卫星优化热设计方法

试图把最优化技术应用于卫星工程的热设计中,提出一种优化热设计的方法,并以14个节点模型作为实例进行了计算分析,采用Hooke-Jeeves 的直接搜索法得到了满意的结果。初步编制的计算机程序,可作为卫星热设计方案计算的基础。     

模拟地球同步轨道辐照环境对光学太阳反射镜性能的影响

研究了模拟地球同步轨道辐照环境对卫星用温控涂层-光学太阳反射镜(OSR)性能的影响。对所研制的两类OSR 片进行的辐照试验项目有,真空紫外辐照、低能电子和两种能量的质子辐照。此外还进行了等离子体环境条件下的表面充/放电效应试验。经过相当于安装在地球同步轨道卫星南北极位置处,在空间七年所受到的电子、质子和紫外辐照总剂量的辐照后,导电型OSR 的太阳光谱吸收率α_s 由0.068增加到0.078,法向发射率ε_n 由0.83降低到0.72;而非导电型OSR的α_s 由0.066增加到0.085,ε_n 由0.82降低到0.76。表面充/放电试验的结果表明:导电型OSR 的充电电位仅在15～40V 之间,而非导电型OSR 的充电电位则可高达13kV。因此导电型OSR能有效地控制表面的充/放电现象。     

微重力场中对流—辐射—传质系统的地面模拟技术

研究了微重力条件下对流－辐射－传质稳态系统的地面相似模拟技术，进一步发 温度－材料综合保护技术。通过采取补偿热流，调整壁面热流密度分布的方法，保持了原型与尺寸适当缩小后的模型的Ｎｕ数，Ｓｈ数，材料，温度，湿度不变，从而实现模型与原型流动，换热和传质相似。     

防静电白色热控涂层的空间环境性能试验

通过在氧化锌晶格中掺入重金属离子，得到具有防静电功能的白色颜料，再以丙烯酸树脂为粘合剂制备出空间飞行器外表面用的ACR－1防静电白色热控涂层；研究了空间环境效应（包括紫外辐照，电子和质子辐照）对该热控涂层太阳吸收率的影响并与有机硅白色热控涂层进行了比较，地面模拟空间环境试验研究结果证明，ACR－1防静电白色热控涂层具有良好的空间稳定性。     

微重力下管肋式空间辐射器的整体优化分析

建立了向一重力环境下管肋式空间辐射器传热过程的数学模型，并以单质量散热量最大和热载体驱动功率最小为优化目标，对管式空间辐射器进行了优化分析。     

多机并联火箭羽流流场及其底部热环境分析

For the problem that the plume flow field structure of a multi engine parallel rocket is complicated and the bottom thermal environment is extremely harsh, which may cause the failure of the engine structural components, the plume flow field and thermal environment at different altitudes are studied through numerical simulation. The result is compared with the measured results in flight which shows that when the rocket is flying at a low altitude, the plume of the engines do not interfere with each other. As the flight altitude increases, the plumes gradually expand and begin to interfere with each other, and finally there is an obvious backflow at the bottom of the rocket. The maximum heat flux at the moment of take off is basically the same as the measured value in flight. Before the backflow occurs, the heat flux mainly consists of radiant heat, the convective heat flow increases as the flight altitude grows, but it is also much smaller than the peak heat flow at takeoff. The result has certain guiding significance for the optimal design of engine structure thermal protection.     

Numerical simulations of water spray on flame deflector during the four-engine rocket launching

This paper aims to study on the cooling effect with two types of water spray nozzle on the flame deflector during the four-engine launch vehicle take-off. To accurately simulate the two-phase flow of the rocket gas with multispecies and the water spray, the three-dimensional compressible Navier-Stokes equations, discrete ordinates methods and realizable k-Ɛ turbulence model are used to establish the rocket supersonic plumes impact model. The Eulerian dispersed phase (EDP) model was used to simulate the water spray into the exhaust gas. The accuracy and effectiveness of the gas-liquid flow model are verified by a good agreement between simulation results and experimental data. On this basis, a series of numerical simulation studies under different water injection position are performed. The results show that the high temperature regions, along the axis of engines on the deflector plate, have no significant temperature decreasing effect by water spray from the nozzles mounted on the apex of the deflector, and the high temperature converts a large quantity of water into vapor near the plume boundary, which would decrease the flow conductivity. With the cooling spray nozzle fixed directly to the deflector plate, the temperature decrease effect is obvious and the effect of thermal shock on deflector plate induced by exhaust plume is reduced, so that it can prevent the flame deflector from thermal ablation. The study results provide indepth information and engineering guidance for designing the water spray systems and increasing the safety of the launch process.     

复杂电磁环境下无线接收机电磁兼容快速测试技术应用CSCD

复杂射频电磁环境下,无线接收机作为主要的敏感设备,其电磁兼容性直接影响着整个武器装备的电磁兼容特性. 本文针对GJB 151B中对于接收机非线性测试方法的局限性,引入了一种利用自动双频测试系统对接收机干扰响应的快速测试方法;并搭建了实验室半实物仿真测试平台,检测了某接收机在（ 4-6 ） GHz组合频率干扰下的所有非线性的干扰响应通道. 测试结果对于评估接收机及其所在系统的外部电磁环境适应性具有重要参考价值.     

A time-frequency analysis of the thermal radiation background anomalies caused by large earthquakes: A case study of the Wenchuan 8.0 earthquake

Strong earthquakes have an impact on the regional thermal radiation background, which has been both observed and confirmed. This effect produces anomalies in the thermal radiation background (TRBA) and increases the difficulty of extracting a thermal radiation anomaly (TRA) that is associated with an earthquake occurring during the same time period. The extraction and identification of such anomalies has been ignored by previous studies. In this study, we investigate the time-frequency analysis (TFA) method, together with the wavelet filtering of the Daubechies method and the relative power spectrum analysis of the Fourier Welch method to extract and analyse the TRBA caused by the 2008 Wenchuan Ms 8.0 earthquake and the TRA of the 2013 Minxian-Zhangxian Ms 6.6 earthquake using data concerning the brightness temperature of a black body (TBB) from the Fengyun-2 series of geostationary meteorological satellites developed by China. The result showed that this method can effectively extract and analyse the TRBA caused by the Wenchuan earthquake and the TRA of the Minxian-Zhangxian earthquake form a complex background environment. Furthermore, we discussed the impact of the earthquake on the TRBA and segmented the process. The impact is mainly reflected by three aspects; the characteristic period of the TRBA changes, the TRBA occurs at the same time every year, which is identical to the time at which the earthquake anomaly occurred, and the impact process is in stages. We also summarized the correlation between the characteristic parameters of a TRA and the regional thermal radiation background, geography, and climatic factors.