"神舟三号"大气成分探测器探测结果--2002年4月磁暴期间大气成分的异常变化

"神州三号"(SZ-3)大气成分探测器搭载在SZ-3留轨舱上于2002年3月26日发射入轨,正遇2002年4月发生的连续两次地磁扰动事件,SZ-3大气成分探测器测得了轨道舱运行高度上(330-350 km附近)大气成分的响应变化和异常现象.探测数据表明,在地磁扰动期间,不仅发生了大气中主要成分O和N2的数密度值增变的响应变化,而且在进入地磁扰动峰期开始后6h左右在较高纬度处出现了N2的异常增变和O的异常降变.4-5h后,这种异常增变峰和降变谷由纬度42°N左右逐渐推移向纬度较低地区,直至消失.     

GPS total electron content and surface latent heat flux variations before the 11 March 2011 M9.0 Sendai earthquake

The present paper describes the variations of the GPS total electron content (TEC) from the International GNSS service network and surface latent heat flux (SLHF) from the Scientific Computing Division of the National Center for Atmospheric Research (NCAR) before the 11 March 2011 M9.0 Sendai earthquake, respectively. The analysis shows pronounced enhancements in the GPS TEC and SLHF a few days prior to the earthquake event. The maximum increase in the GPS TEC was about 30 TECu with an extended spatial distribution on a geomagnetically quiet day (Dst ? −20 nT, between two moderate geomagnetic storms), 8 March, 3 days prior to the earthquake. This giant positive disturbance was possibly associated with the impending disastrous earthquake and contributed from the enhanced solar radiation. Moreover, there were several anomalous regions of SLHF on the global map, but an area of enhanced SLHF very close to the epicenter. The purpose of this paper is to report the existence of the changes in surface and ionosphere, and show the potential application of multi-source data to identify seismic precursors.     

Preparation of bimodal grain size 7075 aviation aluminum alloys and their corrosion properties

The bimodal grain size metals show improved strength and ductility compared to traditional metals; however, their corrosion properties are unknown. In order to evaluate the corrosion properties of these metals, the bimodal grain size 7075 aviation aluminum alloys containing different ratios of coarse(100 μm in diameter) and fine(10 μm in diameter) grains were prepared by spark plasma sintering(SPS). The effects of grain size as well as the mixture degree of coarse and fine grains on general corrosion were estimated by immersion tests, electrochemical measurements and complementary techniques such as scanning electron microscope(SEM) and transmission electron microscope-energy disperse spectroscopy(TEM-EDS). The results show that, compared to fine grains, the coarse grains have a faster dissolution rate in acidic NaCl solution due to the bigger size,higher alloying elements content and larger area fraction of second phases in them. In coarse grains,the hydrogen ions have a faster reduction rate on cathodic second phases, therefore promoting the corrosion propagation. The mixture of coarse and fine grains also increases the electrochemical heterogeneity of alloys in micro-scale, and thus the increased mixture degree of these grains in metal matrix accelerates the corrosion rate of alloys in acidic NaCl solution.     

Estimation of probability of occurrence of F1 layer or L condition using tables and electron density profile models

An algorithm is proposed for evaluation of the probability of occurrence of an F1 layer or L condition, based on tables. Observations independent of the tables database are used for comparison between the estimated probability of occurrence, the formulation used at present in IRI, and the occurrence actually observed. The importance of the inclusion of L condition in the electron density profile model is shown.     

Plasmaspheric electron content derived from GPS TEC and FORMOSAT-3/COSMIC measurements: Solar minimum condition

The plasmaspheric electron content (PEC) was estimated by comparison of GPS TEC observations and FORMOSAT-3/COSMIC radio occultation measurements at the extended solar minimum of cycle 23/24. Results are retrieved for different seasons (equinoxes and solstices) of the year 2009. COSMIC-derived electron density profiles were integrated up to the height of 700 km in order to retrieve estimates of ionospheric electron content (IEC). Global maps of monthly median values of COSMIC IEC were constructed by use of spherical harmonics expansion. The comparison between two independent measurements was performed by analysis of the global distribution of electron content estimates, as well as by selection specific points corresponded to mid-latitudes of Northern America, Europe, Asia and the Southern Hemisphere. The analysis found that both kinds of observations show rather similar diurnal behavior during all seasons, certainly with GPS TEC estimates larger than corresponded COSMIC IEC values. It was shown that during daytime both GPS TEC and COSMIC IEC values were generally lower at winter than in summer solstice practically over all specific points. The estimates of PEC (h > 700 km) were obtained as a difference between GPS TEC and COSMIC IEC values. Results of comparative study revealed that for mid-latitudinal points PEC estimates varied weakly with the time of a day and reached the value of several TECU for the condition of solar minimum. Percentage contribution of PEC to GPS TEC indicated the clear dependence from the time with maximal values (more than 50–60%) during night-time and lesser values (25–45%) during day-time.     

