航空发动机高温升燃烧室贫油熄火及冒烟性能研究

高温升燃烧室头部燃烧组织方案设计,以改善高温升燃烧室的贫油熄火边界及冒烟性能。该方案的特点是采用了三旋流器以及双油路复合式喷嘴,设计的主燃区油气分布相当均匀,而回流区内的油气分布是局部富油的。以常规双旋流器+双油路压力雾化喷嘴(旋流杯)燃烧室作为一个基准方案,在相同的进口实验条件下与本研究方案进行了贫油熄火和出口冒烟性能的比较。实验表明,本研究方案与常规的双旋流杯设计方案相比燃烧稳定性好及出口冒烟改善。      

声发射技术在试件疲劳试验中的预警作用

将声发射动态无损检测技术引入试件疲劳试验中,通过对试验过程中声发射信号的分析,获取试件的初始裂纹数据.证明声发射技术可以发现试验中试件的初始裂纹,并对其破坏具有预警作用.     

热发射测速技术

本文叙述了一种通过探测高温两相流中热粒子的热辐射来测量粒子速度的热发射测速技术,该技术曾多次用于测量电弧加热器射流和火箭弹尾喷火焰中的粒子速度,取得了比较满意的结果。     

An in situ laser induced breakdown spectroscope (LIBS) for Chandrayaan-2 rover: Ablation kinetics and emissivity estimations

A miniaturized in situ laser induced breakdown spectroscope-LIBS is one of the two lunar rover payloads to be flown in India’s next lunar mission Chandrayaan-2, with an objective to carry-out a precise qualitative and quantitative elemental analyses of lunar regolith at the proximity of the landing region. As per the imposed mission constraints and the executed design optimization studies, a compact and light-weight LIBS prototype model is developed at our premises. This paper mainly concerns with the estimation of theoretical aspects; especially on evaluation of elemental ablation parameters and signal-to-noise ratio (SNR) calculations for the designed instrument. Theoretical estimations and simulations yielded an incident laser power density of the order of 5 × 10¹⁰ W/cm² on the target surface at a defined lens-to-surface distance (LTSD) of 200 mm and revealed an SNR > 100 for most of the elements under consideration. This paper also addresses the impact of LTSD variation on detection capability. The estimation of plasma-temperatures was carried out utilizing the emission spectra obtained under high vacuum environments employing the LIBS laboratory model. Experimental investigations and the performed theoretical estimations asserted the successful operation of the configured LIBS instrument for in situ elemental analyses on lunar surface.     

铝合金平板超高速撞击声发射信号S2模态特征分析

对铝合金平板上形成的超高速撞击(HVI)声发射(AE)信号S2模态的特征进行研究,分析其与损伤模式之间的关系。以3 mm厚5A06铝合金平板为研究对象,通过数值仿真获得不同撞击工况下的超高速撞击声发射信号,提取信号中的S2模态,并分析其幅值、能量、频谱等特征。结果表明,S2模态能量随传播距离呈指数衰减;分别随撞击弹丸直径和撞击速度的增加先下降后上升,且在弹丸直径与靶板厚度相近、临界撞击速度时最低。S2模态的中心频率随弹丸直径的增加而降低;随撞击速度的增加而增加;随传播距离的增加向1500 kHz移动。S2模态小波包系数呈凹性的频域范围分别随撞击速度和弹丸直径的增大变窄。在此基础上,当靶板形成穿孔损伤时,可根据S2模态的中心频率推测弹丸的直径;在传播距离和弹丸直径已知的前提下,可根据S2模态小波包系数呈凹性的频域范围推测撞击速度。     

