Evaluation and analysis on positioning performance of BDS/QZSS satellite navigation systems in Asian-Pacific region

By using the observation data and products of precise obit and clock offset from Multi-GNSS Experiment (MGEX) of the International GNSS Service (IGS) and GNSS Research Centre, Curtin University in this paper, the positioning performance of BDS/QZSS satellite navigation system has been analyzed and evaluated in aspects of the quantity of visible satellites, DOP value, multipath effect, signal-to-noise ratio, static PPP and kinematic PPP. The analysis results show that compared to BDS single system when the cutoff angle are 30°and 40°, the DOP value of BDS/QZSS combined system has decreased above 20%, and the quantity of visible satellites increased about 16–30% respectively, because of the improved spatial geometric configuration. The magnitude of satellite multipath effect of BDS system shows the trend of MEO?>?IGSO?>?GEO, which is consistent with that of QZSS satellite system, as the constellation structure of the two systems is similar. The variation tendencies of signal-to-noise ratio with respect to elevation angle of the two systems are almost the same at all frequencies, showing that at the same elevation angle the signal-to-noise ratio of MEO satellites is higher than that of IGSO satellites, as the higher obit is the lower transmitting power is obtained. For having a specially designed obit, the variation of signal-to-noise ratio of BDS system is more stable. However, the magnitude of signal-to-noise ratio of QZSS system appears the trend of frequency 3?>?frequency 2?>?frequency 1. The static PPP performance of the BDS/QZSS combination system has been improved more significantly than the BDS single system in E, N and U directions. When the cutoff angle are at 7°, 15° and 30°, the PPP accuracy is increased about 25–34% in U direction, 10–13% and 23–34% in E and N directions respectively. When the elevation angle is large (40°), compared to BDS single system at lower elevation angles (7° and 15°) the PPP accuracy of the BDS/QZSS combination system is improved above 30% in U direction. In kinematic PPP performance, compared to BDS single system, the accuracy, availability and reliability of the BDS/QZSS combination system has been improved too, especially at large elevation angles (30° and 40°), the kinematic PPP accuracy in E and U directions has been improved about 10–50%, and above 50% in U direction. It can be concluded that the combination with QZSS system can improve the positioning accuracy, reliability and stability of BDS system. In the future, with the improvement of the satellite construction of Japan’s QZSS system and the global networking of China’s BDS satellites, the QZSS satellites will contribute greatly to improve the positioning accuracy, reliability, availability and stability of GNSS systems in areas such as cities, mountains, densely-packed buildings and severely covered areas in Asian-Pacific region.     

工作绩效综合评价与分级管理及实证

本文针对目前员工绩效评价中的问题进行研究。建立了绩效评价指标体系，给出工作绩效考评法；并据综合绩效进行归类分级，提出对员工分类激励的方法，给出实证结果。     

发散波束在媒质界面上的Goos-H(a)nchen位移与焦移

在全反射中研究了发散波束在两种不同媒质界面上Goos-H(a)nchen位移与焦移.首先,通过建立发散光束全反射简单光线模型来显示焦移的形成.然后,从波动光学出发,利用Fourier光学中的角谱法推导出Gauss发散波束入射下Goos-H(a)nchen位移和焦移的近似关系式.结果表明,由Carniglia 和 Brownstein 针对于均匀波束提出的Goos-H(a)nchen位移和焦移的微分关系式同样也适用于Gauss发散波束入射的情况.最后,通过数值模拟总结出了焦移的一些不同于Goos-H(a)nchen位移的特殊性质.这些特殊性质的发现为改善现有实验和工程精度提供了新路径.     

阻拦索断裂对螺旋桨舰载机着舰安全影响数值分析

喷气动力舰载机着舰拦阻滑跑，如阻拦索断裂，其逃逸复飞的概率极小。螺旋桨动力舰载机零升阻力大，推重比小，其安全复飞的能力值得研究。本文基于建立的螺旋桨舰载机逃逸复飞仿真模型（含阻拦索工作模型、发动机动力响应模型、升降舵操纵模型与气动力的动力影响修正模型），数值模拟了E-2C舰载预警机着舰阻拦索断裂情况下，其逃逸复飞的过程。仿真计算显示对象飞机在不同气动力、离舰速度与舵面操纵逻辑状态下，其纵向动力学方程中敏感参数与航迹下沉量的动态变化，结合视频数据分析其复飞成功的原因。研究表明：动力对螺旋桨舰载机俯仰力矩与升力特性的影响是其逃逸复飞成功的关键。动力影响使对象飞机的俯仰力矩曲线上移0.15，8°迎角下纵向静稳定性减小85%，升力线斜率增大29.7%、最大升力系数增大39%。这显著改善了螺旋桨飞机逃逸复飞状态下俯仰操纵的敏捷性，升降舵操纵效率与失速特性。动力影响使螺旋桨舰载机可在较小的加速度、离舰速度与有限的留空时间情况下，迅速改变其航迹角，减小航迹下沉量，保证逃逸复飞安全。     

平衡记分卡的演进

自1992年初创以来,平衡记分卡无论从形式、内涵还是从功能来看都发生了很大的变化:确定行动目标的方法由原来对特定问题进行思考的方式转化为直接根据战略来构造;因果关系由原来只存在于各角度之间的一种粗略关系演化成贯穿各个角度并连结各战略目标的一种明确的联系;功能则超越了原来业绩测评系统的局限成为一体化的战略管理系统的核心.这些改进使平衡记分卡更便于操作,应用也更为广泛.     

