实时精确定轨的自校准方法

实时精确定轨的迫切性越来越成为航天技术任务发展所关注的问题。本文将轨道约束“EMBET”自校准技术^[1,2]推广到实时轨道确定处理；在不断地获取对航天器轨道测量数据的过程中，递推地估算和修正观测数据的系统误差，又实时地为用户提供精确的轨道状态参数或轨道根数。     

基于主动热载荷管理技术的涡轮盘疲劳寿命

为降低航空发动机涡轮盘失效风险并提高使用寿命,将主动热载荷管理技术应用于预置裂纹的涡轮盘模型,采用通用权函数法计算裂纹应力强度因子进而分析轮盘寿命,研究经主动热载荷管理的轮盘上能量分布对轮盘寿命的影响,探索轮盘上热边界载荷与寿命的关联性和变化规律,并通过有限元仿真模拟初步分析其作用机理。结果表明:主动热载荷管理技术通过优化轮盘的温度分布,可以有效地降低裂纹附近的应力,延缓裂纹的扩展,显著的提高寿命和安全性,当热边界载荷系数分别取0.05和0.10时,轮盘相应的寿命分别增加12.2%和26.1%。     

基于滑模变结构和扩张状态观测器的电动舵机复合控制方法

为提高电动舵机伺服系统的鲁棒性,同时解决实际工作中电动舵机不确定负载引起的跟踪精度低的问题,提出了一种采用指数趋近率的滑模变结构控制率结合扩张状态观测器对负载扰动进行实时估计的电动舵机的伺服控制方法,给出了控制器设计方法和试验验证。仿真和试验结果表明,与常规的滑模控制器相比,采用扩张状态观测器的变结构控制能有效提高电动舵机的跟踪性能。     

延伸冲击孔冲击冷却流动与换热特性的数值研究

采用数值模拟方法研究了延伸冲击孔冲击冷却系统的冷却特性,分析了3个冲击雷诺数和5个冲击孔延伸长度对冲击腔内流动与换热特性的影响,给出了靶面努塞尔数分布、靶面压力分布、中心截面流速与综合换热性能的变化。结果表明：延伸冲击孔可以有效地防止横流对冲击射流的偏转作用,同时使射流出口更加贴近冲击靶面壁面,冲击速度更高,可以明显提高靶面的换热系数,并使整个靶面上的换热系数分布也更加均匀。冲击冷却的冷却性能随着冲击孔延伸长度的增加而增加,相较于传统冲击冷却（baseline）,在L/d=2.5时靶面平均努塞尔数提升达15%以上,但压力损失也相对较高;对比不同延伸长度冲击孔的综合换热性能,发现存在最佳的L/d取值范围使冲击冷却系统获得最佳的综合冷却性能。在本研究范围内,最佳的L/d= 2.5。     

Spatial transformation of general sampling-aliasing frequency region for rotating-blade parameter identification with emphasis on single-probe blade tip-timing measurement

Blade-health monitoring is intensely required for turbomachinery because of the high failure risk of rotating blades. Blade-Tip Timing (BTT) is considered as the most promising technique for operational blade-vibration monitoring, which obtains the parameters that characterize the blade condition from recorded signals. However, its application is hindered by severe undersampling and stringent probe layouts. An inappropriate probe layout can make most of the existing methods invalid or inaccurate. Additionally, a general conflict arises between the allowed and required layouts because of arrangement restrictions. For the sake of economy and safety, parameter identification based on fewer probes has been preferred by users. In this work, a spatial-transformation-based method for parameter identification is proposed based on a single-probe BTT measurement. To present the general Sampling-Aliasing Frequency (SAFE) map definition, the traditional time–frequency analysis methods are extended to a time-sampling frequency. Then, a SAFE map is projected onto a parameter space using spatial transformation to extract the slope and intercept parameters, which can be physically interpreted as an engine order and a natural frequency using coordinate transformation. Finally, the effectiveness and robustness of the proposed method are verified by simulations and experiments under uniformly and nonuniformly variable speed conditions.     

On the electrodynamics of counter stream in pulsar’s inner annular cap region

The electric properties of pulsar’s inner annular gap are explored in this paper. Under two main assumptions, (1) the pulsar is alive, (2) the total charge of pulsar should not vary with time, the condition for the acceleration of negative particle in the annular region is derived. The acceleration condition is j₋ ? 0.5j₊, i.e., the current carried by negative particles is greater than or equal to 0.5 times of the current carried by positive particles. This condition holds even when the backward flow of positive particles exists in the annular region. It is noted that the outflow of negative particles offers good opportunities to understand the current closure problem of pulsar as well as wide radiation beam of pulsar observed at high energy band.     

某型三叶螺旋桨的设计及性能试验

根据飞行速度、需用拉力、螺旋桨转速等参数,设计了某型飞机的三叶螺旋桨,获得了弦长和桨叶角沿着径向的分布.制造了三叶复合材料螺旋桨（直径为1.75m）,在螺旋桨试验台上测试了不同转速下螺旋桨的拉力.为了获得螺旋桨的动态性能,制造了螺旋桨的缩比模型（直径为0.96m）,在西北工业大学NF-3风洞的三元试验段测试了螺旋桨的气动性能数据,包括:拉力、扭矩、功率、效率.结果表明:螺旋桨最大效率为85.63%,所设计的三叶复合材料螺旋桨适用于螺旋桨需用功率为70kW左右的发动机（比如Rotax912）,提出的螺旋桨设计方法具有较好的应用价值.      

通用航空FBO经营发展的基本模式

FBO经营发展具有多种商业形态,而当前国外通航发达国家FBO经营发展具有较为成熟的模式,国内FBO发展还处在起步阶段,必须学习借鉴国外的成熟模式,通过不同的方式尽快使经营走向成熟。同时,国内FBO又需要根据内外部发展环境,创新自身经营模式,更好地推进通用航空FBO的发展。     

Indirect search for Dark Matter with H.E.S.S.

Observations of the Galactic center region with the H.E.S.S. telescopes have established the existence of a steady, extended source of gamma-ray emission coinciding with the position of the super massive black hole Sgr A^*. This is a remarkable finding given the expected presence of dense self-annihilating Dark Matter in the Galactic center region. The self-annihilation process is giving rise to gamma-ray production through hadronization including the production of neutral pions which decay into gamma-rays but also through (loop-suppressed) annihilation into final states of almost mono-energetic photons. We study the observed gamma-ray signal (spectrum and shape) from the Galactic center in the context of Dark Matter annihilation and indicate the prospects for further indirect Dark Matter searches with H.E.S.S.