空载固体发动机计算与试验模态相关性分析

为了预测空载状态固体火箭发动机动态特性,对其进行了模态试验,并应用MSC.Marc进行了模态计算,然后对比两者的结果,进行了相关性分析和评估。计算得到了发动机250Hz以内的一阶弯曲模态和五阶呼吸模态。试验测得了发动机的三阶呼吸模态和一阶弯曲模态。比较试验测试模态和与之对应的计算模态:固有频率相对误差均在5%以内;振型相关图上的点大都分布在斜率为1(或 1)的直线周围;MAC(模态置信判据)值在0 9左右。说明计算与试验模态有较好的相关性,有限元计算模型比较准确的反映了实际情况。     

一次火箭参数对RBCC引射模态性能的影响

应用经过校验的三维湍流有限体积数值算法，对引射模态下RBCC模型不同一次引射火箭结构和工作参数条件下的多种工作状态进行了模拟。结果发现：提高一次火箭燃烧室工作压强，二次流量增加，系统推力增加，混合效果增强；一次火箭喷管形状直接影响引射掺混效果，但在保证足够一次流量的前提下，方形管道中可以使用锥形一次喷管，不会带来性能上的较大差异；一次火箭喷管数目增加，掺混质量提高；一次喷管扩张半角的改变不会影响二次引入流量，但会影响掺混效果和一次火箭自身推力；一次喷管面积膨胀比的变化，不会影响二次引入流量．但会改变混合效果。     

教练机发动机设计载荷谱推导方法

系统地研究了教练机航空发动机设计载荷谱的推导方法，主要包括：（1）基准机的选取与现役发动机载荷谱的空测、统计；（2）新机发动机飞行剖面的预测；（3）新机发动机设计任务循环的编制等三大步骤。提出的方法具有一定的通用性，可以推广到其它类型的发动机设计载荷谱研究。     

弹用涡喷、涡扇发动机发展概况

介绍了飞航式导弹主要动力装置的弹用涡喷、涡扇发动机的发展概况，包括发展历史、特点、技术现状，并论述了发展趋势。     

喷管扩张段烧蚀的“台阶效应”计算

当喉衬和扩张段内衬采用具有不同烧蚀率的材料时,常出现“台阶效应”.本文以气动热化学烧蚀机理为基楚,提出应用适当的对流换热和加剧的化学反应计算对台阶效应区进行修正的方法,使台阶效应区的烧蚀率预示更切合实际工况.     

多机并联火箭羽流流场及其底部热环境分析

For the problem that the plume flow field structure of a multi engine parallel rocket is complicated and the bottom thermal environment is extremely harsh, which may cause the failure of the engine structural components, the plume flow field and thermal environment at different altitudes are studied through numerical simulation. The result is compared with the measured results in flight which shows that when the rocket is flying at a low altitude, the plume of the engines do not interfere with each other. As the flight altitude increases, the plumes gradually expand and begin to interfere with each other, and finally there is an obvious backflow at the bottom of the rocket. The maximum heat flux at the moment of take off is basically the same as the measured value in flight. Before the backflow occurs, the heat flux mainly consists of radiant heat, the convective heat flow increases as the flight altitude grows, but it is also much smaller than the peak heat flow at takeoff. The result has certain guiding significance for the optimal design of engine structure thermal protection.     

OSIRIS-REx low-velocity particles during outbound cruise

We analyzed high-angular rate streaks first recorded by OSIRIS-REx’s MapCam during a 2017 search for Earth Trojan asteroids. We interpret them as water-ice particles that translated across the imager’s field of view, originating from the spacecraft itself. Their translation velocities approximated 0.1–1?m/s based on reasonable conclusions about their range. Pursuing several lines of investigation to seek a coherent hypothesis, we conclude that the episodic releases of the water ice particles are associated with spacecraft attitudes that resulted in solar illumination of previously shadowed regions. This correlation suggests that the OSIRIS-REx spacecraft itself possesses micro-climatic zones consisting of hot regions and cold traps that may temporarily potentially pass volatiles back and forth before losing most of them.     

某发动机调节器自动检测异常故障分析

针对某型发动机自动调节器自动检测异常的故障现象,对产生发动机自动调节器自动检测异常的原因进行了深入地研究分析,并提出了针对性的预防措施。     

浅谈水洗发动机对大修成本的影响

通过对深圳航空公司CFM56-7B发动机水洗方法改进前后的发动机进厂大修数据进行比较,主要分析HPT导向器报废率的变化,说明改进的发动机水洗方式对于延长发动机在翼时间、降低HPT导向器报废率、节约大修成本起到良好促进作用。     

对空间碎片近距随遇悬停的控制方法及悬停燃耗分析

对空间碎片检视或抓捕操控中的悬停控制及燃耗问题进行了研究。通过C W方程，建立任务星近距随遇定点悬停控制模型，通过设计状态反馈控制器分析定点悬停的可控性以及推控要求，结果表明近距悬停需要与悬停位置相关的两个正交方向上的常值连续推力控制量，以及用于抵抗扰动的三轴向上的反馈变推力控制量。分析了近距随遇悬停的推控分系统配置，建立了长时近距随遇悬停的燃耗及燃耗速率的数学模型，最后分析了既满足安全距离需求、又满足悬停方位需求的最小悬停燃耗模型。