RPC-MIP: the Mutual Impedance Probe of the Rosetta Plasma Consortium

The main objective of the Mutual Impedance Probe (MIP), part of the Rosetta Plasma Consortium (RPC), is to measure the electron density and temperature of Comet 67P/Churyumov-Gerasimenko’s coma, in particular inside the contact surface. Furthermore, MIP will determine the bulk velocity of the ionised outflowing atmosphere, define the spectral distribution of natural plasma waves, and monitor dust and gas activities around the nucleus. The MIP instrumentation consists of an electronics board for signal processing in the 7 kHz to 3.5 MHz range and a sensor unit of two receiving and two transmitting electrodes mounted on a 1-m long bar. In addition, the Langmuir probe of the RPC/LAP instrument that is at about 4 m from the MIP sensor can be used as a transmitter (in place of the MIP ones) and MIP as a receiver in order to have access to the density and temperature of plasmas at higher Debye lengths than those for which the MIP is originally designed.     

电子环束流对航天器表面电位和等离子体鞘层的影响

采用二维三分量静电粒子模拟程序研究了电子环束流对低轨道磁化等离子体中运行的航天器表面电位和等离子体鞘层结构的影响.当有电子束流平行磁场入射时,航天器表面所带负电位的绝对值将增大.电子束流的速度和密度的增加将使航天器表面负电位绝对值增加很快.与此同时等离子体鞘层的尺度也将增大,形状将由向尾部延伸的“泪滴”状变成向两侧展开的“机翼”状.当电子环束流以相对于磁场成一定角度斜入射时,由于磁场的约束作用,航天器表面负电位的绝对值将随入射角增大而减小.      

小功率电弧等离子体发动机试验及性能研究

电推进技术已应用于航天的多个领域,电弧等离子体发动机（Arcjet)因其高比冲、高推力／功率比以及大的推进剂选择范围等特点成为当前国际上电火箭研究和应用的热点。文章总结小功率Arcjet实验及性能研究,介绍了实验研究系统的主要组成,给出初步的发动机工作性能参数及实验结果分析。     

Charge-product control approach to electrostatic leader-follower formations in LEO plasma wakes

The feasibility of using electrostatic forces to stabilize a close-proximity leader-follower formation is investigated. The leader craft is equipped with a set of affixed spheres whose charge is modulated to hold the charged follower craft along a proscribed trajectory to its nominal leader-relative position. This charge structure and the follower craft are constrained to remain in the plasma wake generated behind all LEO craft because the more-dense ambient plasma outside the wake prevents object charging and electric field propagation. Once the formation is achieved, a controlled electric field is generated by the leader to counter relative accelerations from perturbations like differential drag and solar radiation pressure, holding the follow near its nominal position. Two controllers are derived for the system described, incorporating Coulomb accelerations and linearized gravity and drag accelerations. Simulations are run under unmodeled perturbations and sensor noise for different scenarios, demonstrating the challenges and benefits associated with electrostatic actuation.     

基于碱金属辅助电离的等离子鞘套模拟方法

为解决再入过程中通信黑障与探测异常问题，对等离子体鞘套地面模拟方法进行了研究。以RAM C-II 飞行试验为依据，计算了等离子体鞘套的参数范围。分析现有模拟设备，概括提出了高焓低速风洞的模拟方案，选取相适应的放电方式，并对流量功率进行了计算。针对高温环境对电磁设备造成损坏以及所需功率难以实现的问题，提出添加碱金属的解决方案，并进行了试验验证。试验结果表明，添加碱金属可以使电子密度提升约一个数量级。对方案效果进行评估，预期功率需求降至兆瓦量级。     

A method for automatic detection and characterization of plasma bubbles using GPS and BDS data

