基于IRI-2012模型广州地区f_0F_2实测与预测的对比分析

利用广州台站(23.2°N,113.3°E)的实测数据和IRI-2012模型提供的预测数据,对比分析了2013年广州地区f_0F2的变化特征.结果表明,IRI-2012模型能够较好预测该地区f_0F_2的变化趋势,并且CCIR参数得到的预测值比URSI参数更接近实测值;预测值与实测值存在系统偏差,在11:00 LT-06:00 LT时段,观测值均比预测值大,其他时段则相反.在日落后至午夜前时段,预测值与实测值有较大差距.绝对偏差的极值点通常出现在20:00 LT左右,最大超过4 MHz.相对偏差变化比较明显的时段是午夜后至凌晨;在02:00 LT或04:00 LT及06:00 LT附近,可能会出现双误差峰值点,最大超过0.4;但在σ变化很大的20:00 LT附近,相对偏差却变化不大.夜间增强现象会使得偏差增大,导致预测值不能很好反映实测f_0F2的变化.     

一种卫星信道的反馈优化接入机制

提高卫星信道资源利用率，探索高效可行的端站接入机制是卫星通信发展亟待解决的问题之一。当前卫星通信DVB-RCS标准基于带宽预先规划的接入机制与端站随遇接入的需求矛盾凸显，因此提出一套信道反馈优化接入机制，综合考虑各端站数据业务需求，在不改变原有协议信令特征的基础上，探索性地引入谦虚度激励方法，创造性地构造动态协商反馈模型并加以求解，达到提高端站接入数量、满足随遇接入需求、提升信道利用效率、最大化整体带宽通信业务效益的目的。通过试验验证，带宽分配反馈优化机制比传统模式提高近1倍接入率，最大端站数接入时算法耗时约只有0.67s，可为卫星信道使用提供技术参考。     

Aerodynamics of smart flap under ground effect

Aerodynamic characteristics of two-dimensional smart flap under the ground effect have been assessed by a numerical simulation. In this process, a pressure-based implicit procedure to solve Navier–Stokes equations on a nonorthogonal mesh with collocated finite volume formulation is used. The boundedness criteria for this procedure are determined from the Normalized Variable Diagram (NVD) scheme. The procedure incorporates the k–ε eddy–viscosity turbulence model. Cantilever beam with uniformly varying load with roller support at the free end is considered for the configuration of the smart flap. The method is first validated against experimental data. Then, the algorithm is applied for turbulent aerodynamic flows around airfoil with smart and conventional flaps for different attack angle, flap angle and ground clearance where the results of two flaps are compared. The comparisons show that the quality of the solution is considerable.     

高超声速飞行器控制面热防护系统地面试验研究

针对高超声速飞行器控制面研发手段中极其重要的地面试验技术,以X-37轨道飞行器为例,介绍了国外的最新研究进展和关键技术解决途径,以及指导地面试验研究的方法,并针对控制面方案在评估和鉴定中必不可少的高温模态试验,进行了综述和分析。     

基于产品成熟度的设计制造高度并行研发模式

设计与制造协同作为并行工程的重要环节,是从设计阶段就开始考虑产品的可制造性,有效减少工艺准备时间,缩短研制周期及上市时间.但如何做到设计与制造有效协同一直是困扰航空制造行业的难题.在原有VPM-Windchill-DELMIA协同研发的模式下,进一步探讨基于VPM与DELMIA直接开展设计制造高度并行的研发模式工程应用研究,为实现复杂产品设计制造的协同研发提供新的技术途径.采用VPM-DELMIA模式,可以提升设计与制造的最大并行程度,让制造部门可以及时了解设计状态,提早开展工艺设计过程.     

边界层厚度对腔体气动声学特性影响数值模拟

为了研究来流边界层厚度对开式腔体气动声学特性的影响,基于分离涡模拟方法,计算了来流马赫数为2.0条件下,不同来流边界层厚度与腔体深度比时,长深比为5.88的腔体流动特性,得到了该腔体声压级的频谱特性.计算结果表明:随着来流边界层厚度增加,形成的剪切层稳定性增强,失稳后上下摆动幅度减少,失稳生成的大尺度涡与超声速主流的相互作用减弱,使得大尺度涡发展到腔体后缘时所具有的平动动能和转动动能降低.大尺度涡撞击腔体后缘在腔体内形成的气动噪声的声压级降低,最大减小幅度达7.5dB.同时各阶模态的频率也发生偏移,偏移值在100Hz左右.基于新的假设重新推导了Rossiter公式,明确了经验常数的物理意义,并以此解释了频率偏移现象.      