工程常见塔间距下大型冷却塔的双塔干扰效应

针对工程常见塔间距下冷却塔双塔干扰效应采用风洞试验方法进行研究,通过增加模型表面粗糙度来补偿模型试验的雷诺数效应,变化塔间距和风向角进行125种工况的风洞试验,进行基于有限元的风致响应计算,获得不同风向角和塔间距下的整体风荷载和风致响应,并以此进行双塔的干扰效应研究。研究发现双塔并行放置时,由于"狭缝效应"的存在使得顺风向塔底剪力的干扰系数大于1,此时塔间距越小,干扰效应越显著;本文研究的塔间距下基于多组风荷载和风致响应指标的干扰系数最大值约为1.15;顺风向塔底剪力和弯矩的干扰系数最大值大约出现在67.5°风向,基于风致响应指标的最大值出现在90°≤θ≤150°之间的风向。     

地面效应作用下翼尖涡特性的PIV实验研究

完成了NACA23012机翼地面效应条件下翼尖涡结构及升阻力特性实验。实验在拖曳水槽中模拟机翼的飞行状态,获得了在多种飞行高度、0°攻角时机翼在水平地面和正弦波浪地面附近的升/阻力、翼尖涡流场的变化规律,对比分析了水平地面和波浪地面附近翼尖涡速度、涡量分布的区别及其可能对机翼升/阻力造成的影响。实验结果表明:即使在正弦波浪地面附近,随着机翼逐渐靠近地面,升力逐渐减小至负升力,翼尖涡的强度亦发生相应变化;尤其是在小间隙比、负升力情况下,翼尖涡的旋转方向产生了改变;流场结构不仅受机翼距地面高度影响,也随着波浪地面与机翼瞬时所处位置构成的相对相位关系的不同而变化,并且涡量沿波浪地面运动的变化呈现周期性,但变化规律并不符合正弦周期,主要原因在于波浪地形与下翼面所构成的流道形状及狭窄程度的周期性变化对翼尖涡流场结构的发展和演化产生不同程度的抑制。     

载人航天任务测速雷达双通道数据融合方法

针对载人航天任务中高精度测速雷达在实时多主站外弹道融合时仅能采用单通道应答数据参与处理,获得的弹道精度较差,且测速雷达数据利用率仅有50%的问题,提出利用多普勒效应和应答机遥测参数两种方法对测速雷达跟踪模式进行实时准确识别,首先得到测速雷达双通道的应答数据,然后通过改进的非线性滤波+机动模型算法对火箭上升段外弹道测量数据进行高精度融合。最后采用仿真数据对传统方法和新方法的外弹道融合精度进行了比对分析。该方法的应用可有效提高测速雷达测元利用率和载人航天任务火箭上升段外弹道精度,具有较强的工程应用价值。     

High-temperature gas effects on aerodynamic characteristics of waverider

This paper focuses on the analysis of high-temperature effect on a conical waverider and it is a typical configuration of near space vehicles. Two different gas models are used in the numerical simulations, namely the thermochemical non-equilibrium and perfect gas models. The non-equilibrium flow simulations are conducted with the usage of the parallel non-equilibrium program developed by the authors while the perfect gas flow simulations are carried out with the commercial software Fluent. The non-equilibrium code is validated with experimental results and grid sensitivity analysis is performed as well. Then, numerical simulations of the flow around the conical waverider with the two gas models are conducted. In the results, differences in the flow structures as well as aerodynamic performances of the conical waverider are compared. It is found that the thermochemical non-equilibrium effect is significant mainly near the windward boundary layer at the tail of the waverider, and the non-equilibrium influence makes the pressure center move forward to about 0.57% of the whole craft’s length at the altitude of 60 km.     

Photoluminescence Properties of Nanocrystalline 3C-SiC Films

Nanocrystalline (nc) 3C-SiC films on the Si substrate were prepared by the helicon wave plasma enhanced chemical vapor deposi-tion (HW-PECVD) technique. With the SiH4-CH4 gas flow ratio changing, the films exhibit different photoluminescence (PL) character-istics. Under the stoichiometric condition, the PL peak redshift from 470 nm to 515 nm is detected with the increase of excitation wave-length, which can be attributed to the quantum confinement effect radiation of 3C-SiC nanocrystals of different sizes. However, the ap-pearance of an additional PL band at 436 nm in Si-rich film might be sourced back to the excess of Si defect centers in it. This is also the case for C-rich film for its PL band lying at 570 nm. The results above quoted indicate an important influence of gas flow ratio on the PL properties of the SiC films providing an effective guidance for analyzing the luminescence mechanism and exploring the high-efficiency light emission of the SiC films.