Modeling of sub-ionospheric VLF signal perturbations associated with total solar eclipse, 2009 in Indian subcontinent

During the total solar eclipse of 2009, a week-long campaign was conducted in the Indian sub-continent to study the low-latitude D-region ionosphere using the very low frequency (VLF) signal from the Indian Navy transmitter (call sign: VTX3) operating at 18.2 kHz. It was observed that in several places, the signal amplitude is enhanced while in other places the amplitude is reduced. We simulated the observational results using the well known Long Wavelength Propagation Capability (LWPC) code. As a first order approximation, the ionospheric parameters were assumed to vary according to the degree of solar obscuration on the way to the receivers. This automatically brought in non-uniformity of the ionospheric parameters along the propagation paths. We find that an assumption of 4 km increase of lower ionospheric height for places going through totality in the propagation path simulate the observations very well at Kathmandu and Raiganj. We find an increase of the height parameter by h^′=+3.0$h^{\prime }=+3.0$ km for the VTX-Malda path and h^′=+1.8$h^{\prime }=+1.8$ km for the VTX-Kolkata path. We also present, as an example, the altitude variation of electron number density throughout the eclipse time at Raiganj.     

Directional Filtering Due to Mesospheric Wind Shear on the Propagation of Acoustic-gravity Waves

Gravity waves with periods close to the Brunt-V?is?l? period of the upper troposphere are often observed at mesopause altitudes as short period, quasi-monochromatic waves. The assumption that these short period waves originate in the troposphere may be problematic because their upward propagation to the mesosphere and lower thermosphere region could be significantly impeded due to an extended region of strong evanescence above the stratopause. To reconcile this apparent paradox, an alternative explanation is proposed in this paper. The inclusion of mean winds and their vertical shears is sufficient to allow certain short period waves to remain internal above the stratopause and to propagate efficiently to higher altitudes. A time-dependent numerical model is used to demonstrate the feasibility of this and to determine the circumstances under which the mesospheric wind shears play a role in the removal and directional filtering of short period gravity waves. Finally this paper concludes that the combination of the height-dependent mean winds and the mean temperature structure probably explains the existence of short period, quasi-monochromatic structures observed in airglow images of mesopause region.      

空间对称型二次反射太阳能聚集系统能量传输特性

聚光光伏系统的聚光比和聚集太阳能流密度分布的均匀性是评价其性能的重要指标,基于几何光学原理,建立了对称型二次反射聚集系统的数学物理模型,理论分析了偏轴聚集器倾角、二次斜面倾角等聚光系统的结构参数对能流密度均匀性和聚光比的影响,提出了优势参数组合;并采用射线踪迹蒙特卡罗法(MCRTM)对太阳光的聚集传输过程进行模拟,分析了接收面的能流密度分布特性。结果表明,对称型二次反射聚集系统在偏轴抛物面倾角、二次斜面倾角以及接收面高度参数的适当组合之下,聚光比适中,能流分布均匀,适宜用于空间聚光光伏发电。     

非相干雷达探测低电离层的结果分析

位于波多黎各的Arecibo非相干雷达可以获得低电离层电子和离子密度, 利用此非相干雷达数据对中纬度低电离层的运动特征进行研究. 得到了电子密度随时间和高度的变化 情况, 结果显著呈现出周日变化特征, 并分析了电子密度随高度的变化规律. 进一步对数据进行频谱分析, 深入研究低电离层电子密度的周日变化效应. 得到电子密度的高度剖面, 发现从F层底部到E层有明显的等离子体沉降. 低电离层的层结构特征及电子密度变化表明, 在该区域还存在不同程度的等离子体扰动, 由此对低电离层的作用因素 进行分析, 认为大气潮汐或声重波可能对低电离层产生扰动, 即低电离层与大气存在一定程度的耦合作用.      

非等强度多道冲击波作用下空泡溃灭机制分析

航空航天、生物医学等领域均存在冲击波与空泡作用问题,冲击波尤其是多道冲击波作用下空泡溃灭包含着复杂的多相瞬变行为与物理现象。基于自主搭建的可压缩多相流并行数值平台,对液体中单一/多道冲击波与空泡的作用过程进行了数值模拟。通过对冲击波作用下空泡内波系性质,以及多道冲击波与空泡作用后的系列反射波系在液体中的相互作用过程进行详细解析,分析了不同冲击波作用下空泡的形变演化过程,探究了空泡的溃灭机制与特性。研究发现,相较于单一冲击波的作用,多道冲击波作用下空泡内部及周围液体流场中的波系结构更为复杂,然而无论是单一冲击波或是多道冲击波工况,其最终诱发的空泡溃灭形态均十分相似。而且,当空泡发生溃灭前所受到多道冲击波的总强度与单一冲击波强度相等时,空泡的溃灭波强度也十分相近,为多道冲击波与空泡作用效果的定量化评估提供了理论基础和依据。     

