空-空导弹全向攻击最优制导规律研究

 将发射瞬时所确定的平行接近弹道作为基准弹道,由于各种干拢所引起的相对于基准弹道的偏离作为偏差来处理;用最优控制理论导出空-空导弹进行全向攻击的最优制导律,此制导律包含目标加速度反馈。当目标作非机动飞行时,最优制导律是一种变比例系数的比例制导。数字仿真结果表明:在相同条件下,最优制导弹道需用过载、终端脱靶量均小于比例制导,特别是从目标前方攻击时,其制导精度大大优于比例制导。     

无穷观问题的研究(Ⅲ)——‘每一''与‘所有''

本组系列论文（I）－（Ⅴ）从数学和认识论的角度系统地研究了无穷观问题的历史发展和现状，确立了无穷观背景世界的三分法原则，指出了两种穷观相互排斥的局限性，形成了统一两种无穷于同一框架中的基本观点，并建立了一个统一实无限与潜无限于同一框架中的公理集合论系统APAS。     

考虑高载和阻尼介质时刚塑性圆板的塑性动力分析

本文研究了阻尼介质对刚塑性圆板在高载(冲击荷载)作用下塑性动力响应的影响,得到了解析解并对此解进行了讨论。当阻尼介质参数趋于零时,本文结果与无阻尼解一致。文中还画出了荷载与阻尼介质对圆板运动时间和板中心点残余挠度的影响曲线。     

穿透式冷板的传热分析

对航空电子设备上采用的空心冷板冷却系统的传热特性进行了分析求解，得到了空心冷板稳态温度分布表达工和功率－温度－流量关系式，可作为空心冷板系统的设计依据，建立了空心冷板失效的动态温度模型，得到的温度－时间响应特性可用于评估冷板系统耐热冲击性能。     

一般硬化材料弹塑性旋转盘的变分解法

首先在小弹塑性范围内用应变的奇次四项式相当精确地拟合一般硬化材料的拉伸曲线;再在体积不变条件下用弹性位移场的已知模态和一待定幅值构成弹塑性位移场;最后用势能原理确定该幅值而得到封闭解。     

Hybrid integration method for highly maneuvering radar target detection based on a Markov motion model

To detect highly maneuvering radar targets in low signal-to-noise ratio conditions, a hybrid long-time integration method is proposed, which combines Radon-Fourier Transform (RFT), Dynamic Programming (DP), and Binary Integration (BI), named RFT-DP-BI. A Markov model with unified range-velocity quantification is formulated to describe the maneuvering target’s motion. Based on this model, long-time hybrid integration is performed. Firstly, the whole integration time is divided into multiple time segments and coherent integration is performed in each segment via RFT. Secondly, non-coherent integration is performed in all segments via DP. Thirdly, 2/4 binary integration is performed to further improve the detection performance. Finally, the detection results are exported together with target range and velocity trajectories. The proposed method can perform the long-time integration of highly maneuvering targets with arbitrary forms of motion. Additionally, it has a low computational cost that is linear to the integration time. Both simulated and real radar data demonstrate that it offers good detection and estimation performances.     

Electric potential structures of auroral acceleration region border from multi-spacecraft Cluster data

This paper studies an auroral event using data from three spacecraft of the Cluster mission, one inside and two at the poleward edge of the bottom of the Auroral Acceleration Region (AAR). The study reveals the three-dimensional profile of the region’s poleward boundary, showing spatial segmentation of the electric potential structures and their decay in time. It also depicts localized magnetic field variations and field-aligned currents that appear to have remained stable for at least 80?s. Such observations became possible due to the fortuitous motion of the three spacecraft nearly parallel to each other and tangential to the AAR edge, so that the differences and variations can be seen when the spacecraft enter and exit the segmentations, hence revealing their position with respect to the AAR.     

DME Interference mitigation for L-DACS1 based on system identification and sparse representation

L-band digital aeronautical communication system 1 (L-DACS1) is a promising candi-date data-link for future air-ground communication, but it is severely interfered by the pulse pairs (PPs) generated by distance measure equipment. A novel PP mitigation approach is proposed in this paper. Firstly, a deformed PP detection (DPPD) method that combines a filter bank, correlation detection, and rescanning is proposed to detect the deformed PPs (DPPs) which are caused by mul-tiple filters in the receiver. Secondly, a finite impulse response (FIR) model is used to approximate the overall characteristic of filters, and then the waveform of DPP can be acquired by the original waveform of PP and the FIR model. Finally, sparse representation is used to estimate the position and amplitude of each DPP, and then reconstruct each DPP. The reconstructed DPPs will be sub-tracted from the contaminated signal to mitigate interference. Numerical experiments show that the bit error rate performance of our approach is about 5 dB better than that of recent works and is closer to interference-free environment.     

Numerical investigation on flow nonuniformity-induced hysteresis in scramjet isolator

Numerical simulation and theoretical analysis were conducted to study the hysteresis inside scramjet isolator during the reciprocating process of back pressure variation. It is revealed that only a regular reflection is theoretically possible for two leading shocks when the inflow Mach number is greater than 2.0, and no hysteresis can occur in the transition between shock reflection types. Nevertheless, wall suction, gas injection, and background waves cause non-uniformity of the incoming flow and would make hysteresis possible. Besides the classical hysteresis in the transition between shock reflection, new kinds of hysteresis were found in both the deflection angle of separated boundary layer and the location of the shock train. Moreover, the occurrence of hysteresis in the deflection angle of the separated boundary layer is accompanied with the shock reflection hysteresis. In the case with background waves or gas injection, hysteresis in the starting position of leading shock was observed too. As back pressure decreases, the leading shock does not follow the same path as that as the back pressure increases, and it is anchored at the location where the background shock or the injection interacts with the leading shock. It is inferred that, if two strong adverse pressure gradient regions move towards and interact with each other, hysteresis will take place when they start to separate.     

基于等效板的含离散源损伤机翼结构分析

研究离散源损伤对机翼结构的影响,可以大幅度提高飞机在不良损伤事故下的生存能力.由于机翼内部结构复杂,很难对含离散源损伤机翼结构进行精确分析,而且精确的建模和仿真在建模与计算过程中往往也非常耗时.因此,以含离散源损伤机翼为对象,采用有限元优化设计方法,确立了一种机翼结构等效板模型的建模方法.建立的等效板模型可对含离散源损伤机翼实现快速、准确的静力学和动力学分析.