Comparison of model and experimental ionospheric parameters at high latitudes

Modern use and study of the auroral region needs to attract a wider class of models for describing conditions of radio wave propagation in the ionosphere. In this paper the possibilities of the International Reference Ionosphere model, well-proven and widespread in the mid-latitudes, are investigated in the high latitude zone. Model and measured values of the critical frequency foF2 for two mid-latitude stations (Juliusruh and Goosebay) and four high-latitude ones (Loparskaya, Sodankyla, Sondrestrom, Thule) are compared. Deviations of medians, variations from day to day and solar activity trends seemed to be similar for both areas. This similarity is irrespective of the RZ12 index. Special attention is paid to the TEC parameter and its determination using 6 versions of models, a new version of the model IRI2010 (IRI-Plas) among them. It is shown that the IRI-Plas model significantly improves the definition of TEC in contrast to the versions of IRI2007 and the new model NeQuick. The use of the median of the experimental equivalent slab thickness, together with the current values of the TEC, increases by a factor of two the agreement between calculated and measured foF2 values as compared with the variations from day to day. This allows foF2 to be defined in near-real time.     

Longitudinal behaviors of the IRI-B parameters of the equatorial electron density profiles retrieved from FORMOSAT-3/COSMIC radio occultation measurements

The electron density profiles in the bottomside F₂-layer ionosphere are described by the thickness parameter B0 and the shape parameter B1 in the International Reference Ionosphere (IRI) model. We collected the ionospheric electron density (N_e) profiles from the FORMOSAT-3/COSMIC (F3/C) radio occultation measurements from DoY (day number of year) 194, 2006 to DoY 293, 2008 to investigate the daytime behaviors of IRI-B parameters (B0 and B1) in the equatorial regions. Our fittings confirm that the IRI bottomside profile function can well describe the averaged profiles in the bottomside ionosphere. Analysis of the equatorial electron density profile datasets provides unprecedented detail of the behaviors of B0 and B1 parameters in equatorial regions at low solar activity. The longitudinal averaged B1 has values comparable with IRI-2007 while it shows little seasonal variation. In contrast, the observed B0 presents semiannual variation with maxima in solstice months and minima in equinox months, which is not reproduced by IRI-2007. Moreover, there are complicated longitudinal variations of B0 with patterns varying with seasons. Peaks are distinct in the wave-like longitudinal structure of B0 in equinox months. An outstanding feature is that a stable peak appears around 100°E in four seasons. The significant longitudinal variation of B0 provides challenges for further improving the presentations of the bottomside ionosphere in IRI.     

Near real-time assimilation in IRI of auroral peak E-region density and equatorward boundary

The paper describes the method and initial results of assimilating the auroral peak E-region density (NmE) and the auroral equatorward boundary (EB) into the International Reference Ionosphere (IRI). The NmE and EB are obtained using a FUV based auroral model or FUV measurements in near real-time. Initial results show that the auroral NmE is often significantly larger than the NmE due to the solar EUV. This indicates the importance of including the contribution of precipitating electrons in IRI. The global equatorial boundary helps to improve the specification of the sub-auroral ionosphere trough in IRI. An IDL software package has been developed to interactively display the IRI parameters with assimilated NmE and EB. It can serve as an operational tool for space weather monitoring.     

Study of the 28 October 2003 and 20 January 2005 solar flares by means of 2.223 MeV gamma-emission line

By the data on intensity-time profiles of the neutron capture line of 2.223 MeV we have studied some characteristics of two solar flares, 28 October 2003 and 20 January 2005 (INTEGRAL and CORONAS-F observations, respectively). The SINP code was applied making allowance for the main processes of neutron interactions and deceleration in the solar plasma, character of neutron source, losses of neutrons and density model of the solar atmosphere. Comparison of the computed time profiles of 2.223 MeV line with observed ones for the flare of 28 October 2003 confirms the results obtained earlier for three other flares. Namely, the effect of density enhancement (EDE) in the sub-flare region, as well as the variations (hardening) of accelerated particle spectrum in the course of the event have been confirmed. The usual modeling procedure by the SINP code, however, seems to be inapplicable to the event of 20 January 2005. Possible causes of density enhancements during some flares and peculiarities of the 20 January 2005 flare are discussed.     

高超声速流的电子束诊断法(英文)

本文描述用电子束辉光法测量高超声速流中平均密度、速度以及密度变化特征的物理原理和过程。对此法用于平板上激波层稳定性问题的适用范围和限制条件作了分析。内容通过风洞实验结果加以说明。