0.3 m低温风洞液氮供给系统研制

基于系统级的一维热流体模拟分析,建立了适用于研究分析0.3 m低温风洞液氮供给系统的数学模型,并开展了系统漏热、两相流及缓冲罐中液氮容积等流体动力学分析;在系统现有控制策略及试验数据的基础上,基于该数学模型开展了系统压力动态响应分析,获得了在阀门动态调节过程中管网压力的瞬态响应,计算结果与试验值的总体误差控制在10%以内。喷射压力一致化改造避免了阀间干扰,添加的回流管道消除了供给末端的两相流现象,使喷射压力控制精度达到1.1%,调节时间减少到23 s,实现了风洞总温快速安全调节和精确控制。     

应用GPS载波确定载体姿态

本文简述了利用GPS载波相位技术进行载体姿态确定的原理，比较了目前已有的多种整周模糊度求解算法，选用最小二乘法进行了载体定姿实践，减少了备选整周模糊度的组合数，并采用多种约束信息来剔除不正确的模糊度组合，结合实验，指出了载体姿态变化和整周模糊度搜索速度的关系，提出了一种模糊度确定的辅助方法，并给出了应用算例。     

二维三角晶格的Peierls相变前后的声子色散曲面的研究

利用晶格动力学理论计算了二维三角晶格的Peierls相变前后的声子能谱。并且在第一布里渊区绘制了声子色散曲面。通过对Peierls相变前后的声子能谱比较可知，随其对称性降低，声子能谱的简并度被破缺。二维三角晶格的Peierls相变前只有两支声频支声子能谱，Peierls相变后有两支声频支声子能谱与两支光频支声子能谱，并且声频支声子能谱与光频支声子能谱不相交，两支光频支声子沿ky轴平缓地变化。     

运动单站干涉仪相位差直接定位方法

针对传统干涉仪测向定位在低信噪比(SNR)下性能降低、多频段系统复杂等缺点,本文直接利用运动单站干涉仪模糊相位差(PD)实现对地面静止辐射源定位.为解决该定位问题,结合干涉仪相位差的几何特性,提出了一种多角度距离参数化高斯和滤波(MB-RP-GMF)定位解算方法,利用相位差误差检测获得多个初始方位角,通过距离参数化得到一组滤波初始值,采用扩展卡尔曼滤波(EKF)进行定位计算.仿真结果表明,该定位方法在低信噪比下优于仅测向(BO)定位,且仅采用一组干涉仪便可对多个频段辐射源进行定位.     

不同频率及相转移催化剂条件下的安息香缩合反应

本文介绍了在不同频率超声波及不同相转移催化剂条件下对安息香缩合反应的影响,实验发现,超声波的频率对安息香的收率有一定程度的影响,收率随着超声波频率的增加而增加。在选择的三种相转移催化剂中,采用苄基三乙基溴化铵效果最好,安息香的收率最高。     

A closed-form solution for moving source localization using LBI changing rate of phase difference only

Due to the deficiencies in the conventional multiple-receiver localization systems based on direction of arrival(DOA) such as system complexity of interferometer or array and amplitude/phase unbalance between multiple receiving channels and constraint on antenna configuration,a new radiated source localization method using the changing rate of phase difference(CRPD)measured by a long baseline interferometer(LBI) only is studied. To solve the strictly nonlinear problem, a two-stage closed-form solution is proposed. In the first stage, the DOA and its changing rate are estimated from the CRPD of each observer by the pseudolinear least square(PLS) method,and then in the second stage, the source position and velocity are found by another PLS minimization. The bias of the algorithm caused by the correlation between the measurement matrix and the noise in the second stage is analyzed. To reduce this bias, an instrumental variable(IV) method is derived. A weighted IV estimator is given in order to reduce the estimation variance. The proposed method does not need any initial guess and the computation is small. The Cramer–Rao lower bound(CRLB) and mean square error(MSE) are also analyzed. Simulation results show that the proposed method can be close to the CRLB with moderate Gaussian measurement noise.     

激波聚焦诱导气液两相爆震燃烧的数值模拟

对以激波聚焦和增加障碍物方式诱导煤油-空气气液两相爆震燃烧的过程进行了数值模拟.采用欧拉-拉格朗日方法建立了脉冲爆震发动机(PDE)中气液两相流的喷射、雾化、掺混过程.研究发现环形爆震波在爆震管凹腔内经过反射、汇聚后能够引燃可燃混合物.而在障碍物处,激波的反射和再反射聚焦能够形成高温高压点(2700K,25MPa),产生局部爆炸,有助于形成稳定的脉冲爆震燃烧(波面速度为1900m/s,温度为2 950K),有效地缩短由缓燃向爆震转变(DDT)距离至0.45m.     

含噪信号经验模式分解虚假分量识别方法

针对含噪信号Hilbert-Huang变换存在虚假分量,提出改进的奇异值分解(SVD)方法进行降噪,改进包含两个部分:一是利用重构相空间代替传统矩阵如Hankel矩阵,以去掉信号冗余,再者提出奇异值能量熵分量差分法,更易于定出重构奇异值阶次;二是提出了频谱比值法对虚假分量进行辨识,更有效辨识出虚假分量.首先利用经验模式分解(EMD)得到本征模式分量(IMF),识别并剔除趋势项,重构信号,然后进行SVD,重构降噪后的信号,消除虚假分量,最后进行时频分析.联合方法应用于含噪仿真信号,信噪比(signal noise ratio,SNR)提高了5.5%,虚假分量辨识率提高至100%,用于双跨转子故障振动信号,得到正确的时频结果,表明了所提方法识别含噪信号虚假分量的有效性.     

交会对接寻的段水平双脉冲交会轨道精确求解

基于考虑摄动影响的精确轨道动力学模型,对交会对接寻的段水平双脉冲交会轨道的精确求解方法进行了研究。提出了将控制脉冲的俯仰角近似转化为控制时刻的轨道幅角,从而调整脉冲控制时刻以消除径向速度增量的方法,精确求解首末水平双脉冲的启控时刻;引入导引终点位置偏差的比例控制方法,精确求解水平双脉冲的精确控制量。仿真结果表明,2轮整体迭代可获得首末水平脉冲控制时刻和控制量的精确值,脉冲水平特性达到俯仰角小于1°,导引终点相对位置精度达到10m,验证了该方法的正确性。     

Assessing the feasibility of involving gaseous products resulting from physicochemical oxidation of human liquid and solid wastes in the cycling of a bio-technical life support system

The study addresses the possible ways of involving gaseous products produced by “wet” incineration of human wastes mixed with H₂O₂ in an alternating electric field in the cycling of the physical model of a bio-technical life support system (BTLSS). The resulting gas mixture contains CO₂ and O₂, which are easily involved in the cycling in the closed ecosystem, and NH₃, which is unacceptable in the atmosphere of the BTLSS. NH₃ fixation has been proposed, which is followed by nitrification and involvement of the resulting products in the mass exchange of the closed system. Experiments have been performed to show that plants can be grown in the atmosphere resulting from the closing of the gas loop that includes a physicochemical installation and a growth chamber with plants representing the phototrophic compartment of the BTLSS. The results of the study suggest the conclusion that the proposed method of organic waste oxidation can be a useful tool in creating a physical model of a closed-loop integrated BTLSS.