空间相机热平衡试验温度预测方法改进及应用

为实现对航天器热平衡试验平衡温度的预测,建立了热平衡温度预测的方程式,对影响预测结果的各参数进行了分析。首先,由节点网络法推导出平衡温度表达式,介绍了其基于非线性最小二乘法的求解过程,建立了平衡温度的迭代方程;其次,结合大量的试验数据,对影响迭代结果的3个因素进行了统计分析,并最终确定了各因素的合理取值范围;最后,利用温度预测程序对某空间相机热平衡试验中低温工况的平衡温度进行了预测,并与试验结束后的结果进行了对比。结果表明,预测温度与试验数据的误差为±1℃（在3%之内）,满足精度要求,对热平衡温度准确的预测有效的缩短了试验时间,节省试验费用。     

抗辐射模拟CMOS集成电路研究与设计

为研究宇宙辐射环境中航天器里的模拟互补金属氧化物半导体(Complementary Metal Oxide Semiconductor,CMOS)集成电路性能和各种效应,并在辐射效应所产生机制的基础上,从设计和工艺方面提出了模拟CMOS集成电路主要抗辐射加固设计方法.在宇宙环境中,卫星中的模拟CMOS集成电路存在CMOS半导体元器件阈值电压偏离、线性跨导减小、衬底的漏电流增加和转角1/f噪声幅值增加.所以提出了3种对模拟CMOS集成电路进行抗辐射加固的方法:1)抗辐射模拟CMOS集成电路的设计;2)抗辐射集成电路版图设计;3)单晶半导体硅膜(Silicon on Insulator,SOI)抗辐射工艺与加固设计.根据上面的设计方法研制了抗辐射加固模拟CMOS集成电路,可以取得较好的抗辐射效果.     

Estimation of ballistic coefficients of low altitude debris objects from historical two line elements

This paper presents a new method for estimating ballistic coefficients (BCs) of low perigee debris objects from their historical two line elements (TLEs). The method uses the drag perturbation equation of the semi-major axis of the orbit. For an object with perigee altitude below 700 km, the variation in the mean semi-major axis derived from the TLE is mainly caused by the atmospheric drag effect, and therefore is used as the source in the estimation of the ballistic coefficient. The method is tested using the GRACE satellites, and a number of debris objects with external ballistic coefficient values, and agreements of about 10% are achieved.     

电离辐照诱发面阵电荷耦合器暗信号增大试验

针对电荷耦合器件(CCD)在空间轨道环境中应用时易受到辐射损伤的影响,对面阵CCD的电离辐照损伤效应问题进行了试验研究.首先,通过开展面阵CCD60 Co γ射线电离辐照效应试验,在暗场条件下测试了面阵CCD辐照后输出信号随积分时间的变化,并拟合计算出暗信号斜率.然后,对比分析了不同偏置条件下辐照后暗信号退化的试验规律;分析了不同偏置条件下辐照后暗信号的退火恢复情况;分析了不同积分时间、不同总剂量下的暗信号不均匀性的变化规律.最后,阐述了电离辐照损伤诱发面阵CCD暗信号增大的物理机制.结果表明:面阵CCD对电离辐照损伤很敏感,在进行航天器成像系统设计时,要充分考虑CCD受电离辐照损伤带来的影响.     

Signatures of strong geomagnetic storms in the equatorial latitude

Ionosonde data from two equatorial stations in the African sector have been used to study the signatures of four strong geomagnetic storms on the height – electron density profiles of the equatorial ionosphere with the objective of investigating the effects and extent of the effects on the three layers of the equatorial ionosphere. The results showed that strong geomagnetic storms produced effects of varying degrees on the three layers of the ionosphere. Effect of strong geomagnetic storms on the lower layers of the equatorial ionosphere can be significant when compared with effect at the F2-layer. Fluctuations in the height of ionization within the E-layer were as much as 0% to +20.7% compared to −12.5% to +8.3% for the F2-layer. The 2007 version of the International Reference Ionosphere, IRI-07 storm-time model reproduced responses at the E-layer but overestimated the observed storm profiles for the F1- and F2-layers.     

基于故障行为模型的产品寿命分析方法

针对传统可靠性工程方法无法满足高可靠长寿命需求产品设计与分析要求的现状。本文充分考虑引起产品寿命分散性的内因和外因的不确定性,在产品功能模型或数字样机模型的基础上,结合产品的故障行为模型,建立了一种基于产品故障行为模型的产品寿命分析方法。在该方法中,内因参数与外因参数的分散性分别可以用相应的概率密度函数来表示,都是通过对实际使用情况和生产条件的估计得到的,因此,按照这种方法评估得到的产品寿命特征,能够弥补基于故障物理的可靠性预计方法无法体现产品正常使用条件的不足。      

Spacecraft survivability in the natural debris environment near the stable Earth-Moon Lagrange points

The theoretical analysis of the motion of natural space debris near the stable Earth-Moon Lagrange Points, $L_4$ and $L_5$, is presented with a focus on the potential debris risks to spacecraft operating near these points. Specifically, the research formulates a debris propagation model using four-body dynamics, then applies candidate probabilistic survivability models to a notional spacecraft operating at the $L_4$ and $L_5$ Lagrange points to quantify the collision risks to the spacecraft from natural debris particles. Of the survivability models implemented, the natural debris collision risks to spacecraft survivability are found to be incredibly low, but mitigation strategies to reduce the risk further are identified in this study. Overall, research into stable Lagrange point natural debris propagation improves understanding of the collision risks posed by the naturally occurring Kordylewski clouds and enhances operational planning for Lagrange point space missions.     

石英玻璃的等离子体抛光技术研究现状

具有耐腐蚀、热膨胀系数低等诸多优良物理化学特性的石英玻璃在高性能光学系统中被广泛使用。要求元件达到纳米级别的表面粗糙度,而且没有损伤层和残余应力,因此精加工之后的超精密抛光工序尤为重要。本文介绍了气囊、磁流变、弹性发射、离子束等几种石英玻璃的精密抛光方法,侧重阐述了国内外等离子体的抛光技术,包括等离子体辅助化学刻蚀、等离子体喷射加工、等离子化学蒸发加工研究进展及取得的成果;且对等离子体的未来发展进行概述。     

微阴极电弧推力器羽流探针诊断研究

微阴极电弧推力器（micro-cathode arc thruster,μCAT）具备功率低和结构简单的特点,能够满足微纳卫星的任务需求,具有良好的发展前景。μCAT羽流的诊断可以揭示推力器的加速机理,对提高其性能具有重要意义。利用朗缪尔三探针对μCAT羽流进行诊断,得到了μCAT羽流不同位置的电子温度、电子密度和离子速度等羽流特性,研究了外加磁场、充电时间和阴极材料对羽流特性的影响。研究结果表明,μCAT放电初期产生的等离子体电子温度较高,密度较大;随着等离子体向下游运动,电子温度和电子密度降低,离子速度增大;外加磁场的磁感应强度越强,电子温度和离子速度越高,电子密度有所降低;磁场位置适当向推力器下游平移,能够有效提高推力器中轴线的电子密度;μCAT充电时间越长,电子温度、电子密度和离子速度越大;相比于CuW和AgW阴极,Ti阴极羽流的电子温度更高,电子密度更低。