吸气式脉冲爆震发动机壁温试验

为了探索各频率下管壁温度随时间的变化趋势及爆震管外壁面的温度分布规律,对爆震室内径68mm,长2 000mm,以汽油为燃料、空气为氧化剂的吸气式脉冲爆震发动机进行试验,用热成像仪对稳定工作在10Hz,20Hz,40Hz下的管壁温度进行了监测。结果表明:同一频率下随时间的增加壁面温度增加速度减小;热平衡时壁面温度随频率的增加而增长,10Hz,20Hz,40Hz热平衡时外壁面最高温度分别在726℃,1011.5℃,1159.5℃以上;热平衡前管壁温度的增长速度随频率的增加而增加,管壁温度的增长速度跟频率约成正比;爆震室上沿着压缩波叠加至形成爆震的方向,温度在外壁面上递增分布,在爆震形成区温度最高,从爆震形成区到发动机出口处,温度在外壁面上逐渐降低;各频率下最高温度区位置基本不变,距点火位置1 350mm左右;同一轴向位置上的外壁面温度随频率的增加而增加,温度的增长幅度随频率的增加而减小。     

TC4钛合金超音频直流脉冲TIG焊

首先对超音频直流脉冲TIG焊的特点进行了介绍,重点分析了的峰值电流、脉冲频率等关键工艺参数对超音频直流脉冲TIG焊电弧轴向等离子流力的影响规律.采用频率不同的几组超音频直流脉冲TIG焊工艺及常规直流TIG焊工艺分别焊接了2.5mm厚的TC4钛合金.用X-射线探伤检测焊缝中的气孔缺陷,根据检测结果,分析了超音频直流脉冲T...     

等腰梯形脉宽调制波控制的变频器研究

介绍了一种斜边占π/5的等腰梯形脉宽调制波,从理论上证明了采用这种PWM(PulseWidth Modulation)波控制的变频器,能消除输出电压的5次谐波分量,使输出电压谐波分量小,电流波形好,系统运行时转矩脉动小,可靠、平稳、噪声低.已将这种控制技术应用于某种列车风扇异步电机的变频调速,实验结果与理论分析相吻合.     

基于PD处理技术的雷达弱信号检测方法

针对脉冲跟踪测量雷达普遍存在的远距离弱信号检测能力不足的问题,基于PD（PulseDoppler,脉冲多普勒）雷达的杂波抑制与信号处理技术,提出脉冲雷达中的弱信号检测方法;详细分析了在脉冲跟踪测量雷达中应用PD处理技术的可行性,得出在一定约束条件下,可将PD处理技术运用于脉冲跟踪测量雷达,并提出了具体实现方法;最后,通过数据仿真和脉冲雷达实际测量数据进行验证,结果表明该方法能有效提高信噪比。     

The lower ionosphere response to its disturbances by powerful radio waves

The paper presents data from some campaigns at Sura heating facility in 2011–1016. The experiments on probing of the artificial disturbed region of the lower ionosphere were carried out at two observation sites. One of them was located near Vasil’sursk 1 km from Sura facility (56.1°N; 46.1°E) and the other site was located at the Observatory (55.85°N; 48.8°E) of Kazan State University, 170 km to the East. Investigation of the features of the disturbed region of the lower ionosphere based on its diagnostics by the methods of the vertical sounding and oblique backscattering is the main goal of this paper. Ionosphere disturbance was fulfilled by the effect of the powerful radio wave of the ordinary or extraordinary polarization emitted by transmitters of the Sura facility with effective radiated power ERP = 50–120 MW at the frequency of 4.3, 4.7 and 5.6 MHz. Pumping waves were emitted with period from 30 s to 15 min. The disturbed region of the ionosphere in Vasil’sursk was probed by the vertical sounding technique using the partial reflexion radar at the frequency of 2.95 and 4.7 MHz. For the oblique sounding of the disturbed region the modified ionosonde Cyclon-M, operating at ten frequencies from 2.01 to 6.51 MHz was used at the Observatory site. On many heating sessions simultaneous variations of the probing partial reflection signals in Vasil’sursk and backscattered signals in Observatory were observed at the height at 40–100 km below the reflection height of the pumping wave. These observations were correlated with the pumping periods of the Sura facility. Possible mechanisms of the appearance of the disturbance in the lower ionosphere and its effect on the probing radio waves are discussed.     