Detecting and characterizing Total Electron Content (TEC) depletion is important for studying the ionospheric threat due to the Equatorial Plasma Bubble (EPB) when applying the Ground-Based Augmentation System (GBAS) at low latitudes. This paper develops a robust method to automatically identify TEC depletion and derive its parameters. The rolling barrel algorithm is used to automatically identify the TEC depletion candidate and its parameters. Then, the depletion candidates are screened by several improved techniques to distinguish actual depletions from other phenomena such as Traveling Ionospheric Disturbance (TID) or abnormal data. Next, based on the depletion signals from three triangular receivers, the method derives EPB parameters such as velocity, width and gradient. The time lag and front velocity are calculated based on cross-correlation using TEC depletions and the geometrical distribution of three triangular receivers. The width and gradient of slope are then determined by using TEC depletion from a single receiver. By comparison, both the station-pair method and proposed method depend on the assumption that the EPB morphology is frozen during the short time when the plasma bubble moves between the receivers. However, our method relaxes the restriction that the baseline length should be shorter than the width of slope required by the station-pair. This relaxation is favorable for studying small-scale slope of depletions using stations of a longer baseline. In addition, the accuracy of the width and gradient is free of impact from hardware biases and small-scale disturbance, as it is based only on the relative TEC variation. The method is demonstrated by processing Global Positioning System (GPS) and BeiDou Navigation Satellite System (BDS) data on 15 August, 2018, in a solar minimum cycle.     

Results of measurements of the response of a delta-doped CCD to neutral and charged particle beams

We report the measurements of the response of a delta-doped Charge Coupled Device (CCD) in imaging mode to beams of charged and neutral particles. That is, the detector imaged the incident beam over its 1024 × 1024 pixels, integrating the number of particles counted in each pixel during the exposure period. In order to count individual particles the exposure time would have had to be reduced considerably compared to the typical ?5 s used in these studies. Our CCD thus operated in a different manner than do conventional particle detectors such as the CEM and MCP that normally are used in a particle counting mode. The measurements were carried out over an energy range from 0.8 to 30 keV. The species investigated include H, H⁺, He⁺, N⁺, N₂⁺, and Ar⁺. The energy and ion mass covered wider ranges than previous measurements for the CCD. The results of these measurements show, as in the case of the previous measurement, for a given ion the CCD response increases with energy and for a given particle energy the response decreases with increasing mass of the particle. These results are in agreement with predictions of the theory of the range of ions in solids. The results also show the possibility for the application of the delta doped CCD as a detector for low energy particle measurements for space plasma physics applications.     

Effect of the seed perturbation amplitude on the equatorial spread F initiation during solar minimum

The contribution of gravity wave (GW) to the initiation/development of spread F during a solar minimum year was investigated through the comparison of the observed precursory parameters and characteristics of the corresponding equatorial spread F (ESF) events. The ionospheric parameters were recorded at the magnetic equatorial station Sao Luis (2.3°S, 44°W, dip latitude 2°S) during March and October 2010. These data were used to estimate the influence of the relative gravity wave amplitude and the ambient ionospheric condition on the diurnal variation of the spread F initiation. The vertical velocity drift indicated a clear control and defines the threshold for the seasonal variability of the ESF occurrence. However, it was insufficient to solely determine or predict the day to day variation of ESF occurrence. Thus, few days with contrasting ambient ionospheric condition and magnitude of GW amplitude were analysed in order to investigate the role of the different precursory factors in the observed diurnal variation of the plasma irregularity development. The density scale length and gravity wave amplitude were shown to immensely contribute to the linear instability growth rate, especially during the days with a low post-sunset rise. Thus, the experimental observations have demonstrated the strong inter-dependence between the precursory factors and they have also highlighted the probable control of the ESF morphology.     

An in situ laser induced breakdown spectroscope (LIBS) for Chandrayaan-2 rover: Ablation kinetics and emissivity estimations

A miniaturized in situ laser induced breakdown spectroscope-LIBS is one of the two lunar rover payloads to be flown in India’s next lunar mission Chandrayaan-2, with an objective to carry-out a precise qualitative and quantitative elemental analyses of lunar regolith at the proximity of the landing region. As per the imposed mission constraints and the executed design optimization studies, a compact and light-weight LIBS prototype model is developed at our premises. This paper mainly concerns with the estimation of theoretical aspects; especially on evaluation of elemental ablation parameters and signal-to-noise ratio (SNR) calculations for the designed instrument. Theoretical estimations and simulations yielded an incident laser power density of the order of 5 × 10¹⁰ W/cm² on the target surface at a defined lens-to-surface distance (LTSD) of 200 mm and revealed an SNR > 100 for most of the elements under consideration. This paper also addresses the impact of LTSD variation on detection capability. The estimation of plasma-temperatures was carried out utilizing the emission spectra obtained under high vacuum environments employing the LIBS laboratory model. Experimental investigations and the performed theoretical estimations asserted the successful operation of the configured LIBS instrument for in situ elemental analyses on lunar surface.