Estimation of ground range on the sweep frequency backscatter leading edge

The high frequency management system with backscatter radar supplies the real time ionosphere channel conditions to high frequency users, which leads to the demand for the ground range between the radar location and the scatters on the distant ground. The ionosphere electron density profile is usually inversed to obtain the ground range. An inversion algorithm, with which the ground range on the leading edge of the backscatter ionograms can be obtained without electron density, is presented in this paper. The ray path geometry of the backscatter sounding and the change in the group path on the leading edge with operating frequency are used to derive the ground range. Synthesized backscatter ionogram and experimental backscatter ionograms are processed to validate the algorithm. The results indicate that the algorithm is usable for high frequency management system.     

Satellite and ground detection of very dense smoke clouds produced on the islands of the Paraná river delta that affected a large region in Central Argentina

Intense fires were produced on the Paraná river delta islands, Argentina, during most part of 2008, by a combination of an exceptionally dry period and the farmers’ use of a fire land-cleaning technique. In April 2008, those fires significantly affected the nearby regions and their inhabitants, from Rosario city to Buenos Aires mega-city. In this work we present satellite as well as ground Aerosol Optical Depth (AOD) at 550 nm data obtained during the propagation of pollution clouds to the central zone of Argentina. The highest value (1.18) was registered at Buenos Aires by atmospheric remote sensing, using the satellite instrument MODIS/Terra on April 18th 2008 at 10:35 local time (= UT − 3 h). On the same day, ground air quality detectors also measured in this city the highest Total Suspended Particle (TSP) value of the month, 2.02 mg/m³. The AOD(550) daily variation at Rosario Astronomical Observatory, which is located near the Paraná riverside, was derived by combining solar ultraviolet erythemal irradiance data (measured with a YES biometre) with model calculations. On April 25th 2008, from 12:00 to 15:30 local time, a rather high and constant AOD(550) value was registered, with a mean value of (0.90 ± 0.21). Cities located on the side of the Rosario–Buenos Aires highway (San Nicolás, Baradero and San Pedro) were also affected, showing a mean AOD(550) between the Rosario and Buenos Aires values. The particulate matter was collected with gridded samplers placed on the Paraná river islands as well as at the Rosario Observatory. They were analysed with a Scanning Electron Microscope (SEM) and mainly showed a biological origin. Even if normally large particles travel small distances from the source, organic aerosol in the range of 40–100 μm and complex asymmetric structures were registered several kilometres away from the aerosol sources on the islands. Another event of intense UV index attenuation (98.6%) occurred on September 18th 2008, due to very dense smoke clouds that extended over the Rosario area for several hours. The clouds were driven away from the fires by East–northeast and East–southeast winds. The minimum value of this index measured around noon allows to derive a maximum AOD(550)_max = (3.65 ± 0.90) at 12:45 local time. Soot clouds extended over the Paraná river, transporting Burned Biomass Debris (BBD) that deposited on Rosario. In particular, burned leaves and small branches with dimensions of 1–20 cm were collected. The mean (BBD) particles deposited on the ground from 7:00 to 19:00 local time were (0.92 ± 0.20) BBD/(m² h).     

火电厂汽包水位测量及误差分析

汽包水位信号的准确测量直接关系到机组的安全稳定运行及汽水调节的品质，是机组安全、稳定运行的重要保证，因此需要采取必要措施提高汽包水位的测量精度并减少测量误差。本文介绍了汽包水位常用的测量方法、汽包水位测量误差产生的原因以及因汽包压力及取样管温度引起的水位测量误差的校核计算方法，提出r适用于发电厂汽包水位校核计算及实际补偿的通用原理和试验方法。     

航空发动机热端部件可修复性评估方法探讨

评估热端部件的可修复性是开展受损航空发动机热端部件修复工作的重要内容之一。本文综合介绍了热端部件可修复性的定义、技术上的可修复性及可修复性评估的工艺流程等。重点论述了不同因素对可修复性评估的影响,并指出:热端部件的可修复性评估应在现有技术基础上,针对部件结构和使用特点,综合分析部件缺陷位置载荷要求、焊接修复区组织性能和结构可达性、工艺匹配性等特殊制约因素对热端部件可修复性的影响,在此基础上实现受损热端部件可修复性的合理准确评估。