结冰风洞中过冷大水滴云雾演化特性数值研究

为明晰结冰风洞中过冷大水滴（SLD）云雾演化特性,发展了基于欧拉法的SLD液滴运动、传热和传质耦合计算方法,针对3 m×2 m结冰风洞主试验段水平收缩构型,分析了SLD云雾沉降收缩特性、动量平衡特性和热平衡特性,探索了液滴变形破碎的影响,评估了构型出口处SLD液滴动量平衡和热平衡状态。研究结果表明：直径超过250 μm的SLD液滴在构型内会发生显著形变,液滴尺寸越大则变形程度越强,尤其在160 m/s工况下,当液滴直径超过750 μm后,SLD液滴甚至会发生破碎;液滴变形破碎效应会增大液滴加速度和液滴温度下降率,促使SLD液滴趋近动量平衡和热平衡状态;SLD云雾（最大液滴直径小于1 000 μm）在构型出口处会出现显著的粒径浓度分层、动量分层和热分层现象,其中直径小于100 μm的小尺寸液滴速度快、温度低且不断凝结,趋于平衡态,但直径超过500 μm的大尺寸SLD液滴速度慢、温度高且不断蒸发,则显著偏离平衡态;增大试验段气流速度尽管会减弱SLD云雾粒径浓度分层程度,但会增强动量分层和热分层程度,尤其在160 m/s工况下,SLD云雾会均匀分布在构型出口中心区域内（-0.75 m < Y < 0.75 m且-0.5 m < Z < 0.5 m）,与其平衡态间的最大速度差和温度差将分别超过18 m/s和20℃。     

三维发动机进气道水滴撞击特性分析

用带数值扩散项的欧拉法对某型三维发动机进气道水滴撞击特性进行了研究.实现了可压流场中三维复杂形体的局部水滴收集系数的计算.数值扩散项的引入解决了欧拉法计算产生奇异结果发散的问题.通过对不同进气道流量的算例结果的比较,发现进气道流量对进气道唇口附近的水滴撞击区和撞击量都有影响.进气量大,最大局部水滴收集系数也大.通过对有无整流罩的计算结果进行比较,发现此型发动机整流罩对水滴撞击特性的影响很小.      

直升机主桨叶的鸟撞有限元数值模拟

以某型直升机主桨叶为例,使用瞬态动力学分析软件(MSC.Dytran),采用先进的任意拉格朗日-欧拉(ALE)流固耦合算法,进行鸟撞过程的数值模拟.模拟结果表明:撞击过程中的最大应力达到199MPa,没有超出桨叶材料的屈服极限.研究结果为桨叶的抗鸟撞损伤设计提供了参考.      

静叶角度调节对组合压气机性能优化机理

采用流线曲率法求解组合压气机的准三维流场,在叶片排前后缘及中间设置计算站,使用样条函数拟合流线;根据组合压气机结构特点,发展了适合其特性计算的损失、落后角模型及计算程序;将特性计算程序与导、静叶角度优化调节方案相结合,确定出不同设计转速下,导、静叶最佳调节角度组合.在90%设计转速,近最高效率点处,利用全三维的数值模拟手段分析了组合压气机导、静叶最佳角度调节前后流场结构变化.研究结果表明:导、静叶角度调节削弱了压气机叶片排中的激波强度,减少了损失,同时能抑制气流的分离,明显改善组合压气机的流场结构.      

Effect of scavenge port angles on flow distribution and performance of swirl-loop scavenging in 2-stroke aircraft diesel engine

Swirl-Loop Scavenging (SLS) improves the performance of 2-stroke aircraft diesel engine because the involved swirl may not only benefit the scavenging process, but also facilitate the fuel atomization and combustion. The arrangement of scavenge port angles greatly influences in-cylinder flow distribution and swirl intensity, as well as the performance of the SLS engine. However, the mechanism of the effect and visualization experiment are rarely mentioned in the literature. To further investigate the SLS, Particle Image Velocimetry (PIV) experiment and Computational Fluid Dynamics (CFD) simulation are adopted to obtain its swirl distribution characteristics, and the effect of port angles on scavenging performance is discussed based on engine fired cycle simulation. The results illustrate that Reynolds Stress Turbulence model is accurate enough for in-cylinder flow simulation. Tangential and axial velocity distribution of the flow, as well as the scavenging performance, are mainly determined by geometric scavenge port angles α_geom and β_geom. For reinforcement of scavenging on cross-sections and meridian planes, α_geom value of 27° and β_geom value of 60° are preferred, under which the scavenging efficiency reaches as high as 73.7%. Excessive swirl intensity has a negative effect on SLS performance, which should be controlled to a proper extent.     

