The characteristics of sharp (small-scale) boundaries of solar wind plasma and magnetic field structures

We investigate properties of large (>20%) and sharp (<10 min) solar wind ion flux changes using INTERBALL-1 and WIND plasma and magnetic field measurements from 1996 to 1999. These ion flux changes are the boundaries of small-scale and middle-scale solar wind structures. We describe the behavior of the solar wind velocity, temperature and interplanetary magnetic field (IMF) during these sudden flux changes. Many of the largest ion flux changes occur during periods when the solar wind velocity is nearly constant, so these are mainly plasma density changes. The IMF magnitude and direction changes at these events can be either large or small. For about 55% of the ion flux changes, the sum of the thermal and magnetic pressure are in balance across the boundary. In many of the other cases, the thermal pressure change is significantly more than the magnetic pressure change. We also attempted to classify the types of discontinuities observed.     

实测载荷谱数据处理系统

简要介绍了实测载荷谱数据处理系统，较深入地论述了实测载荷谱数据处理的几个重要方面，给出了该系统处理直升机旋翼系统动部件实测载荷谱的实例，通过大子样二维疲劳２载荷母体分布参数估计及假设检验，发现载荷幅值服从半正态分布，载荷均值服从三参数Ｗｅｉｂｕｌｌ分布。     

Time-series analysis of GPS measurements for long-span bridge movements using wavelet and model prediction techniques

This study aims at assessing the safety behavior of the Incheon long-span bridge using high rate (10?Hz) geodetic monitoring global positioning system (GPS). The time series of wavelet spectrum analysis is utilized to assess the dynamic behavior of the bridge. The coefficients and model errors of the time series autoregressive-moving average (ARMA) model are used to evaluate the movement performances of the bridge. The results show that: (i) the accuracy of GPS measurements to extract the dynamic behavior of the bridge is 97.27% when compared with the design results. (ii) the behavior of the bridge is within the safety limits of the bridge design with minimum observed changes for the historical GPS measurements in time and frequency domains, the mean deflection of bridge deck is 8.26?mm and frequency changes of bridge is 0.004?Hz compared with the design results. (iii) the time series analysis of the wavelet spectrum and ARMA model coefficients can be used to detect the significant frequency changes and study the rigidity of the bridge performance, respectively; and the both methods are found to be suitable techniques to estimate the performance changes of the GPS measurements in the time and frequency domains during the monitoring time period.     

DME脉冲调制信号波形参数对空间频谱占用的影响分析

航空测距器DME的开发、调试和性能验证都要用到高斯双脉冲调制格式的DME信号。由于专用的DME信号模拟器技术复杂、价格昂贵,人们常用具有快沿双脉冲调制功能的模拟信号源替代。本文以航空测距器DME信号要求为依据,初步分析了这种替代可能存在的问题,并通过实验对不同边沿条件下高斯双脉冲、矩形双脉冲调制信号的功率频谱占用情况进行了验证。     

热处理对FeCo-2V-0.5Cr软磁合金力学与磁学性能的影响

针对FeCo-2V-0.5Cr软磁合金,研究了真空热处理时间对其微观组织结构、力学与磁学性能的影响规律,发现在800℃下热处理时间为2h左右时,合金的抗拉强度和延伸率达到最佳,同时仍保持良好的软磁性能,抗拉强度、延伸率以及矫顽力分别为867.8MPa、10.4%以及2.0Oe。进一步对该合金进行附加磁场下的真空热处理,重点研究了合金的交流损耗与矫顽力随附加磁场方式包括磁场撤除温度与磁场下保温时间的变化规律,发现适当的磁场热处理对合金相关力学性能影响不大,但由于合金中产生了单轴各向异性而使合金矫顽力进一步降至1.6Oe。     

无人机高速DS/FH混合扩频通信系统关键模块设计

针对UAV(Unmanned Aerial Vehicle,无人机)测控链路高抗干扰需求,给出了实现跳频速率20 000次/s的扩跳混合无人机测控数据链系统实现方案.系统采用跳频频率并行捕获模式.跳频源设计采用直接频率合成、DDS(Direct Digital Synthesis,直接数字频率合成)和PLL (Phase-Locked Loop,锁相环)相结合的混合频率合成技术.利用相位响应滤波器,通过正交调制技术完成MSK(Minimum Shift Keying,最小频移键控)、GMSK (GaussianMinimum Shift Keying,高斯最小频移键控)调制.通过推导得出2 bit差分解调输出与载波频率选择有关,且为四分之数据率的整数倍关系.然后通过实例分析给出了跳频频率间隔选取方法,即跳频间隔应当将临近跳频的主瓣分开,同时跳频载波频率应当设在其他跳频频谱的零点处.最后总结了高速扩跳频系统参数设计一般步骤.     

飞机发动机混沌振动信号盲分离检测方法

发动机混沌振动信号携带着丰富的状态信息,依据混沌振动信号进行状态监测及故障诊断是一种很有前途的技术手段,但由于混沌信号具有伪随机特性及在低频段具有宽频谱等特点,使得传统的方法很难将其从振动信号中分离。在提取混沌振动信号方面,使用快速独立分量分析（Fast ICA）盲分离方法分离出飞机发动机振动信号中的混沌信号。利用功率谱和Lyapunov指数（LE）方法进行了判定,根据计算结果对发动机状态做出判断,验证了盲分离方法分离混沌振动信号的有效。盲分离检测混沌振动信号的方法不仅使依据混沌信号判断飞机发动机状态成为可能,也为利用混沌信号进行状态预测和控制提供了一种方法。     

纸基蜂窝模块化固持方法研究

 基于磁场与摩擦学蜂窝芯材料固持原理,提出复杂型面纸基蜂窝零件固持平台的模块化设计思想。运用移动模块、固定模块、模块夹具以及导磁体和隔磁体解决了该原理中磁路控制问题,实现了复杂曲面零件在模块化固持平台上的加工固持。通过理论分析和有限元仿真研究了固持系统中蜂窝孔格的受力,分析了固持系统的特点和可靠性,以及永磁体厚度、固定平台高度、铁粉填充高度和平台间隙对磁场力的影响规律。实验与仿真结果表明,模块化固持平台能够满足复杂曲面蜂窝铣削加工的固持要求。     

遥感图像的亚像素配准技术研究

高分辨遥感技术在军民领域应用广泛,图像配准技术是高分辨遥感图像的预处理技术。实际的机载和星载遥感成像仪,由于自身成像原理和成像仪平台抖动原因,出现了遥感图像亚像素偏移误差。对亚像素图像配准技术进行系统研究,对高精度亚像素配准算法进行研究分析,并对其算法进行仿真、处理,对仿真的结果进行系统分析,通过误差分析提出配准误差修正算法,修正算法对亚像素配准进行了很好的改进,达到遥感图像预处理的目的。     

弹用S弯进气道气动性能试验

对一种弹用S弯进气道进行了试验,结果表明:①偏航角一定,攻角由负到正变化时,总压恢复系数先上升后变化不大,|DC₆₀|则先下降后小幅升高;②攻角一定,总压恢复系数和|DC₆₀|随偏航角的增加均呈先升高后降低的趋势;③大的攻角和偏航角组合状态下,总压恢复系数较低,|DC₆₀|偏大,但随偏航角进一步增大,进气道性能有所改善;④进/发匹配点处,进气道出口压力功率频谱较平坦且对姿态角和来流马赫数的变化均不敏感;⑤发动机小流量状态时,进气道模型发生了喘振,频率约为150 Hz.