异型孔空心叶片壁厚检测的试验研究

发动机叶片的结构型式和制造误差，直接影响发动机的性能和使用寿命。运用超声波法和电涡流法，对两种不同材料和形式的试件进行了试验。电涡流法受到探头直径和试件几何尺寸的影响，测量误差大，超声波法由于存在测量盲区，测量厚度的下限受到限制。但测量值与实际值相关，若对探头加以改进，用于异型孔空心叶片壁厚检测是可行的。     

飞机壁板结构的声疲劳计算及试验

 <正> 飞机结构所承受的噪声载荷声压级超过130dB时,经较长时间激励,往往在噪声诱导应力较大的区域里产生疲劳破坏。而在各种类型的结构件中声疲劳破坏的相对发生率以蒙皮壁板结构为最高。 本文采用矩形铝合金平板来模拟蒙皮壁板结构,对其进行了声疲劳寿命计算与试验研究.     

实测载荷谱数据处理系统

简要介绍了实测载荷谱数据处理系统，较深入地论述了实测载荷谱数据处理的几个重要方面，给出了该系统处理直升机旋翼系统动部件实测载荷谱的实例，通过大子样二维疲劳２载荷母体分布参数估计及假设检验，发现载荷幅值服从半正态分布，载荷均值服从三参数Ｗｅｉｂｕｌｌ分布。     

Time-series analysis of GPS measurements for long-span bridge movements using wavelet and model prediction techniques

This study aims at assessing the safety behavior of the Incheon long-span bridge using high rate (10?Hz) geodetic monitoring global positioning system (GPS). The time series of wavelet spectrum analysis is utilized to assess the dynamic behavior of the bridge. The coefficients and model errors of the time series autoregressive-moving average (ARMA) model are used to evaluate the movement performances of the bridge. The results show that: (i) the accuracy of GPS measurements to extract the dynamic behavior of the bridge is 97.27% when compared with the design results. (ii) the behavior of the bridge is within the safety limits of the bridge design with minimum observed changes for the historical GPS measurements in time and frequency domains, the mean deflection of bridge deck is 8.26?mm and frequency changes of bridge is 0.004?Hz compared with the design results. (iii) the time series analysis of the wavelet spectrum and ARMA model coefficients can be used to detect the significant frequency changes and study the rigidity of the bridge performance, respectively; and the both methods are found to be suitable techniques to estimate the performance changes of the GPS measurements in the time and frequency domains during the monitoring time period.     

DME脉冲调制信号波形参数对空间频谱占用的影响分析

航空测距器DME的开发、调试和性能验证都要用到高斯双脉冲调制格式的DME信号。由于专用的DME信号模拟器技术复杂、价格昂贵,人们常用具有快沿双脉冲调制功能的模拟信号源替代。本文以航空测距器DME信号要求为依据,初步分析了这种替代可能存在的问题,并通过实验对不同边沿条件下高斯双脉冲、矩形双脉冲调制信号的功率频谱占用情况进行了验证。     

Satellite launch vehicle effect on the Earth’s lower ionosphere: A case study

The effect of the rocket exhaust products on the D-region of the ionosphere is investigated with the help of Very low frequency (VLF) electromagnetic wave propagation characteristics within the Earth-ionosphere waveguide. The changes in the electron density profile are computed from the observed VLF signal amplitude perturbations about 3 dB during the rocket launch. We find a localized electron depletion in the lower ionosphere at an altitude of around 58 km, that is thought to be originated by the attachment of ionospheric ion and molecular hydrogen along with water molecule in the exhaust product of first stage burn of Geosynchronous Launch Vehicle (GSLV) rocket at the time of GSLV launched from Sriharikota, India, on 27 August 2015 at 11:22 UT (16:52 IST). The ionospheric depletion perturbed the navigational VLF signal (VTX = 17 kHz) 134 s after the launch of the GSLV rocket.     

