航天器TDRSS中继终端入网验证初探

针对国内外航天系统的现状,介绍了NASA航天器TDRSS系统的应用情况和中继终端入网验证技术。在此基础上,面向航天器测控的发展方向,从综合利用中继终端入网验证设施、分析中继终端入网验证流程和管理体制方面,探讨了未来我国航天器TDRSS中继终端入网验证的设想。     

红外遥感器空间制冷技术的发展现状

红外遥感技术发展的关键技术之一是解决其红外器件的制冷问题。文中通过对空间用制冷技术的分析,探讨了辐射制冷器、斯特林制冷机、脉冲管制冷器在空间中的应用和发展方向。     

低轨航天器致空间等离子体尾流

建立起一个低轨道航天器引起的等离子体尾的二维计算机模式，结果表明：（１）尾流的宽度随表面负电位值的增加而变窄。（２）随离子马赫数增加尾流位垒变宽；（３）对正电位表面情况尾流近区有电子聚集，并且离子的放空更远。     

A Geosynchronous Orbit Search Strategy

Since more than 10 years there is evidence that small-size space debris is accumulating in the geosynchronous orbit (GEO), probably as the result of breakups. Two break-ups have been reported in GEO. The 1978 break-up of an EKRAN 2 satellite, SSN 10365, was identified in 1992, and in 1992 a Titan 3C Transtage, SSN 3432, break-up produced at least twenty observable pieces. Subsequently several nations performed optical surveys of the GEO region in the form of independent observation campaigns. Such surveys suffer from the fact that the field of view of optical telescopes is small compared with the total area covered by the GEO ring. As a consequence only a small volume of the orbital element-magnitude-space is covered by each individual survey. Results from these surveys are thus affected by observational biases and therefore difficult to compare. This paper describes the development of a common search strategy to overcome these limitations. The strategy optimizes the sampling for objects in orbits similar to the orbits of the known GEO population but does not exclude the detection of objects with other orbital planes. A properly designed common search strategy clearly eases the comparison of results from different groups and the extrapolation from the sparse (biased) samples to the entire GEO environment.     

基于脉冲超宽带的星载高速无线数据网络设计

针对卫星内高速数据通信现有的点对点LVDS线缆通信带来的线缆束缚、布局困难、成本增加的难题,提出一种基于脉冲超宽带的星载高速无线数据网络设计方案,介绍了脉冲超宽带收发机、高速无线网络协议和无线网络节点软硬件设计的关键技术.发射机采用阶跃恢复二级管（SRD）产生皮秒级脉冲信号;超宽带脉冲接收采用幅度检测方法;无线高速网络协议设计参考美国军用数据总线标准MIL-STD-1553B协议,采用时分制指令响应机制,对1553B标准的许多指标进行扩展以适应UWB无线信道和高速传输特点,并通过FPGA成功实现.测试显示,地面演示系统应用层数据传输误码率小于10^-9,表明了基于脉冲超宽带的星载高速数据网络设计的可行性和可靠性.

     

克服地球轨道空间碎片的航天器防护结构几何规划设计

文章描述了一个用于航天器防护结构综合优化的独特方法——几何规划优化技术,以减小暴露于流星体和空间碎片超高速碰撞环境下的航天器防护结构系统的重量。空间碎片和流星体环境由广义加权目标函数的公式来定义。通过Wilkinson,Burch和Nysmith超高速碰撞预示模型说明几何规划的性能。表明遵循几何规划形式的超高速碰撞模型,可以进行综合非线性设计优化。     

空间系绳碎片碰撞生存能力研究

空间系绳结构和几何尺寸对其在复杂空间环境中抵抗碎片碰撞的能力有显著影响.本文根据系绳-碎片碰撞模型和泊松分布,计算了双股系绳和带状系绳被碎片割断的概率,分析了太空碎片对系绳生存能力可能造成的影响.双股系绳是由两条平行系绳每隔一段距离打结连接构成,带状系绳可视为一种横截面为矩形的特殊单股系绳.首先对单股系绳被碎片割断的概率进行建模,然后构建双股系绳和带状系绳生存能力函数,最后根据空间碎片环境模型,对比分析具有不同结构、不同尺寸的系绳的生存能力.仿真结果表明,相较于单股系绳,双股系绳和带状系绳的生存能力有明显提高.     

Collision Risk Mitigation in Geostationary Orbit

The short- and long-term effects of spacecraft explosions, as a function of the end-of-life re-orbit altitude above the geostationary orbit (GEO), were analyzed in terms of their additional contribution to the debris flux in the GEO ring. The simulated debris clouds were propagated for 72yrs, taking into account all the relevant orbital perturbations.The results obtained show that 6–7 additional explosions in GEO would be sufficient, in the long term, to double the current collision risk with sizable objects in GEO. Unfortunately, even if spacecraft were to re-orbit between 300 and 500km above GEO, this would not significantly improve the situation. In fact, an altitude increase of at least 2000km would have to be adopted to reduce by one order of magnitude the long-term risk of collision among geostationary satellites and explosion fragments. The optimal debris mitigation strategy should be a compromise between the reliability and effectiveness of spacecraft end-of-life passivation, the re-orbit altitude and the acceptable debris background in the GEO ring. However, for as long as the re-orbit altitudes currently used are less than 500km above GEO, new spacecraft explosions must be avoided in order to preserve the geostationary environment over the long term.     

Modelling of Spall in an Anisotropic Aluminium Alloy

Spall caused by hypervelocity impacts at the lower range of velocities could result in significant damage to spacecraft. A number of polycrystalline alloys, used in spacecraft manufacturing, exhibit a pronounced anisotropy in their mechanical properties. The aluminium alloy AA 7010, whose orthotropy is a consequence of the meso-scale phase distribution or grain morphology, has been chosen for this investigation. The material failure observed in plate impact was simulated using a number of spall models. The Hugoniot elastic limit and spall strength have been studied as a function of orientation, and compared to experimental results.     

带充液腔的自旋卫星稳定性问题

本文应用Pfeiffer的思想讨论带轴对称充液腔的卫星系统自旋稳定性。本方法的基本思想为将轴对称腔内的液体旋度平均化,使之与空间位置无关,由此将液体的无限自由度问题离散化为有限自由度问题,从而用线性理论讨论系统的自旋稳定性。用这方法,本文讨论了带充液腔的非轴对称卫星系统、带充液腔的双自旋卫星系统的自旋稳定性,给出了它们的自旋稳定性判据。此外,本文还给出了一些带有不同形状腔体的卫星系统自旋稳定域图,为实际工程设计人员提供理论参考。