数字全息测量超高速撞击碎片云实验研究

在中国空气动力研究与发展中心(CARDC)超高速碰撞中心(HIRC)7.6 mm超高速碰撞设备的基础上，搭建纳秒级脉冲激光数字全息系统。提出滤波片和衰减片组合布置，减弱超高速碰撞等离子体自发光、提高信噪比的方法。实验获得了2.25 mm铝球弹丸以4.0 km/s的速度撞击0.5 mm厚铝板形成碎片云的全息图。采用小波变换算法对碎片云全息图进行重建，得到超高速撞击碎片云的三维结构和碎片大小。碎片云的轮廓呈椭球型，分为碎片云的前端、核心和外壳，碎片主要分布在弹丸破碎形成的碎片云核心，存在大碎片，且分布较集中，对后板的损伤也严重     

Simultaneous state and actuator fault estimation for satellite attitude control systems

In this paper, a new nonlinear augmented observer is proposed and applied to satellite attitude control systems. The observer can estimate system state and actuator fault simultaneously. It can enhance the performances of rapidly-varying faults estimation. Only original system matrices are adopted in the parameter design. The considered faults can be unbounded, and the proposed augmented observer can estimate a large class of faults. Systems without disturbances and the fault whose finite times derivatives are zero piecewise are initially considered, followed by a discussion of a general situation where the system is subject to disturbances and the finite times derivatives of the faults are not null but bounded. For the considered nonlinear system, convergence conditions of the observer are provided and the stability analysis is performed using Lyapunov direct method. Then a feasible algorithm is explored to compute the observer parameters using linear matrix inequalities (LMIs). Finally, the effectiveness of the proposed approach is illustrated by considering an example of a closed-loop satellite attitude control system. The simulation results show satisfactory perfor-mance in estimating states and actuator faults. It also shows that multiple faults can be estimated successfully.     

基于纯比例导引的拦截碰撞角约束制导策略

拦截碰撞角约束制导是当前导弹制导研究的关键问题之一。首先基于理想比例导引（IPN）律拦截非机动目标的解析解,推导了纯比例导引律（PPN）拦截固定目标的解析解,得到了弹目相对距离、制导指令加速度和导弹前置角的显示表达式,并进一步得到了拦截碰撞角与弹目相对运动状态和比例导引系数之间的解析表达式。其次,基于该解析表达式,提出了基于PPN的拦截碰撞角约束制导策略（PPNIACG）,并探讨了在铅垂面内进行落角约束打击和水平面内进行拦截碰撞角约束打击的2种实现方式。最后,以弹道成型制导律（TSG）和最优碰撞角约束制导律（OIACG）为参考,通过数值仿真算例,对PPNIAC的拦截性能进行了对比分析,验证了所提出制导策略的有效性和正确性。     

In-orbit assessment of laser retro-reflector efficiency onboard high orbiting satellites

The navigation and geodetic satellites that orbit the Earth at altitudes of approximately 20,000 km are tracked routinely by many of the Satellite Laser Ranging (SLR) stations of the International Laser Ranging Service (ILRS). In order to meet increasing demands on SLR stations for daytime and nighttime observations, any new mission needs to ensure a strong return signal so that the target is easily acquirable. The ILRS has therefore set a minimum effective cross-section of 100 million square metres for the on-board laser retro-reflector arrays (LRAs) and further recommends the use of ‘uncoated’ cubes in the arrays. Given the large number of GNSS satellites that are currently supported by SLR, it is informative to make an assessment of the relative efficiencies of the various LRAs employed. This paper uses the laser ranging observations themselves to deduce and then compare the efficiencies of the LRAs on the COMPASS-M1 navigation satellite, two satellites from the GPS and three from the GLONASS constellations, the two GIOVE test satellites from the upcoming Galileo constellation, the two Etalon geodetic spheres and the geosynchronous communications test satellite, ETS-8. All the LRAs on this set of satellites employ back-coated retro-reflector cubes, except those on the COMPASS-M1 and ETS-8 vehicles which are uncoated. A measure of return signal strength, and thus of LRA-efficiency, is calculated using the laser-range full-rate data archive from 2007 to 2010, scaled to remove the effects of variations in satellite range, atmospheric attenuation and retro-reflector target total surface area. Observations from five SLR stations are used in this study; they are Herstmonceux (UK), Yarragadee (Australia), Monument Peak and McDonald (USA) and Wettzell (Germany). Careful consideration is given to the treatment of the observations from each station in order to take account of local working practices and system upgrades. The results show that the uncoated retro-reflector cubes offer significant improvements in efficiency.     

Quantifying the role of solar radiative forcing over the 20th century

The 20th century temperature anomaly record is reproduced using an energy balance model, with a diffusive deep ocean. The model takes into account all the standard radiative forcings, and in addition the possibility of a non-thermal solar component. The model is parameterized and then optimized to produce the most likely values for the climate parameters and radiative forcings which reproduce the 20th century global warming. We find that the best fit is obtained with a negligible net feedback. We also show that a non-thermal solar component is necessarily present, indicating that the total solar contribution to the 20th century global warming, of ΔT_solar = 0.27 ± 0.07 °C, is much larger than can be expected from variation in the total solar irradiance alone. However, we also find that the largest contribution to the 20th century warming comes from anthropogenic sources, with ΔT_man = 0.42 ± 0.11 °C.     