Semi-stochastic modification of second-order radial derivative of Abel–Poisson’s formula for validating satellite gravity gradiometry data

The geoid can be used to validate the satellite gravity gradiometry data. Validation of such data is important prior to their downward continuation because of amplification of the data errors through this process. In this paper, the second-order radial derivative of Abel–Poisson’s formula is modified stochastically to reduce the effect of the far-zone geoid and generate the second-order radial derivative of geopotential at 250 km level. The numerical studies over Fennoscandia show that this method yields the gradients with an error of 10 mE and when the long wavelength of geoid is removed from the estimator and restored after the computations (remove–compute–restore) the error will be in 1 mE level. We name this method semi-stochastic modification. The best case scenario is found when the degree of modification of the integral formula is 200 and the long wavelength geoid to degree 100 is removed and restored. In this case the geoid should have a resolution of 15′ × 15′ and the integration should be performed over a cap size of 3°.     

无人机高速DS/FH混合扩频通信系统关键模块设计

针对UAV(Unmanned Aerial Vehicle,无人机)测控链路高抗干扰需求,给出了实现跳频速率20 000次/s的扩跳混合无人机测控数据链系统实现方案.系统采用跳频频率并行捕获模式.跳频源设计采用直接频率合成、DDS(Direct Digital Synthesis,直接数字频率合成)和PLL (Phase-Locked Loop,锁相环)相结合的混合频率合成技术.利用相位响应滤波器,通过正交调制技术完成MSK(Minimum Shift Keying,最小频移键控)、GMSK (GaussianMinimum Shift Keying,高斯最小频移键控)调制.通过推导得出2 bit差分解调输出与载波频率选择有关,且为四分之数据率的整数倍关系.然后通过实例分析给出了跳频频率间隔选取方法,即跳频间隔应当将临近跳频的主瓣分开,同时跳频载波频率应当设在其他跳频频谱的零点处.最后总结了高速扩跳频系统参数设计一般步骤.     

Effect of blade tip winglet on the performance of a highly loaded transonic compressor rotor

The tip leakage flow has an important influence on the performance of transonic com-pressor. Blade tip winglet has been proved to be an effective method to control the tip leakage flow in compressor, while the physical mechanisms of blade tip winglet have been poorly understood. A numerical study for a highly loaded transonic compressor rotor has been conducted to understand the effect of varying the location of blade tip winglet on the performance of the rotor. Two kinds of tip winglet were designed and investigated. The effects of blade tip winglet on the compressor over-all performance, stability and tip flow structure were presented and discussed. It is found that the interaction of the tip winglet with the flow in the tip region is different when the winglet is located at suction-side or pressure-side of the blade tip. Results indicate that the suction-side winglet (SW) is ineffective to improve the performance of compressor rotor. In addition, a significant stall range extension equivalent to 33.74% with a very small penalty in efficiency can be obtained by the pressure-side winglet (PW). An attempt has been made to explain the fundamental mechanisms of blade tip winglet in detail.     

展向振荡对激波/湍流边界层干扰的影响

周期振荡作为一种有效的壁面流动控制手段受到广泛关注,而其对激波/湍流边界层干扰的影响目前鲜有研究。本文采用高精度直接数值模拟（DNS）方法对马赫数2.9、12°激波入射角、强振荡下的激波/湍流边界层干扰进行了系统研究。通过与无振荡工况的定量比较,揭示了展向强振荡对干扰区内复杂流动结构的影响规律及作用机制,如分离泡尺度、物面压力脉动非定常特性、物面剪切的非定常特性及统计特征等。研究发现：在展向强振荡作用下,分离点位置提前,间歇区长度增大;同时由于分离泡内强黏性耗散的影响,展向振荡的穿透高度约为分离泡高度的4%,因而对流动结构不会产生实质影响。但展向强振荡会对壁面附近流动造成显著影响,如强振荡诱导的壁面展向速度远大于流向速度,造成流向剪切与展向剪切之间夹角的概率密度函数峰值从0°偏移到80°~90°之间。物面压力及剪切本征正交分解分析表明,展向振荡会导致模态能量从低阶模态向高阶模态转移,降低低频运动的能量占比,增强再附后Görtler涡等壁面附近旋涡结构的强度。