自动钻铆装备的激光测量系统法向误差研究

飞机装配中铆接部位的孔垂直度直接影响铆钉的连接质量和疲劳寿命,进而影响飞机的力学性能。为了保证飞机铆接垂直度要求,必须分析自动钻铆系统法向误差的影响因素。首先,确定了倾角误差、数学模型的线性误差与法向误差的关系。其次,给出了激光位移传感器安装参数的选取规律,并研究了其对位姿标定的影响。最后,实验验证了安装参数优化后的实际效果。研究结果可为法向测量装置的设计与分析提供理论指导,对于提升自动钻铆系统的法向精度,进而保证孔垂直度要求具有重要意义。     

基于形貌优化法的无轴承开关磁阻电机减振降噪

脉振的径向电磁力作为激励源作用于12/8极单绕组宽转子齿无轴承开关磁阻电机（Bearingless switched reluctance motor with wider rotor teeth,BSRMWR）的定子齿面并传送至定子轭部及机壳,会引发较大的振动噪声,阻碍其推广应用。针对这一问题,本文从本体结构的角度入手对电机壳体进行优化改进。采用三维多物理场有限元模型,建立了BSRMWR电磁-结构-振动-声场耦合模型。通过对BSRMWR电磁场进行瞬态分析,得到径向电磁力。将模态应变能方法应用于BSRMWR的壳体得到电机外壳结构有较大的应变能,说明电机壳体结构的薄弱。基于此,通过形貌优化的方法对电机的壳体结构进行优化。结果表明,采用形貌优化后机壳结构的BSRMWR,其振动和噪声均有显著改善。     

空间平台发射拦截器动力学与最优脉冲拦截

研究了空间平台发射拦截器的两体耦合动力学,以及拦截器拦截目标星的最优脉冲控制问题。平台首先与目标星形成绕飞关系,保持其发射筒轴线始终瞄准目标星。接到发射指令后,拦截器从发射筒中射出,本文采用拉格朗日第二类方程建立了发射过程平台-拦截器两体动力学模型。因为两体耦合影响,平台姿态偏转,拦截器出筒时的速度已经不能瞄准目标星。通过小型火箭发动机给其施加速度脉冲,使其进入拦截轨道,保证拦截的同时,将脉冲速度最小化以节省燃料,本文将其归结为一个非线性规划问题,采用三级优化的策略来求解。在拦截飞行时间相较于平台绕飞目标星的周期是小量的条件下,可以视绕飞平均角速度为小参数,采用正则摄动方法求出非线性规划的一阶近似解,然后以此为迭代初值,寻找最优真解。最后进行了数值仿真验证。     

Precipitation behavior and properties of extruded 7136 aluminum alloy under different aging treatments

In this work, the mechanical properties and electrical conductivity of the extruded 7136 aluminum alloy treated by single-stage aging treatment (T6), retrogression and re-aging treatment (RRA), and multiple retrogression and re-aging treatment have been investigated by means of hardness measurements, electrical conductivity tests and tensile tests. The results have shown that the properties of the 7136 alloy such as hardness, tensile strength and electrical conductivity were sensitive to retrogression time (within 90 min). With prolonging the retrogression time, the tensile strength was enhanced first and then decreased, yet the electrical conductivity was continuously increased. The 60 min-treated alloy performed the highest tensile strength (716 MPa), whereas the 90 min-treated alloy possessed the highest electrical conductivity (33.95%IACS). Compared with the T6-treated alloy, the tensile strength and electrical conductivity were improved by 3.3% and 18.9%, respectively. The electrical conductivity showed an obvious increase with repetitious times of the RRA treatment. After 3RRA60 treatment, a good combination of tensile strength (705 MPa) and electrical conductivity (33.20%IACS) can be obtained. Compared with the T6 condition, the tensile strength and electrical conductivity were improved by 1.7% and 16.3%, respectively. The mechanism of microstructure evolution under different aging treatments has been discussed in detail.     