Time delay compensation in lateral-directional flight control systems at high angles of attack

The previous studies of time delay compensation in flight control systems are all based on the conventional aerodynamic derivative model and conducted in longitudinal motions at low angles of attack. In this investigation, the effects of time delay on the lateral-directional stability augmentation system in high-α regime are discussed based on the $\dot{\beta }$ model, which is proposed in our previous work and proved as a more accurate aerodynamic model to reveal the lateral-directional unsteady aerodynamic characteristics at high angles of attack. Both the $\dot{\beta }$ model and the quasi-steady model are used for simulating the effects of time delay on the flying qualities in high-α maneuvers. The comparison between the simulation results shows that the flying qualities are much more sensitive to the mismatch of feedback gains than the state errors caused by time delay. Then a typical adaptive controller based on the conventional dynamic derivative model and a gain-prediction compensator based on $\dot{\beta }$ model are designed to address the time delay in different maneuvers. The simulation results show that the gain-prediction compensator is much simpler and more efficient at high angles of attack. Finally, the gain-prediction compensator is combined with a linearized $\dot{\beta }$ model reference adaptive controller to compensate the adverse effects of very large time delay, which exhibits excellent performance when addressing the extreme conditions at high angles of attack.     

前机身对飞机大迎角气动特性的影响

通过对一些相关文献的分析，得出了前机身外形是要求具有过失速机动能力的飞机气动设计的关键这一结论，并建议在气动布局工作中加强对前机身特性研究。     

斜爆轰波的波角和法向速度-曲率关系初探

为研究斜劈诱导斜爆轰波的波阵面弯曲效应，以期为斜爆轰的不稳定性及其演化规律提供新的见解，基于加权本质无振荡（WENO）格式空间离散和附加Runge-Kutta方法时间离散的求解器，针对不同的化学反应参数（释热量、放热速率和化学反应区参考长度）条件，开展斜爆轰波的数值计算研究。结果表明斜爆轰波沿波阵面的波角变化可分为3个区域：区域I，波角平滑减小；区域II，波角跃升后衰减；区域III，波角有规律振荡。波阵面法向速度-曲率关系在区域I呈现准垂直直线变化趋势，并伴随着爆轰波强度的不断衰减；在区域III则呈现出"D"形曲线，即由极曲线段、光滑水平变化段和拟线性变化段组成，为类胞格结构的周期性演变；区域II可认为是以上两个区域特征的耦合。不同的化学反应参数对斜爆轰波波阵面的弯曲效应影响存在较大差别。     

LES of the Sandia flame series D-F using the Eulerian stochastic field method coupled with tabulated chemistry

In this paper, the Eulerian Stochastic Field (ESF) model in the Transported Probability Density Function (TPDF) class model is combined with the Flamelet Generated Manifolds (FGM) model. This method solves the joint probability density function transport equation by ESF method that considers the interaction mechanism between flame and turbulence with high precision. At the same time, by making use of the advantage of the FGM model, this model is able to incorporate the detailed chemical reaction mechanism (GRI 3.0) with acceptable computational cost. The new model has been implemented in the open source CFD suite-OpenFOAM. Validation of the model has been carried out by simulating the Sandia flame series (three turbulent piloted methane jet flames) issued by the National Laboratory of the United States. The accuracy and advancement of the ESF/FGM turbulent combustion model are verified by comparing the LES results of the new model with the rich experimental data as well as the RANS results. The results demonstrate that the model has a strong ability in capturing combustion phenomena such as extinction and re-ignition in turbulent flame, which is essential in the accurate prediction of the combustion process in real combustion devices, for example, aircraft engines.     

Nonlinear filtering for sequential spacecraft attitude estimation with real data: Cubature Kalman Filter,Unscented Kalman Filter and Extended Kalman Filter

This article compares the attitude estimated by nonlinear estimator Cubature Kalman Filter with results obtained by the Extended Kalman Filter and Unscented Kalman Filter. Currently these estimators are the subject of great interest in attitude estimation problems, however, mostly the Extended Kalman Filter has been applied to real problems of this nature. In order to evaluate the behavior of the Extended Kalman Filter, Unscented Kalman Filter and Cubature Kalman Filter algorithms when submitted to realistic situations, this paper uses real data of sensors on-board the CBERS-2 remote sensing satellite (China Brazil Earth Resources Satellite). It is observed that, for the case studied in this article, the filters are very competitive and present advantages and disadvantages that should be dealt with according to the requirements of the problem.