Phase Space Density Analysis of Energy Transport in the Earth’s Magnetotail

Two energetic events in the Earth’s magnetotail detected by Geotail are examined with detailed analysis of three-dimensional velocity phase space density. It is found that the occurrence of multiple ion components is high during these dynamic episodes. Different populations evolve independently of each other, suggesting particles from multiple activity sites contributing to the observed phase space density. The transport properties with consideration of multiple components are evaluated, with the result showing significant differences from those based on a single fluid approach. This comparison indicates that precise evaluation of the energy and magnetic flux transport of energetic events in the magnetotail requires resolving individual populations in the phase space density.     

碱金属引射对尾流化学动力学和电子密度的影响

用把碱金属（Na）加入到空气尾流中进行数值模拟的方法,研究了碱金属引射对高超声速尾流化学动力学和电子密度的影响。采用的化学反应模型为包括O2、N2、O、N、NO、NO＋、Na 、Na、O2-及e-的10组元模型。计算结果表明,碱金属引射,使尾流电子数密度增加1～3个量级。计算结果与文献中的数据符合较好。     

炮击振动试验谱的预计

 <正> 军用飞机机炮附近区域,最严重的振动环境主要是射击时传递到飞机主要结构上的冲击压力脉冲所诱导的强烈振动场所引起的。这种环境,随着距炮口距离的增加,其作用明显减弱。距炮口2 m半径范围内敏感的机载设备受炮击振动影响较大,2 m半径以外炮击振动的量值衰减很快。炮击振动试验谱一般是根据炮击实测数据经分析归纳后提供的。对于新研制的飞机来说,在方案论证阶段和初步设计阶段,在无实测数据的情况下,只能根据有关规范进行估算和参考原准机的经验修正,给出初步的炮击振动试验谱。     

酸酐固化剂对硅橡胶低密度烧蚀材料施工期的影响

通过对延长硅橡胶密度烧蚀材料体系施工期的研究，发现酸酐固化剂可以将环氧改性硅橡胶低密度烧蚀材料的施工期延长到24h以上，从而可能实现真空热压罐大面积灌注密度烧蚀材料的成型工艺。通过对固化材料进行红外分析，发现加入酸酐固化剂后并未改变硅橡胶和环氧树脂各自的反应，没有新的反应特征峰出现，说明环氧和硅橡胶之间无反应，只是物理共混，从材料拉伸断面的扫描电镜观察可以证实硅橡胶和环氧树脂以海－岛结构存在。     

