最大熵磁共振成象理论

由于在实际磁共振成象系统中,只能得到有限的频谱数据,利用传统的ＦＦＴ方法重建磁共振图象,将导致截断的伪影和低的分辨率。本文提出了一种基于ＡＲ模型的最大熵磁共振成象算法,利用ＡＲ模型外推未知频谱数据,替代了ＦＦＴ方法的填零法重建,并利用了ＢＵＲＧ算法中的ＡＲ模型参数计算的有效性,不仅消除了截断伪影、抑制噪声、提高了分辨率,而且使重建时间与ＦＦＴ方法相当,完全适用于临床应用。     

Experimental Study on Effects of Fuel Injection on Scramjet Combustor Performance

In order to investigate the effects of fuel injection distribution on the scramjet combustor performance, there are conducted three sets of test on a hydrocarbon fueled direct-connect scramjet test facility. The results of Test A, whose fuel injection is carried out with injectors located on the top-wall and the bottom-wall, show that the fuel injection with an appropriate close-front and centralized distribution would be of much help to optimize combustor performances. The results of Test B, whose fuel injection is performed at the optimal injection locations found in Test A, with a given equivalence ratio and different injection proportions for each injector, show that this injection mode is of little benefit to improve combustor performances. The results of Test C with a circumferential fuel injection distribution displaies the possibility of ameliorating combustor performance. By analyzing the effects of injection location parameters on combustor performances on the base of the data of Test C, it is clear that the injector location has strong coupled influences on combus- tor performances. In addition, an inner-force synthesis specific impulse is used to reduce the errors caused by the disturbance of fuel supply and working state of air heater while assessing combustor performances.     

双太阳翼GEO卫星在轨角动量管控方法

地球同步轨道(GEO)卫星在轨的主要环境干扰力矩为太阳光压力矩和重力梯度力矩,干扰力矩的累积效应表现为飞轮转速的变化,需要通过外力矩进行角动量卸载避免飞轮饱和。由于GEO磁场极弱,卫星无法使用磁力矩卸载,只能通过喷气卸载,而喷气将对卫星轨道产生影响,因此需要尽可能延长卸载周期。针对配置双对称太阳电池阵GEO卫星的角动量管控需求,首先建立卫星在惯性空间中角动量积累模型,并映射到卫星本体系中,得到本体系中的角动量变化规律。通过飞轮在轨转速遥测数据,精确辨识获取环境干扰力矩特征参数,获得真实可靠的干扰模型。以角动量卸载周期最长为原则,基于在轨环境干扰模型制定角动量管控策略,并准确预估下次角动量卸载时间。经在轨数据处理与分析表明:提出的角动量管控策略,可有效将飞轮的角动量卸载周期提升为原来的2倍,有效提升卫星在轨应用效能,具有实际工程意义。     

基于磁路法与等效热网络法的航天 永磁同步电机设计与仿真

针对航天永磁同步电机方案初步设计耗时长、过度依赖商业软件的问题,基于磁路法和热网络法,提出了一套方案设计阶段航天永磁同步电机磁热性能快速预估与仿真方法。给出了定子内径、定子外径、铁芯长度、匝数等关键参数的取值准则,建立了包含36个节点集总参数热网络模型,并以端部绕组为例给出了热平衡方程的详细推导过程。通过与成熟商业软件对比,其电磁计算最大误差出现在电流有效值上,偏差值为607%;与样机实测值对比,绕组温升最大误差为73%,满足方案设计阶段预示精度要求,为方案设计阶段航天永磁同步电机快速性能预估提供有力支撑。     

微纳聚合体卫星的对称式重构规划算法

为解决微纳聚合体卫星变构过程中,聚合体各部分之间的动力学耦合导致的卫星整体姿态翻转或紊乱,提出了一种对称式变构规划算法。首先建立了铰链约束下的漂浮基多刚体系统动力学模型,研究了重构过程中各运动模块对本体姿态的影响,提出当每两个运动模块位置与转动方向满足对称性条件时,两者对本体姿态的影响可在一定程度上相互抵消。基于上述理论,在A*算法中引入最优分配度量和对称性判定,设计了并行对称重构规划算法。仿真结果表明,该规划算法可实现重构过程中多模块并行、对称运动,重构过程总步数较少,运动模块对本体姿态的影响小。     

Upper limit of the total magnetic flux in an active region according to the photometric-magnetic dynamical model

The photometric-magnetic dynamical model handles the evolution of an individual sunspot as an autonomous nonlinear, though integrable, dynamical system. One of its consequences is the prediction of an upper limit of the sunspot areas. This upper limit is analytically expressed by the model parameters, while its calculated value is verified by the observational data. In addition, an upper limit for the magnetic strength inside the sunspot is also predicted, and then, we obtain the following significant result: The upper limit of the total magnetic flux in an active region is found to be of about 7.23 × 10²³ Mx, namely, phenomenologically equal to the magnetic flux concentrated in the totality of the granules of the quiet Sun, having a typical maximum magnetic strength of about 12G. Therefore, the magnetic flux concentrated in an active region cannot exceed the magnetic flux concentrated in the photosphere as a whole.     

Modelling and observations of photospheric magnetic helicity

Mounting observational evidence of the emergence of twisted magnetic flux tubes through the photosphere have now been published. Such flux tubes, formed by the solar dynamo and transported through the convection zone, eventually reach the solar atmosphere. Their accumulation in the solar corona leads to flares and coronal mass ejections. Since reconnections occur during the evolution of the flux tubes, the concepts of twist and magnetic stress become inappropriate. Magnetic helicity, as a well preserved quantity, in particular in plasma with high magnetic Reynolds number, is a more suitable physical quantity to use, even if reconnection is involved.     

小型磁偏转质谱计性能实验研究

自主研发了小型磁偏转质谱计,并对其质量范围、分辨本领、灵敏度和最小可检分压力四个主要性能指标进行了实验测试和比对。结果表明,该质谱计的质量范围为（1~143）amu,相对N₂的分辨本领为1400,灵敏度为4.2×10^-5 A/Pa,最小可检分压力为9.5×10^-7 Pa。该测试和比对结果为磁偏转质谱计进一步的优化设计和性能提高奠定了重要基础。     

轨控大干扰下的系统角动量管理

摘要： 针对利用角动量交换装置系统实现轨控期间姿态维持的情况,研究当轨控推力器存在大力矩扰动时系统角动量管理方法.结合对地运行航天器轨道运动特性,分析轨控干扰力矩的积累角动量变化规律;考虑角动量管理装置系统的角动量存贮容量,基于角动量积累规律提出了一种结合偏置角动量建立与对称分布轨控位置选择的系统角动量管理方法,实现了对称轨控位置积累角动量互相抵消的自平衡效果,极大程度地提高轨控效率且避免系统角动量饱和现象.所提出的方法适用于喷气欠驱动控制系统,方法的有效性通过了数学仿真验证及在轨型号应用.     

基于虚拟目标点制导的误差分析

基于标准弹道确定的虚拟目标点位置在弹道小扰动的情况下能够确保闭路制导的精度,但是在弹道大扰动时,虚拟目标点位置修正误差变大,能否保证闭路制导的精度值得探讨。通过给弹道一个大扰动进行了弹道仿真,结果表明,弹道大扰动会引起闭路制导的方法误差变大。