Nonlinear electron-acoustic rogue waves in electron-beam plasma system with non-thermal hot electrons

The properties of nonlinear electron-acoustic rogue waves have been investigated in an unmagnetized collisionless four-component plasma system consisting of a cold electron fluid, non-thermal hot electrons obeying a non-thermal distribution, an electron beam and stationary ions. It is found that the basic set of fluid equations is reduced to a nonlinear Schrodinger equation. The dependence of rogue wave profiles on the electron beam and energetic population parameter are discussed. The results of the present investigation may be applicable in auroral zone plasma.     

进口斜激波、膨胀波干扰下等直隔离段内的激波串特性

 超燃冲压发动机的隔离段在实际工作中会受到进气道唇罩激波及肩部膨胀扇的显著干扰,本文针对这一特定问题进行了专门研究。提出了唇罩入射激波及肩部膨胀扇的模拟方法,并利用德国Achen的风洞试验对其进行了检验,而后以此研究了入射激波及肩部膨胀扇干扰下隔离段内激波串的基本形态,并分析了出口反压和激波入射位置的影响。仿真结果表明：当激波串在隔离段内不断前移时,受唇罩入射激波及其反射激波的干扰,其高速核心区交替地偏向上下壁面;与无激波入射的情况相比,此时激波串的耐反压能力显著降低,且入射点位置越高,降低幅度越大,管道内的沿程静压分布规律与Waltrup经验公式偏离程度也越来越大。该文结果可为进气道/隔离段的一体化设计提供依据。     

Oscillatory thermocapillary flows in simulated floating-zones with time-dependent temperature boundary conditions

This study deals with numerical simulations of the Maxus sounding rocket experiment on oscillatory Marangoni convection in liquid bridges. The problem is investigated through direct numerical solution of the non-linear, time-dependent, three-dimensional Navier-Stokes equations. In particular, a liquid bridge of silicon oil 2[cs] with a length L = 20 [mm] and a diameter D = 20 (mm) is considered. A temperature difference ΔT = 30 [K] is imposed between the supporting disks, by heating the top disk and cooling the bottom one with different rates of ramping. The results show that the oscillatory flow starts as an ‘axially running wave’, but after a transient time the instability is described by the dynamic model of a ‘standing wave’, with an azimuthal spatial distribution corresponding to m = 1 (where m is the critical wave number). After the transition, the disturbances become larger and the azimuthal velocity plays a more important role and the oscillatory field is characterized by a travelling wave. The characteristic times for the onset of the different flow regimes are computed for different rates of ramping.     

WEIGHTED COMPACT SCHEME FOR SHOCK CAPTURING

INTRODUCTIONRecently compact schemes have been widelyused in the simulation of complex flows,espe-cially in the directnumerical simulation of turbu-lent flows[1～ 2 ] . Standard finite differenceschemes have explicit forms and need to be atleastone pointwider than the desired approxima-tion order. It is also difficult to find suitable andstable boundary closure for high order schemes.Compared to the standard finite difference ap-proximations,the compact schemes can achievehigher order acc…     

Feedback control of boundary layer Tollmien-Schlichting waves using a simple model-based controller

The attenuation of spatially evolving instability Tollmien-Schlichting (T-S) waves in the boundary layer of a flat plate with zero pressure gradients using an active feedback control scheme is theoretically and numerically investigated. The boundary layer is excited artificially by various perturbations to create a three-dimensional field of instability waves. Arrays of actuators and sensors are distributed locally at the wall surface and connected together via a feedback controller. The key elements of this feedback control are the determination of the dynamic model of the flat plate boundary layer between the actuators and the sensors, and the design of the model-based feedback controller. The dynamic model is established based on the linear stability calculation which simulates the three-dimensional input-output behaviour of the boundary layer. To simplify the control problem, an uncoupled control mode of the dynamic model is made to capture only those dynamics that have greatest influences on the input-output behaviour. A Proportional-Integral-Derivative (PID) controller, i.e. a lead-lag compensator, combining with a standard Smith predictor is designed based on the system stability criterion and the specifications using frequency-response methods. Good performance of the feedback control with the uncoupled control mode is demonstrated by the large reduction of the three-dimensional disturbances in the boundary layer. This simple feedback control is realistic and competitive in a practical implementation of T-S wave cancellation using a limited number of localised sensors and actuators.