Protecting Earth-orbiting spacecraft against micro-meteoroid/orbital debris impact damage using composite structural systems and materials: An overview

Spacecraft that are launched to operate in Earth orbit are susceptible to impacts by meteoroids and pieces of orbital debris (MMOD). The effect of a MMOD particle impact on a spacecraft depends on where the impact occurs, the size, composition, and speed of the impacting object, the function of the impacted system. In order to perform a risk analysis for a particular spacecraft under a specific mission profile, it is important to know whether or not the impacting particle (or its remnants) will exit the rear of an impacted spacecraft wall. A variety of different ballistic limit equations (BLEs) have been developed for many different types of structural wall configurations. BLEs can be used to optimize the design of spacecraft wall parameters so that the resulting configuration is able to withstand the anticipated variety of on-orbit high-speed impact scenarios. While the level of effort exerted in studying the response of metallic multi-wall systems to high speed particle impact is quite substantial, the extent of the effort to study composite material and composite structural systems under similar impact conditions has been much more limited. This paper presents an overview of the activities performed to assess the resiliency of composite structures and materials under high speed projectile impact. The activities reviewed will be those that have been aimed at increasing the level of protection afforded to spacecraft operating in the MMOD environment, and more specifically, on those activities performed to mitigate the mechanical and structural effects of an MMOD impact.     

气动换向阀阀芯/阀座撞击特性研究

针对某型气动换向阀在研制过程中出现由于阀芯/阀座撞击变形导致阀芯卡死的现象,对阀芯/阀座的撞击特性进行了仿真研究,定量分析了撞击过程以及不同阀座高度对撞击特性的影响,根据仿真结果对换向阀进行了改进设计,试验结果表明改进后的换向阀满足使用要求.     

Determination of station positions and velocities from laser ranging observations to Ajisai,Starlette and Stella satellites

The positions and velocities of the four Satellite Laser Ranging (SLR) stations: Yarragadee (7090), Greenbelt (7105), Graz (7839) and Herstmonceux (7840) from 5-year (2001–2005) SLR data of low orbiting satellites (LEO): Ajisai, Starlette and Stella were determined. The orbits of these satellites were computed from the data provided by 20 SLR stations. All orbital computations were performed by means of NASA Goddard’s GEODYN-II program. The geocentric coordinates were transformed to the topocentric North–South, East–West and Vertical components in reference to ITRF2005. The influence of the number of normal points per orbital arc and the empirical acceleration coefficients on the quality of station coordinates was studied. To get standard deviation of the coordinates determination lower than 1 cm, the number of the normal points per site had to be greater than 50. The computed positions and velocities were compared to those derived from LAGEOS-1/LAGEOS-2 data. Three parameters were used for this comparison: station coordinates stability, differences from ITRF2005 positions and velocities. The stability of coordinates of LEO satellites is significantly worse (17.8 mm) than those of LAGEOS (7.6 mm), the better results are for Ajisai (15.4 mm) than for Starlette/Stella (20.4 mm). The difference in positions between the computed values and ITRF2005 were little bit worse for Starlette/Stella (6.6 mm) than for LAGEOS (4.6 mm), the results for Ajisai were five times worse (29.7 mm) probably due to center of mass correction of this satellite. The station velocities with some exceptions were on the same level (≈1 mm/year) for all satellites. The results presented in this work show that results from Starlette/Stella are better than those from Ajisai for station coordinates determination. We can applied the data from LEO satellites, especially Starlette and Stella for determination of the SLR station coordinates but with two times lower accuracy than when using LAGEOS data.     

Satellite and ground detection of very dense smoke clouds produced on the islands of the Paraná river delta that affected a large region in Central Argentina

Intense fires were produced on the Paraná river delta islands, Argentina, during most part of 2008, by a combination of an exceptionally dry period and the farmers’ use of a fire land-cleaning technique. In April 2008, those fires significantly affected the nearby regions and their inhabitants, from Rosario city to Buenos Aires mega-city. In this work we present satellite as well as ground Aerosol Optical Depth (AOD) at 550 nm data obtained during the propagation of pollution clouds to the central zone of Argentina. The highest value (1.18) was registered at Buenos Aires by atmospheric remote sensing, using the satellite instrument MODIS/Terra on April 18th 2008 at 10:35 local time (= UT − 3 h). On the same day, ground air quality detectors also measured in this city the highest Total Suspended Particle (TSP) value of the month, 2.02 mg/m³. The AOD(550) daily variation at Rosario Astronomical Observatory, which is located near the Paraná riverside, was derived by combining solar ultraviolet erythemal irradiance data (measured with a YES biometre) with model calculations. On April 25th 2008, from 12:00 to 15:30 local time, a rather high and constant AOD(550) value was registered, with a mean value of (0.90 ± 0.21). Cities located on the side of the Rosario–Buenos Aires highway (San Nicolás, Baradero and San Pedro) were also affected, showing a mean AOD(550) between the Rosario and Buenos Aires values. The particulate matter was collected with gridded samplers placed on the Paraná river islands as well as at the Rosario Observatory. They were analysed with a Scanning Electron Microscope (SEM) and mainly showed a biological origin. Even if normally large particles travel small distances from the source, organic aerosol in the range of 40–100 μm and complex asymmetric structures were registered several kilometres away from the aerosol sources on the islands. Another event of intense UV index attenuation (98.6%) occurred on September 18th 2008, due to very dense smoke clouds that extended over the Rosario area for several hours. The clouds were driven away from the fires by East–northeast and East–southeast winds. The minimum value of this index measured around noon allows to derive a maximum AOD(550)_max = (3.65 ± 0.90) at 12:45 local time. Soot clouds extended over the Paraná river, transporting Burned Biomass Debris (BBD) that deposited on Rosario. In particular, burned leaves and small branches with dimensions of 1–20 cm were collected. The mean (BBD) particles deposited on the ground from 7:00 to 19:00 local time were (0.92 ± 0.20) BBD/(m² h).