CFD Study of NO_x Emissions in a Model Commercial Aircraft Engine Combustor

Air worthiness requirements of the aircraft engine emission bring new challenges to the combustor research and design. With the motivation to design high performance and clean combustor, computational fluid dynamics (CFD) is utilized as the powerful design approach. In this paper, Reynolds averaged Navier-Stokes (RANS) equations of reactive two-phase flow in an experimental low emission combustor is performed. The numerical approach uses an implicit compressible gas solver together with a Lagrangian liquid-phase tracking method and the extended coherent flamelet model for turbulence-combustion interaction. The NOx formation is modeled by the concept of post-processing, which resolves the NOx transport equation with the assumption of frozen temperature distribution. Both turbulence-combustion interaction model and NOx formation model are firstly evaluated by the comparison of experimental data published in open literature of a lean direct injection (LDI) combustor. The test rig studied in this paper is called low emission stirred swirl (LESS) combustor, which is a two-stage model combustor, fueled with liquid kerosene (RP-3) and designed by Beihang University (BUAA). The main stage of LESS combustor employs the principle of lean prevaporized and premixed (LPP) concept to reduce pollutant, and the pilot stage depends on a diffusion flame for flame stabili-zation. Detailed numerical results including species distribution, turbulence performance and burning performance are qualita-tively and quantitatively evaluated. Numerical prediction of NOx emission shows a good agreement with test data at both idle condition and full power condition of LESS combustor. Preliminary results of the flame structure are shown in this paper. The flame stabilization mechanism and NOx reduction effort are also discussed with in-depth analysis.     

AVS-F observations of γ-ray emission during January 20, 2005 solar flare up to 140 MeV

The solar flare of January 20, 2005 (X7.1, 06:36–07:26 UT, maximum at 07:01 UT by the GOES soft X-ray data) was the most powerful one in January 2005 series. The AVS-F apparatus onboard CORONAS-F registered γ-emission during soft X-ray rising phase of this flare in two energy ranges of 0.1–20 MeV and 2–140 MeV. The highest γ-ray energy registered during this flare was ∼140 MeV. Six spectral features were registered in energy spectrum of this solar flare: annihilation + αα (0.4–0.6 MeV), ²⁴Mg + ²⁰Ne + ²⁸Si + neutron capture (1.7–2.3 MeV), ²¹Ne + ²²Ne + ¹⁶O + ¹²С (3.2–5.0 MeV), ¹⁶O (5.3–6.9 MeV), one from neutral pions decay (25–110 MeV) and one in energy band 15–21 MeV. Four of them contain typical for solar flares lines – annihilation, nuclear de-excitation and neutron capture at ¹H. Spectral feature caused by neutral pions decay was registered during several flares too. Some spectral peculiarities in the region of 15–21 MeV were first observed in solar flare energy spectrum.     

基于ZnO阵列的银表面二次电子发射抑制技术

随着卫星有效载荷的射频功率越来越大,传统的微放电抑制方法已经无法满足大功率卫星有效载荷的需求。降低大功率射频部件内表面的二次电子发射系数是抑制微放电效应的重要方法之一,通过在金属银表面构造纳米量级ZnO阵列,实现了纳米尺度银陷阱结构的制备,研究了晶种制备方式、锌盐浓度对ZnO阵列生长的影响。结果表明,采用紫外照射法制备晶种获得的ZnO阵列在样片表面分布均匀,提高锌盐浓度可改善ZnO阵列的分布均匀性。分析了ZnO阵列排列密度对银膜构筑的影响,发现在低密度的ZnO阵列上更加容易镀覆金属银。因此,获得了镀银表面基于ZnO阵列的陷阱结构制备的工艺技术,实现金属银表面二次电子发射系数最大值降低36.3%。     

芳香烃种类及含量对航空发动机燃烧的排放影响

为了对不同芳香烃种类及含量在航空发动机上表现开展综合评定,对16种芳香烃的3种配比调和燃料开展发动机排放尾气碳烟浓度实验。根据实测颗粒物排放浓度值,对芳香烃的种类与含量增长对排放的影响进行比较;通过线性拟合计算芳香烃特性与颗粒物PM(particulate matters)排放的相关性;结合燃料的能量密度与排放两大重要因素,给出综合评定排名。分析结果表明:茚与萘系类产生的PM数浓度显著更高,而加氢处理后对排放有明显改善。芳香烃的密度和碳氢比对PM的影响最大,并随着芳烃浓度的增加影响越显著。对异丙苯与苯乙烯在综合评定中被列为最优两种芳烃,对萘系列加氢处理可同时优化比能与排放。该结果为通过控制燃料中芳烃种类来优化燃料提供了研究基础。