无人机电静液起落架收放及刹车系统仿真研究

无人机起落架收放及刹车系统在无人机的起飞、降落和刹车的过程中发挥着至关重要的作用,随着无人机飞行条件和要求的日益严苛,传统的液压系统已经无法满足需要。电静液系统既保留了传统液压系统的优点,又兼备电作动的优势。根据电静液作动器的工作原理,设计一款无人机起落架收放和刹车功能一体化的电静液系统,将改进型的PID 控制方式运用到起落架收放的控制中,并且设计两种模糊PID 控制方式运用于防滑刹车功能中,在此基础上进行基于AMESim 和MATLAB/Simulink 的联合仿真用于验证系统性能,并对仿真结果进行对比分析。结果表明：模糊PID 的控制方式控制效果良好,可以有效地改善无人机起落架收放和刹车过程的稳定性,使得起落架收放更安全,刹车效率更高。     

基于工厂模式的OSLC数据集成接口设计与实现

复杂软件系统往往由不同地域的研发团队采用不同的开发工具来协同完成,研发过程中存在数据难以集成的问题.基于开放式生命周期协作服务(OSLC)规范来设计软件协同开发数据接口,有利于提高软件协同开发的效率.首次结合工厂模式和OSLC规范设计并实现数据集成接口,将不同工具的数据集成抽象成统一的公共接口,从而采用统一的数据接口和...     

A null frame for spacetime positioning by means of pulsating sources

We introduce an operational approach to the use of pulsating sources, located at spatial infinity, for defining a relativistic positioning and navigation system, based on the use of four-dimensional bases of null four-vectors, in flat spacetime. As a prototypical case, we show how pulsars can be used to define such a positioning system. The reception of the pulses for a set of different sources whose positions in the sky and periods are assumed to be known allows the determination of the user’s coordinates and spacetime trajectory, in the reference frame where the sources are at rest. We describe our approach in flat Minkowski spacetime, and discuss the validity of this and other approximations we have considered.     

Evolution of periodic orbits near the Lagrangian point L2

A study of the evolution of the periodic and the quasi-periodic orbits near the Lagrangian point L₂, which is located to the right of the smaller primary on the line joining the primaries and whose distance from the more massive primary is greater than the distance between the primaries, in the framework of restricted three-body problem for the Sun–Jupiter, Earth–Moon (relatively large mass ratio) and Saturn–Titan (relatively small mass ratio) systems is made. Two families of periodic orbits around the smaller primary are identified using the Poincaré surface of section method – family I (initially elliptical, gradually becomes egg-shaped with the increase in the Jacobi constant C and elongated towards the more massive primary) and family II (initially egg-shaped orbits elongated towards L₂ and gradually becomes elliptical with the increase in C). The family I in the Sun–Jupiter and Saturn–Titan systems contains two separatrix caused by third-order and fourth-order resonances, while the Earth–Moon system has only one separatrix which is caused by third-order resonances. Also in the Sun–Jupiter and the Saturn–Titan systems, family I merge with family II, around Jacobian constant 3.0393 and 3.0163, respectively, while in the Earth–Moon system, family II evolves separately from two different branches. The two branches merge at C = 3.184515. In the Earth–Moon system, the family II contains a separatrix due to third-order resonances which is absent in the other two systems.     

廊坊市市区水资源规划治理研究

水资源是人类赖以生存的资源,现今,水资源已成为制约我国民经济发展的障碍,如何在充分利用水资源、保护水资源的基础上发展经济,是实现可持续发展的重要条件。本文通过对废水排放量和规划用水量的预测,对廊坊市未来的水资源利用规划提出建议,实现可持续发展。     

Mining Spatial Associations with Limited Sensory Information

Abstract

Human navigation in an unknown environment requires an understanding of the spatial relationships of the terrain. For example, a soldier who is on a reconnaissance mission in a new city needs to “know” the spatial layout of the surroundings with high confidence. Oftentimes, this understanding must be acquired within a very short amount of time and with limited sensory inputs. The soldier would benefit from a digital avatar that draws inferences about the spatial layout of the city based on an initial set of observations and guides the soldier either in further exploring the environment or in making decisions based on these inferences. In this paper, we present and evaluate an inductive approach to learning spatial associations using sensory data that is available from the simulation environment of a computer game, Unreal Tournament. We study two kinds of spatial relationships between nodes on a level of a game map: nodes that are placed near each other to satisfy some spatial requirement and nodes that are placed near each other to satisfy the design preferences of a level architect. We show that we can infer both kinds of relationships using an association rule mining algorithm. Furthermore, we show how to use an ontology to distinguish between these relationships in order to discover different types of spatial arrangements on a specific map. We discuss how the inferred associations can be used to control an avatar that makes recommendations for navigating unexplored areas on a map. We conclude with some thoughts on the applicability of our methods to scenarios in the real world, beyond the simulation environment of a game, and on how the learned associations can be represented and queried by a simple question-answer type system.