功率谱密度(PSD)在评价超精密光学表面中的应用研究

用原子力显微镜对不同工艺下获得的超光滑反射镜基片进行了功率谱密度(PSD)检测,并对结果进行分析,以指导光学元件加工。     

Magnetosphere Imaging Instrument (MIMI) on the Cassini Mission to Saturn/Titan

The magnetospheric imaging instrument (MIMI) is a neutral and charged particle detection system on the Cassini orbiter spacecraft designed to perform both global imaging and in-situ measurements to study the overall configuration and dynamics of Saturn’s magnetosphere and its interactions with the solar wind, Saturn’s atmosphere, Titan, and the icy satellites. The processes responsible for Saturn’s aurora will be investigated; a search will be performed for substorms at Saturn; and the origins of magnetospheric hot plasmas will be determined. Further, the Jovian magnetosphere and Io torus will be imaged during Jupiter flyby. The investigative approach is twofold. (1) Perform remote sensing of the magnetospheric energetic (E > 7 keV) ion plasmas by detecting and imaging charge-exchange neutrals, created when magnetospheric ions capture electrons from ambient neutral gas. Such escaping neutrals were detected by the Voyager l spacecraft outside Saturn’s magnetosphere and can be used like photons to form images of the emitting regions, as has been demonstrated at Earth. (2) Determine through in-situ measurements the 3-D particle distribution functions including ion composition and charge states (E > 3 keV/e). The combination of in-situ measurements with global images, together with analysis and interpretation techniques that include direct “forward modeling’’ and deconvolution by tomography, is expected to yield a global assessment of magnetospheric structure and dynamics, including (a) magnetospheric ring currents and hot plasma populations, (b) magnetic field distortions, (c) electric field configuration, (d) particle injection boundaries associated with magnetic storms and substorms, and (e) the connection of the magnetosphere to ionospheric altitudes. Titan and its torus will stand out in energetic neutral images throughout the Cassini orbit, and thus serve as a continuous remote probe of ion flux variations near 20R _S (e.g., magnetopause crossings and substorm plasma injections). The Titan exosphere and its cometary interaction with magnetospheric plasmas will be imaged in detail on each flyby. The three principal sensors of MIMI consists of an ion and neutral camera (INCA), a charge–energy–mass-spectrometer (CHEMS) essentially identical to our instrument flown on the ISTP/Geotail spacecraft, and the low energy magnetospheric measurements system (LEMMS), an advanced design of one of our sensors flown on the Galileo spacecraft. The INCA head is a large geometry factor (G ∼ 2.4 cm² sr) foil time-of-flight (TOF) camera that separately registers the incident direction of either energetic neutral atoms (ENA) or ion species (≥5^∘ full width half maximum) over the range 7 keV/nuc < E < 3 MeV/nuc. CHEMS uses electrostatic deflection, TOF, and energy measurement to determine ion energy, charge state, mass, and 3-D anisotropy in the range 3 ≤ E ≤ 220 keV/e with good (∼0.05 cm² sr) sensitivity. LEMMS is a two-ended telescope that measures ions in the range 0.03 ≤ E ≤ 18 MeV and electrons 0.015 ≤ E≤ 0.884 MeV in the forward direction (G ∼ 0.02 cm² sr), while high energy electrons (0.1–5 MeV) and ions (1.6–160 MeV) are measured from the back direction (G ∼ 0.4 cm² sr). The latter are relevant to inner magnetosphere studies of diffusion processes and satellite microsignatures as well as cosmic ray albedo neutron decay (CRAND). Our analyses of Voyager energetic neutral particle and Lyman-α measurements show that INCA will provide statistically significant global magnetospheric images from a distance of ∼60 R _S every 2–3 h (every ∼10 min from ∼20 R _S). Moreover, during Titan flybys, INCA will provide images of the interaction of the Titan exosphere with the Saturn magnetosphere every 1.5 min. Time resolution for charged particle measurements can be < 0.1 s, which is more than adequate for microsignature studies. Data obtained during Venus-2 flyby and Earth swingby in June and August 1999, respectively, and Jupiter flyby in December 2000 to January 2001 show that the instrument is performing well, has made important and heretofore unobtainable measurements in interplanetary space at Jupiter, and will likely obtain high-quality data throughout each orbit of the Cassini mission at Saturn. Sample data from each of the three sensors during the August 18 Earth swingby are shown, including the first ENA image of part of the ring current obtained by an instrument specifically designed for this purpose. Similarily, measurements in cis-Jovian space include the first detailed charge state determination of Iogenic ions and several ENA images of that planet’s magnetosphere.This revised version was published online in July 2005 with a corrected cover date.     

复合推进剂高压下侵蚀燃烧特性的研究

讨论了少烟丁羟合推进剂高压下侵蚀燃烧与装药装填密度的关系，给出了计算变截面装药气流速度方程，总结了在此推进剂在Ｐ≥１５．０ＭＰａ下侵蚀燃烧规律，为装药设计提供了依据。     

SBS改性再生型木塑复合材料及其耐水性能

为了充分利用城市固体废弃物中的各项资源，本项工作将固体废弃物中的高密度聚乙烯（HDPE）回收后与废弃的木纤维、苯乙烯-丁二烯-苯乙烯（SBS）进行复合，成功地制备出SBS／再生型木塑复合材料，并进行了力学性能测试和水煮试验。结果表明，SBS的加入使木塑复合材料的冲击韧性得到显著改善，同时，复合材料的弯曲强度和弯曲模量没有明显的影响，表明SBS可以作为木塑复合材料的增韧剂。SBS／木塑复合材料经过8周、60℃的水煮后，复合材料的吸水率和厚度膨胀率均有所增加，弯曲模量和冲击韧性分别平均下降14．4％、10．8％。水煮试验初期复合材料的弯曲强度逐渐降低，然后又逐渐增大，第8周后弯曲强度增加的幅度约10％。木塑复合材料的冲击破坏模式以界面脱粘为主，而加入SBS后，复合材料的破坏以纤维断裂和基体断裂为主。     

恒温热源条件下实际回热式布雷顿循环的功率密度优化

计人工质与高、低温侧换热器和回热器的热阻损失、压气机和涡轮机中不可逆压缩和膨胀损失及管路系统中的压力损失，用有限时间热力学方法，导出了恒温热源条件下实际回热式布雷顿循环功率密度与压比间的解析式，借助于数值计算，研究了高、低温侧换热器和回热器的热导率分配对最大功率密度的影响。     

风洞试验中风剖面的模拟及近流场特性分析

首先简单介绍了日本东京工艺大学风工程研究中心新建的开环流低速边界层风洞中风剖面模拟的试验情况.基于试验结果,采用被广泛应用的三角尖劈加上布置粗糙元的方法,成功地模拟出日本建筑学会定义的四类不同场地对应的风剖面.通过对试验数据的比较分析,就所采用的立方体粗糙元及三角尖劈对最终模拟得到的风剖面特性的影响进行了比较分析.其次,对风剖面模拟及特性判定中的几个重要问题,如三角尖劈的形状优化、风速功率谱的一致性、积分尺度的分析方法等进行了分析.最后,基于以上分析,对在边界层风洞中模拟预定的风剖面提出几点参考意见.