基于有限体积法和SNBCK模型的红外辐射特性计算

耦合求解流场、组分浓度场、基于SNBCK模型的气体辐射传输/能量方程以求准确模拟飞行器排气系统气动热力及红外特性.窄带模型参数由HITEMP逐线计算数据库计算得到.通过CO₂4.3μm波段吸收率计算,圆柱炉膛辐射换热特性计算两个算例验证了所采用程序求解辐射传输/能量方程的准确性.最后计算了两种二元喷管的红外特性,结果表明大宽高比二元喷管地面和空中状态红外辐射特性差异巨大.     

基于自由权矩阵的时变时延线性群系统编队控制

研究了基于自由权矩阵方法的时变时延线性群系统编队控制问题。首先,基于一致性理论,设计了具有时变时延的线性群系统编队控制协议。其次,通过变量代换,将时延条件下的线性群系统编队控制问题转化为时延系统的镇定问题。构造Lyapunov-Krasovskii函数,并利用自由权矩阵方法对时延系统的镇定问题进行分析,得到了保守性较小的线性矩阵不等式（LMI）判据,并求解出时延上界和编队控制器增益。最后,通过仿真实验,验证了方法的有效性。     

ARINC 653分区实时系统的可调度分析

ARINC 653规范定义了综合模块化航空电子(IMA)实时操作系统的行为逻辑以及向应用程序提供的接口规范。该规范规定了系统采用分区内调度和分区间调度的两级调度方案,如何分析系统的可调度性以保证实时任务能够在截止时间内完成计算是需要研究的新问题。基于负载请求与平台资源提供能力的供需约束关系导出了系统可调度的判定依据。证明了判据的约束是系统可调度的充分必要条件。实际应用表明,提出的可调度判定定理能够应用于判定ARINC 653分区实时系统的可调度性,辅助提升系统的安全属性。     

具有轨道倾角和最大高度约束的耗尽关机闭路制导

快速响应空间固体运载火箭轨道转移级以最大限度利用能量而非消耗能量为目的进行耗尽关机制导,基于椭圆轨道理论和牛顿迭代法,提出了一种适用于具有轨道、制导多种约束的耗尽关机闭路制导方法,通过实时寻找需要推力方向,充分利用轨道转移级能量,导引上面级进入具有给定轨道倾角和最大高度约束的转移轨道,同时实现耗尽关机.理论推导和数学仿真表明,本文提出的制导方法能在耗尽关机条件下实现对转移轨道的高精度控制.     

Optimization of geosynchronous satellite constellation for independent regional navigation and positioning in Middle East region

Regional Navigation and positioning systems using geosynchronous satellites are emerging for different parts of the world. Optimal constellation geometry achievement for a set of geosynchronous satellites is a key sector in designing of such systems. Genetic algorithm is applied for optimization of constellations with 6 and 7 satellites which is to be used in Middle East region where these systems have been deprived of. Based on the fact that the coverage criterion is not sufficient enough to guarantee a good navigation service, positioning process by the satellite systems is discussed and the performance of the system on the basis of position dilution of precision is collected as the fitness criterion. Placing the satellites in groups to pass over the same ground track is applied as a constraint to the genetic algorithm. By simulation, performance of the best obtained results and GPS are compared in terms of position dilution of precision, visibility and the required epochs (time span) to resolve the ambiguities with a 99% success rate, in this region. Also, capability of the GA for such problems is demonstrated.     

On the large-scale structure of the tail current as measured by THEMIS

The magnetic field structure and the spatial characteristics of the large-scale currents in the magnetospheric tail were studied during quiet and moderately disturbed geomagnetic conditions in 2009. The magnetic field of the currents other than the tail current was calculated in terms of a paraboloid model of the Earth’s magnetosphere, A2000, and was subtracted from measurements. It was found on the base of obtained tail current magnetic field radial distribution that the inner edge of the tail current sheet is located in the night side magnetosphere, at distances of about 10 R_E and of about 7 R_E during quiet and disturbed periods respectively. During the disturbance of February 14, 2009 (Dst_min ∼ −35 nT), the B_x and the B_z component of the tail current magnetic field near its inner edge were about 60 nT, and −60 nT that means that strong cross-tail current have been developed. The tail current parameters at different time moments during February 14, 2009 have been estimated. Solar wind conditions during this event were consistent with those during moderate magnetic storms with minimum Dst of about −100 nT. However, the magnetospheric current systems (magnetopause and cross-tail currents) were located at larger geocentric distances than typical during the 2009 extremely quiet epoch and did not provide the expected Dst magnitude. Very small disturbance on the Earth’s surface was detected consistent with an “inflated” magnetosphere.     

基于模型的系统工程方法在载人航天任务中的应用探讨

针对基于文档的航天任务设计中设计数据分散、一致性差、跟踪难度大等问题,引入了基于模型的系统工程(MBSE)方法。首先,介绍了MBSE方法理念,即通过构建图形化的模型来支持系统的需求捕获、设计、分析、验证和确认等全生命周期活动。然后,给出了MBSE方法的一般工作流程,即先构建系统的需求模型,用于指导功能模型、物理架构模型等的构建,按照事先制定好的逻辑规则建立模型间的关系,依靠模型间的关系实现设计过程中的关联性分析、参数查询等工作。最后,应用MBSE方法于载人飞船交会对接任务中。结果表明,此方法改善了人员沟通,提高了设计效率,降低了设计风险,可为MBSE方法在航天任务设计中的进一步应用提供参考。     

捷联式天线稳定平台动力学建模与仿真分析

对于体积有限制的战术导弹应用,导引头天线伺服系统的体积受到严格限制,传统的速率陀螺稳定平台的应用受到挑战,为此提出采用捷联稳定方式来解决视线稳定问题.根据弹载捷联式天线平台的结构特点及稳定原理,应用坐标变换方法,完整地建立了两自由度捷联式天线平台的运动学与动力学模型.通过分析平台框架运动学耦合关系,表明捷联稳定方式与速率陀螺稳定方式的基本区别在于信息的获取和控制方式上,速率陀螺稳定方式是一种直接硬件稳定方法,而捷联稳定方式是一种软件补偿方法.在此基础上,对框架动力学耦合特性进行了数值仿真,结果表明:弹体对框架的耦合较强,需要进行弹体解耦,而框架之间的交叉耦合相对较弱,实际设计时可以忽略.所得结果为进一步研究捷联式天线稳定平台提供了理论基础,也为小型化导引头视线稳定平台系统的工程设计提供了一种解决方案.     

离散广义Markov跳变系统的镇定性

针对转移概率部分未知情况下的离散时间广义Markov跳变系统,研究了系统的稳定性和镇定性。转移概率部分未知的情况包含了转移概率完全已知和完全未知两种特殊情况,具有更广泛的实际意义。首先利用线性矩阵不等式方法,将离散Markov跳变系统的结论推广到离散广义Markov跳变系统,提出了使开环系统随机稳定的充分条件;在此基础上,进一步提出了闭环系统可镇定的判据,并表示为线性矩阵不等式形式;最后,通过仿真算例验证了所提方法的有效性。