固体运载火箭抗强电磁脉冲优化设计方法

本文分析了火箭在飞行过程中的强电磁脉冲(EMP)环境，建立了箭上敏感设备受强电磁脉冲干扰的优化设计模型，包括传导干扰及辐射干扰两种设计模型。针对起飞质量对火箭总体参数设计的制约问题，以最小质量增量为目标函数，采用模拟退火(SA)算法，对箭上典型电气系统抗强电磁脉冲防护进行优化设计研究，为箭上敏感设备抗强电磁脉冲指标与质量增量提供了平衡选取方法。优化结果表明,火箭在飞行过程中典型电气系统的抗强电磁脉冲性能指标达到要求的同时，实现了火箭质量增量最小的目标。     

Calibration of IRI–ITU-R peak density and height over the oceans with topside sounding data

Accuracy of IRI electron density profile depends on the F2 layer peak density and height converted by empirical formulae from the critical frequency and M3000F2 factor provided by the ITU-R (former CCIR). The CCIR/ITU-R maps generated from ground-based ionosonde measurements suffer from model assumptions, in particular, over the oceans where relatively few measurements are available due to a scarcity of ground-based ionosondes. In the present study a grid-point calibration of IRI/ITU-R maps for the foF2 and hmF2 over the oceans is proposed using modeling results based on the topside true-height profiles provided by ISIS1, ISIS2, IK-19 and Cosmos-1809 satellites for the period of 1969–1987. Topside soundings results are compared with IRI and the Russian standard model of ionosphere, SMI, and grouped to provide an empirical calibration coefficient to the peak density and height generated from ITU-R maps. The grid-point calibration coefficients maps are produced in terms of the solar activity, geodetic latitude and longitude, universal time and season allowing update of IRI–ITU-R predictions of the F2 layer peak parameters.     

合成孔径雷达压缩感知成像方法

为解决大带宽、多通道空间雷达系统的数据量大导致数据无法存储和传输的问题,介绍了一种基于压缩感知理论(CS,Compressive Sensing)的、全新的合成孔径雷达数据获取体制和脉冲压缩方法.在观测场景满足一定稀疏特性的前提条件下,使用该方法取代传统的匹配滤波方法进行脉冲压缩处理,可以从远远低于常规雷达所获取的数据量中恢复出原始场景.压缩感知脉冲压缩是通过使用一种贪婪追踪算法解一个逆问题来重建脉冲压缩后的信号.给出了该方法的原理和过程,并通过计算机仿真验证了该方法的有效性.这种新方法可以简化雷达系统,有效降低存储和传输的数据量,将设计重点从昂贵的接收机硬件上转移到智能信号重建算法上去.      

频率捷变反舰导弹导引头相参积累技术研究

将雷达的频率捷变技术与相参技术相结合,分析了在频率捷变条件下,运动目标回波相位的变化规律。影响相参积累的因素包括因频率捷变带来的回波中载频与距离及速度的两个耦合项。并在此基础上提出了利用相位补偿原理来进行有效相参积累的方法,主要包括参差脉冲重复间隔法及基于代价函数的补偿法。算例表明了方法的可行性、通用性,具有一定的理论和实践指导意义。     

精密定轨中三类经验加速度的有效建模方法

根据瞬时速度脉冲、逐段常量经验加速度和周期性摄动加速度模型的特点,分别给出敏感矩阵的有效计算方法,以及最小二乘批处理的设计矩阵和法方程矩阵的分块结构。该建模方法将灵敏度矩阵数值积分规模和存储规模降为O(n),而传统方法为O(n 2)。应用GRACE-A星载GPS观测数据对法方程的计算效率测试,结果表明：对于瞬时速度脉冲和逐段常量经验加速度模型,当采用伪距观测量时,法方程构建效率提高1倍;当采用伪距加载波相位观测量时,效率提高3.5倍。对于周期性摄动加速度模型,效率没有明显提高,主要原因在于模型参数较少,矩阵分块建模方法的优越性尚未体现。