding real-time orbit products. While traditional GNSS orbits are generated with the dual-frequency IF (Ionosphere-Free) model, the increase of multi-frequency signal satellites brings new challenges for the data processing. Therefore, real-time orbit determination with the multi-frequency UC (Uncombined) model is introduced in this study considering its flexibility. With the derived mathematical model conforming to IGS (International GNSS Service) dual-frequency clock definition and one-week triple-frequency Galileo observation data from 90 IGS network stations, the convergence and accuracy of real-time orbits is assessed and the characteristics of satellite IFCB (Inter-Frequency Clock Bias) are analyzed. Results indicate that the model differences, including dual-frequency IF model, dual-frequency UC model and triple-frequency UC model, contribute to only cm-level differences with CODE (Center for Orbit Determination in Europe) final orbits after a convergence time of around 12 h. The constellation-mean RMS (Root Mean Square) differences of the converged real-time orbits with the CODE final orbits reaches about 5.0 cm, 7.0 cm and 5.0 cm for the radial, tangential and normal directions. The convergence of satellite IFCB is much faster than that of satellite orbit, which reflects a loose correlation between these two parameters. While the Galileo satellite IFCB are temporally stable, the modeling of satellite IFCB may be unreliable when over constrained and becomes even more unstable with commonly encountered datum changes. In summary, real-time GNSS orbit determination with multi-frequency raw observations is feasible and extendable with proper treatment of IFCB.     

Convex optimisation approach to constrained fuel optimal control of spacecraft in close relative motion

This paper describes an interesting and powerful approach to the constrained fuel-optimal control of spacecraft in close relative motion. The proposed approach is well suited for problems under linear dynamic equations, therefore perfectly fitting to the case of spacecraft flying in close relative motion. If the solution of the optimisation is approximated as a polynomial with respect to the time variable, then the problem can be approached with a technique developed in the control engineering community, known as “Sum Of Squares” (SOS), and the constraints can be reduced to bounds on the polynomials. Such a technique allows rewriting polynomial bounding problems in the form of convex optimisation problems, at the cost of a certain amount of conservatism. The principles of the techniques are explained and some application related to spacecraft flying in close relative motion are shown.     

A direct position determination method with combined TDOA and FDOA based on particle filter

The localization of a stationary transmitter using moving receivers is considered. The original Direct Position Determination (DPD) methods, with combined Time Difference of Arrival (TDOA) and Frequency Difference of Arrival (FDOA), do not perform well under low Signal-to-Noise Ratio (SNR), and worse still, the computation cost is difficult to accept when the computational capabilities are limited. To get better positioning performance, we present a new DPD algorithm that proves to be more computationally efficient and more precise for weak signals than the conventional approach. The algorithm partitions the signal received with the same receiver into multiple non-overlapping short-time signal segments, and then uses the TDOA, the FDOA and the coherency among the short-time signals to locate the target. The fast maximum likelihood estimation, one iterative method based on particle filter, is designed to solve the problem of high computation load. A secondary but important result is a derivation of closed-form expressions of the Cramer-Rao Lower Bound (CRLB). The simulation results show that the algorithm proposed in this paper outperforms the traditional DPD algorithms with more accurate results and higher computational efficiency, and especially at low SNR, it is more close to the CRLB.     

A fast arc fault detection method for AC solid state power controllers in MEA

Arc fault detection is desperately required in Solid State Power Controllers (SSPC) in addition to their fundamental functions because arcs will provoke growing harm and threat to aircraft safety. Experimental study has been done to obtain the faulted current data. In order to improve the detection speed and accuracy, two fast arc fault detection methods have been proposed in this paper with the analysis of only half cycle data. Both Fast Fourier Transform (FFT) and Wavelet Packets Decomposition (WPD) have been adopted to distinguish arc fault currents from normal operation currents. Analysis results show that Alternating Current (AC) arcs can be effectively and accurately detected with the proposed half cycle data based methods. Moreover, experimental verification results have also been provided.     

去中心化时差频差直接定位方法

针对原始利用时差频差的直接定位(DPD)方法存在数据传输量和计算量大的瓶颈,提出了两种去中心化直接定位方法。第1种方法采用去中心化配对方案,只将各观测站截获信号在站间进行一次传输,将数据传输和计算分散到各观测站间并行计算互模糊函数(CAF),构造仅满足满秩条件的互模糊矩阵(CAM)。第2种方法根据推导的任意互模糊函数间关系公式,采用归约方式去中心化的在各观测站并行计算余下互模糊函数,补全互模糊矩阵。两种方法都降低了直接定位数据传输量,提高了计算效率。性能分析和仿真实验表明本文两种方法精度性能优于两步定位方法,在低信噪比时两种方法都可达到比较理想的精度性能,在高信噪比时第2种方法与原始直接定位方法的精度性能相当。     

High-resolution simulation for rotorcraft aerodynamics in hovering and vertical descending flight using a hybrid method

A high-resolution simulation tool for rotorcraft aerodynamics is developed by coupling CFD with a Vorticity Transport Model (VTM). An Eulerian-based CFD module is used to model the blade near body flowfield, and a Lagrangian-based VTM module is employed for vortex tracking in the far wake. The coupling procedure is implemented by transmitting vortex sources to the VTM module and feeding boundary conditions back to the CFD module. The presented CFD/VTM hybrid solver is firstly validated by hover cases of three different rotor configurations. Simulation results, including the blade surface pressure distribution, rotor downwash, and hover figure of merit, exhibit favorable correlations with available experimental data. Then, a rotor operated in vertical descending flight with a fixed collective pitch is investigated. It is shown that the CFD/VTM coupling method is suitable for rotor wake simulation. Wake instabilities (far wake breakdown in hover and toroidal wake pattern in the vortex ring state) are successfully demonstrated with a moderate computational cost.     

Implementation and performance analysis of accurate localization of short-range targets based on multisensor systems

Ｉｎｒｅｃｅｎｔｙｅａｒｓ，ｗｉｔｈｔｈｅａｐｐｅａｒａｎｃｅｏｆｐｒｅ－ｃｉｓｉｏｎ－ｇｕｉｄｅｄｗｅａｐｏｎｓ，ｔｈｅｄｅｆｅｎｓｅｓｙｓｔｅｍｆｏｒｉｍｐｏｒｔａｎｔａｐｐａｒａｔｕｓｈａｓｅｎｃｏｕｎｔｅｒｅｄｎｅｗｄｉｆｉ－ｃｕｌｔｙ．Ｉｆ...