四酚基乙烷环氧树脂的固化性能

研究了甲基四氢邻苯二甲酸酐(Me THPA)和4,4-二氨基二苯基砜(DDS)两种固化剂对1,1,2,2,-四(对羟基苯基)乙烷四缩水甘油醚环氧树脂(TGE)固化反应及固化性能的影响。通过DSC研究了树脂的固化行为,结果表明Me THPA体系与DDS体系的固化反应活化能分别为65.8和68.4 k J/mol;同时通过DMA、TGA以及万能材料试验机等方法对树脂的热力学和力学性能等进行研究。Me THPA体系的Tg为188℃,初始热分解温度为219.9℃,拉伸强度为33 MPa,弯曲强度为48 MPa。而DDS体系的Tg为203℃,初始分解温度为292.3℃,拉伸与弯曲强度分别为61和93 MPa。     

飞机环控系统管道气流温度的测量

根据实际使用中出现的问题，对各种实用的管道气流温度传感器的误差进行了计算，对电阻式和热电偶式温度传感器的误差原因作了定量分析。由于带密封罩的温度传感器在实际使用中存在着明显的缺点，建议今后使用热电偶测量飞机环控系统管道气流温度，并提出了一种实用热电偶温度传感器的结构形式，同时也介绍了如何减小由于热传导和热辐射引起的误差。     

Numerical simulation on antenna temperature field of complex structure satellite in solar simulator

A thermal network model is developed for studying the temperature variation of complicated structure satellite surfaces. The solar incident areas, the infrared and solar radiation transfer coefficients among surfaces are numerically simulated by means of Monte Carlo ray tracing (MCRT) method in model. The non-uniformity and the instability of solar radiation, which plays the important roles in simulating outer-space heat flux designation parameters by solar simulator, are studied for analysis variation of antenna temperature fields in detail. Results showed non-uniformity irradiation effects are greater than those of instability for this kind of geometry sheltering structure.     

烧蚀材料的热分解动力学研究

用热重分析技术研究了３种烧蚀材料的热失重信息，分别用直接法和差减微分法确定了其分解动力学参数，并以ＣａＣＯ３火已动力学参数的标准物对这２种方法作了标定。     

在轨温度环境对J-47C 胶黏剂粘接性能的影响

为考察在轨温度环境对J-47C结构胶黏剂粘接性能的影响,利用动态热机械分析和热重分析方法,对其Tg、热分解温度进行了测试,掌握了胶黏剂的耐热指标。通过不同温度下力学性能测试,温度冲击及真空热循环试验研究了卫星特殊的温度环境对胶黏剂性能的影响。结果表明,J-47C胶黏剂在高温以及真空热循环和温度冲击后其仍具有较高的力学强度保持率,满足卫星的温度环境对胶黏剂性能的需求。     

Ascent trajectory optimization for stratospheric airship with thermal effects

Ascent trajectory optimization with thermal effects is addressed for a stratospheric airship. Basic thermal characteristics of the stratospheric airship are introduced. Besides, the airship’s equations of motion are constructed by including the factors about aerodynamic force, added mass and wind profiles which are developed based on horizontal-wind model. For both minimum-time and minimum-energy flights during ascent, the trajectory optimization problem is described with the path and terminal constraints in different scenarios and then, is converted into a parameter optimization problem by a direct collocation method. Sparse Nonlinear OPTimizer(SNOPT) is employed as a nonlinear programming solver and two scenarios are adopted. The solutions obtained illustrate that the trajectories are greatly affected by the thermal behaviors which prolong the daytime minimum-time flights of about 20.8% compared with that of nighttime in scenario 1 and of about 10.5% in scenario 2. And there is the same trend for minimum-energy flights. For the energy consumption of minimum-time flights, 6% decrease is abstained in scenario 1 and 5% decrease in scenario 2. However, a few energy consumption reduction is achieved for minimum-energy flights. Solar radiation is the principal component and the natural wind also affects the thermal behaviors of stratospheric airship during ascent. The relationship between take-off time and performance of airship during ascent is discussed. it is found that the take-off time at dusk is best choice for stratospheric airship. And in addition, for saving energy, airship prefers to fly downwind.     

Effects of lighting and air movement on temperatures in reproductive organs of plants in a closed plant growth facility

Temperature increases in plant reproductive organs such as anthers and stigmas could cause fertility impediments and thus produce sterile seeds under artificial lighting conditions without adequately controlled environments in closed plant growth facilities. There is a possibility such a situation could occur in Bioregenerative Life Support Systems under microgravity conditions in space because there will be little natural convective or thermal mixing. This study was conducted to determine the temperature of the plant reproductive organs as affected by illumination and air movement under normal gravitational forces on the earth and to make an estimation of the temperature increase in reproductive organs in closed plant growth facilities under microgravity in space. Thermal images of reproductive organs of rice and strawberry were captured using infrared thermography at air temperatures of 10–11 °C. Compared to the air temperature, temperatures of petals, stigmas and anthers of strawberry increased by 24, 22 and 14 °C, respectively, after 5 min of lighting at an irradiance of 160 W m⁻² from incandescent lamps. Temperatures of reproductive organs and leaves of strawberry were significantly higher than those of rice. The temperatures of petals, stigmas, anthers and leaves of strawberry decreased by 13, 12, 13 and 14 °C, respectively, when the air velocity was increased from 0.1 to 1.0 ms⁻¹. These results show that air movement is necessary to reduce the temperatures of plant reproductive organs in plant growth facilities.     

Boundary layer aerosol retrieval from thermal infrared nadir sounding – Preliminary results

A non-empirical algorithm is presented to retrieve the optical depth in the 750–1250 cm⁻¹ spectral range, of aerosol located in the boundary layer over the ocean, from nadir high-resolution radiance spectra in the thermal infrared. The algorithm is based on a line-by-line radiative transfer forward model and used the Optimal Estimation Method for the retrieval. Its performance strongly depends on the quality of the a priori temperature and H₂O atmospheric profiles. To demonstrate the relevance of the algorithm, distributions of maritime aerosol parameters have been retrieved from IMG/ADEOS data for December 1996, using the algorithm with the LBLRTM radiative transfer code, and ERA40 (ECMWF) a priori atmospheric profiles and surface conditions.     

SiO2 气凝胶热参数测试及评价

利用非稳态阶跃平面热源法对SiO2气凝胶的热参数进行了高温实验研究,获得了不同温度和压力条件下SiO2气凝胶的热导率、热扩散率以及比热容等.结果表明,SiO2气凝胶800℃的热导率比室温增大约62％.在相同气压且低于600℃时,其热导率受比热容影响,而在高于600℃时,则受热扩散率影响;在相同温度且高于10 kPa时,热导率亦受热扩散率影响.     

飞机系统模拟试验中热电阻及其数字显示仪表的现场校准技术研究

在飞机系统地面模拟试验中．热电阻及其数字显示仪表在液压、飞控等试验系统中广泛使用。针对各试验系统中某些位置的热电阻及其数字显示仪表接线复杂,不便拆卸和传统计量方式的种种弊端等问题,提出了一种由现场计量炉、便携式测温仪和温度校准器等设备组成的现场校准系统。实现对热电阻及其数字显示仪表的现场整体校准,同时亦可实现对热电阻及其数字显示仪表的分部校准,避免了拆卸和安装,提高了工作效率,具有实用价值。