An Integer Precise Point Positioning technique for sea surface observations using a GPS buoy

GPS data dedicated to sea surface observation are usually processed using differential techniques. Unfortunately, the precision of resulting kinematic positions is baseline-length dependent. So, high precision sea surface observations using differential GPS techniques are limited to coasts, lakes, and rivers. Recent improvements in GPS satellite products (orbits, clocks, and phase biases) make phase ambiguity fixing at the zero difference level achievable and opens up the observation of the sea surface without geographical constraints. This paper recalls the concept of the Integer Precise Point Positioning technique and discusses the precision of GPS buoy positioning. A sequential version of the GINS software has been implemented to achieve single epoch GPS positioning. We used 1 Hz data from a two week GPS campaign conducted in the Kerguelen Islands. A GPS buoy has been moored close to a radar gauge and 90 m away from a permanent GPS station. This infrastructure offers the opportunity to compare both kinematic Integer Precise Point Positioning and classical differential GPS positioning techniques to in situ radar gauge data. We found that Precise Point Positioning results are not significantly biased with respect to radar gauge data and that horizontal time series are consistent with differential processing at the sub-centimetre precision level. Nevertheless, standard deviations of height time series with respect to radar gauge data are typically [4–5] cm. The dominant driver for noise at this level is attributed to errors in tropospheric estimates which propagate into position solutions.     

预先危险分析方法在航管二次雷达站运行管理中的应用

本文对预先危险分析方法作了简单介绍。重点研究了PHA在航管二次雷达站运行管理中的应用，找出了广汉机场航管二次雷达站运行管理中存在的危险源，采用定性和定量的方法从危险的后果严重程度和发生可能性两方面对风险进行了分析，提出了控制危险性的有效措施。     

Time and phase synchronization using clutter observations in airborne distributed coherent aperture radars

Airborne Distributed Coherent Aperture Radar(ADCAR) is one of the most promising next-generation radars to significantly improve target detection and discrimination abilities. However, time and phase synchronization among unit radars should be done before an ADCAR is intended to cohere on a potential target. To address this problem, a time and phase synchronization technique using clutter observations is proposed in this paper. Clutter returns from different azimuths and elevations on the surfac...     

Using altimetry and seafloor pressure data to estimate vertical deformation offshore: Vanuatu case study

Measuring ground deformation underwater is essential for understanding Earth processes at many scales. One important example is subduction zones, which can generate devastating earthquakes and tsunamis, and where the most important deformation signal related to plate locking is usually offshore. We present an improved method for making offshore vertical deformation measurements, that involve combining tide gauge and altimetry data. We present data from two offshore sites located on either side of the plate interface at the New Hebrides subduction zone, where the Australian plate subducts beneath the North Fiji basin. These two sites have been equipped with pressure gauges since 1999, to extend an on-land GPS network across the plate interface. The pressure series measured at both sites show that Wusi Bank, located on the over-riding plate, subsides by 11 ± 4 mm/yr with respect to Sabine Bank, which is located on the down-going plate. By combining water depths derived from the on-bottom pressure data with sea surface heights derived from altimetry data, we determine variations of seafloor heights in a global reference frame. Using altimetry data from TOPEX/Poseidon, Jason-1, Jason-2 and Envisat missions, we find that the vertical motion at Sabine Bank is close to zero and that Wusi Bank subsides by at least 3 mm/yr and probably at most 11 mm/yr.     

弹-架间隙的非线性模拟与特性分析

以大长径比低速旋转火箭为例,探讨弹-架间隙非线性特性对不同发射装置系统的动力响应的影响,当飞行器以S个定心部沿发射装置滑移时,根据弹、架横向相对位移确定其定心部处接触刚度和支承特性,模拟弹-架间隙效应。分别就刚性和柔性两种发射装置,分析了间隙量、支承刚度和转速等因素对飞行器发射中的姿态和系统动力特性的影响,算例与实际情况的相吻合证明了该方法的有效性。     

基于STF的Jerk模型自适应机动目标跟踪算法

在Jerk模型的基础上,提出了一种新的机动目标自适应跟踪算法STF-Jerk。该算法通过引入强跟踪滤波器(STF)的渐消因子,实时调节滤波器增益,增强了系统对突发机动的自适应跟踪能力,从而很好地改善了Jerk模型在跟踪机动目标时的跟踪精度。仿真结果表明,提出的STF-Jerk自适应跟踪算法显著提高了Jerk模型自适应算法的机动目标跟踪性能。     

模糊控制在雷达天线控制系统中的应用

针对目前在雷达天线控制系统中采用数字PID控制存在超调量大、响应时间长等不足，分析比较了数字PID控制和模糊控制的不同特点，介绍了模糊控制在雷达天线控制系统中的应用。     

旋风式燃气过滤器的冷流实验和内流场模拟

为了考察某导弹系统燃气发生器的旋风式燃气过滤器的除尘特性，对其进行了冷流实验研究，对除尘效率进行了模拟测量，并应用多流体模型的IPSA算法对其内流场进行了三维两相的数值模拟。计算结果与实验结果较符合，计算得到的分离界限粒径为2μm--3μm。     

基于ATE技术的末制导雷达“天线对零”实现方案

在叙述“天线对零”过程重要性的基础上,介绍了基于ATE技术的末制导雷达“天线对零”自动过程的实现方案。该自动“天线对零”方案已经应用在“末制导雷达通用检测系统”中,保证了系统的高精度自动化测量。     

轨道机动过程中推力加速度的在线最小方差估计

定位和跟踪空间机动目标时，对目标运动建模受发动机推力的不确定性影响，通过统计处理离散的雷达观测数据实时估计发动机的推力，进而定位和跟踪机动目标便是本文所要研究和解决的问题，本文在地心惯性系建立了常推力轨道机动过程中连续变质量运动模型和离散雷达量测模型，机动过程中质量秒耗量和排气速度作为表征轨控发动机推力的两个近似常量，应用扩展卡尔曼滤波对离散雷达测量数据进行序贯统计处理得到发动机推力的最小方差估计；文中详细地给出了线性化量测模型的变分方程和观测矩阵；仿真结果表明该算法能快速、准确地在线估计轨控发动机的等效推力。