Large-scale Coronal Heating, Clustering of Coronal Bright Points, and Concentration of Magnetic Flux

By combining quiet-region Fe XII coronal images from SOHO/EIT with magnetograms from NSO/Kitt Peak and from SOHO/MDI, we show that the population of network coronal bright points and the magnetic flux content of the network are both markedly greater under the bright half of the large-scale quiet corona than under the dim half. These results (1) support the view that the heating of the entire corona in quiet regions and coronal holes is driven by fine-scale magnetic activity (microflares, explosive events, spicules) seated low in the magnetic network, and (2) suggest that this large-scale modulation of the magnetic flux and coronal heating is a signature of giant convection cells. This revised version was published online in June 2006 with corrections to the Cover Date.     

西安某粘接材料厂室内供暖、热水系统的设计

基于厂方对供热系统的要求,根据供热建筑物、机房和可利用设施的实际情况,采用一台换热器,通过阀门的切换,实现了供暖和供热水的分段运行。将蒸汽发生器的进水与系统补水有机地整合为一个系统,有效地解决了机房面积过小的实际困难。利用自来水的压力和热水箱与浴室的高差解决了热水供应的实际问题。     

Electron density inversed by plasma lines induced by suprathermal electron in the ionospheric modification experiment

Incoherent scatter radar (ISR) is the most powerful ground-based measurement facility to study the ionosphere. The plasma lines are not routinely detected by the incoherent scatter radar due to the low intensity, which falls below the measured spectral noise level of the incoherent scatter radar. The plasma lines are occasionally enhanced by suprathermal electrons through the Landau damping process and detectable to the incoherent scatter radar. In this study, by using the European Incoherent Scatter Association (EISCAT) UHF incoherent scatter radar, the experiment observation presents that the enhanced plasma lines were observed. These plasma lines were considered as manifest of the suprathermal electrons generated by the high-frequency heating wave during the ionospheric modification. The electron density profile is also obtained from the enhanced plasma lines. This study can be a promising technique for obtaining the accurate electron density during ionospheric modification experiment.     

Coronal Heating by Magnetic Explosions

From magnetic fields and coronal heating observed in flares, active regions, quiet regions, and coronal holes, we propose that exploding sheared core magnetic fields are the drivers of most of the dynamics and heating of the solar atmosphere, ranging from the largest and most powerful coronal mass ejections and flares, to the vigorous microflaring and coronal heating in active regions, to a multitude of fine-scale explosive events in the magnetic network, driving microflares, spicules, global coronal heating, and, consequently, the solar wind. This revised version was published online in June 2006 with corrections to the Cover Date.     

双馈异步风力发电机气隙偏心故障诊断研究现状与发展

双馈异步风力发电机(DFIG)机械故障在实际运行中尤其不可忽略,不论是转子刚度不足还是轴承磨损或安装误差,都会导致气隙偏心,严重时甚至会烧毁电机,因此对风机进行准确高效的气隙偏心故障诊断至关重要。简单介绍DFIG产生气隙偏心的故障机理,再对当前已有的相关故障诊断方法做重点归类阐述,最后展望未来的DFIG气隙偏心故障诊断方法的发展趋势和方向。     

充气式返回舱气动热特性研究

文章针对航天器返回实时性和经济性的需求,以充气式返回舱为研究对象,研究该飞行器从空间站返回过程中的气动特性,重点分析气动热特性。文章通过引入分子运动论、Kemp-Riddell方法、Linear桥函数等计算方法,建立起该飞行器在自由分子流区、过渡流区和连续流区高超声速情况下的表面热平衡方程,得出了该飞行器返回过程中的驻点热流密度和驻点壁面温度。计算分析了该飞行器最大直径D1和半锥角α等几何尺寸对其气动热特性的影响,得到在一定范围内增大D1和α可以有效减小驻点热流密度和驻点壁面温度,并研究在峰值加热高度附近70km、80km处不同马赫数下的气动热特性。在此基础上,依据热防护系统材料和布局,将气动加热计算的表面热流分布作为外壁边界条件,分析了结构材料层的温度变化特性。     

数值研究低热值燃料环管燃烧室燃烧流场

在任意曲线坐标系下对采用两种不同组分(天然气掺混氮气、一氧化碳)的低热值燃料环管燃烧室燃烧流场进行计算,结果表明低热值燃料的化学反应速率与其组分直接有关,燃料一氧化碳的燃烧效率高于天然气与氮气掺混物燃料,燃料组分变化对燃烧室燃烧效率与出口温度影响很大,因此选用合适的燃料十分重要.计算所得的燃烧室的燃烧效率和出口温度分布与试验数据符合较好,表明所用的数学模型与计算方法合理,计算程序可靠,可为低热值气体燃料燃烧室研制和优化设计提供有用的数据.      

一种改进的直接转矩控制算法

分析了转矩角与定转子磁链角速度及电机速度的关系,提出一种新的直接转矩控制算法.通过转矩角增量和定转子磁链的位置,计算出补偿转矩和定子磁链的参考电压矢量,基于空间矢量调制技术实现对逆变器电压状态的控制,改善了系统的性能.给出了仿真结果,证明了算法的合理性和有效性.     

基于磁通感应的动目标探测原理及分析

文章研究利用磁通感应技术对运动目标进行探测的方法。通过分析运动目标的磁特性,建立等效磁性模型。根据模型设计了探测感应线圈的结构,并从理论上推导出线圈内磁通量和感生电动势的求解公式。利用数值仿真获得了探测信号与运动目标特征及线圈参数的关系。计算结果表明,探测信号对运动目标参数及探测感应线圈的结构变化响应明显,初步验证了该探测技术的可行性。     

150kV逆变电源性能优化及其束源特性

为了进一步提高电子束流发生系统工作的可靠性和稳定性,提高电子束加工质量,采用AC-DC-AC-DC-AC-DC的拓扑电路、新型功率变压器、高压脉冲检测技术、优化的束流反馈控制与灯丝加热电流闭环反馈控制技术等,分别优化了高压加速电源、偏压电源与灯丝加热电源。将所研制逆变电源与150 k V/30 k W电子枪、真空系统等组成了一套电子束流发生系统,测试了该电子束流发生系统输出的高压、最大束流以及灯丝加热电流、偏压变化对束流输出的影响。试验结果表明:经过优化的逆变电源高压输出达到-150 k V,高压输出线性度较好,最大束流达到200 m A;高压、灯丝加热电流给定时,随着偏压降低,束流输出逐渐增大;高压、偏压给定时,随着灯丝加热电流增大,束流输出存在死区、线性增大区和恒流区。