连接压力在Ti/Ni/Ti复合层TLP扩散连接Si3N4陶瓷中的作用机制

研究了Ｔｉ／Ｎｉ／Ｔｉ复合层ＴＬＰ扩散连接Ｓｉ３Ｎ４陶瓷时压力对接头形成的作用机制。结果表明,ＴＬＰ来不及与陶瓷发生充分反应并形成高强度结合界面就已完全凝固,为形成高强度的结合界面,必须进一步发生固态扩散反应。只有当连接过程中施加足够的压力,才能保证ＴＬＰ在其存在期间充分铺展陶瓷,并在ＴＬＰ完全凝固后形成大量扩散通道,为固态扩散反应提供必要条件。     

基于Socket的网络中间件开发技术

对基于Scoket的网络中间件的开发机理及编程方法作一简要的概述.对使用队列方法解决Socket在同一过程中发送与接收多个消息的方法进行了论述.     

Temporal evolution of the EIA along 95°E as obtained from GNSS TEC measurements and SAMI3 model

The total electron content (TEC) derived from GNSS measurements at a trans-hemispheric meridional chain of ground stations around 95°E longitude are used to study the quiet time inter-hemispheric structure and dynamics of the equatorial ionization anomaly (EIA) during the period March 2015 to February 2016. The stations are Dibrugarh (27.5°N, 95°E, 43° dip), Kohima (25.6°N, 94.1°E, 39° dip), Aizawl (23.7°N, 92.8°E, 36° dip), Port Blair (11.63°N, 92.71°E, 9° dip) and Cocos Islands (12.2°S, 96.8°E, 43° dip). The observation shows that the northern crest of the EIA lies in the south of 23°N (Aizawl) in all seasons but recedes further south towards the equator during December solstice. The largest poleward expansion of the northern (southern) EIA is observed in the March equinox (December solstice). The equinoctial and hemispherical asymmetry of TEC is noted. The winter anomaly is observed in the northern hemisphere but not in the southern hemisphere. The highest midday TEC over any station is observed in the March equinox. The TEC in southern summer (December solstice) is significantly higher than that in the northern summer (June solstice). The observed northern EIA contracts equatorward in the postsunset period of solstice but the southern EIA persists late into the midnight in the December solstice. The asymmetry may be attributed to the different geographic location of the magnetically conjugate stations. The SAMI3 simulations broadly capture the EIA structure and the inter-hemispheric asymmetry during solstices. The difference between observations and the SAMI3 is higher in March equinox and December solstice. The higher E?×?B vertical drift in the 90–100°E sector and the large geographic-geomagnetic offset in observing stations may have contributed to the observed differences.     

柔性薄壁结构电子束焊接的变形控制

基于电子束焊接方法,探讨了功率分出轴柔性薄壁结构真空电子束焊接过程中的变形控制方法,提出了综合应用最小焊接热输入、减小焊接重叠角度和合理焊接装配及散热相结合的变形控制方法,有效地控制了焊接变形,实现了电子束焊接柔性薄壁结构的制造。     

局域网网络操作系统选型的探讨

通过对NTServer4.0和NetWare4.11两大主流网络操作系统的分析、探讨,简述了网络操作系统选型的基本步骤、原则以及网络操作系统升级时应考虑的因素。     

基于高分四号数据的多时相多通道云检测算法

针对高分四号（GF-4）卫星影像波段较少导致传统云检测算法难以区分云与冰雪像元的问题,提出一种多时相多通道云检测算法。该算法首先对GF-4卫星影像进行辐射定标和配准,然后利用云与典型地表的光谱差异得到潜在云像元,之后利用序列GF-4卫星影像之间的差异识别出移动的云像元,最后利用中红外波段反演地表亮度温度来去除冰雪像元。该算法在海南、辽宁和安徽3个研究区域进行验证,并将检测结果与传统单时相云检测算法、支持向量机（SVM）云检测算法和实时差分（RTD）云检测算法的检测结果进行对比。结果表明,该算法优于其他3种云检测算法,准确识别率均达到90%以上,误检率均低于5%,有利于GF-4卫星影像的进一步利用。     

Evaluation of airborne data link communication

An experimental prototype of a cockpit data link communication interface (modified Navigation Display (ND) and Multi-purpose Control and Display Unit (MCDU)) was developed and tested in an Airbus A340 Full Flight Simulator. 8 crews (16 professional pilots) performed simulator flights in a mixed voice and data link scenario. After each experiment video recordings were presented to the pilots and they were asked to estimate subjective strain (NASA task load index) and situational aspects retrospectively. Results show an increase in subjective strain and a decrease of ‘feeling of sovereignty’ and situation awareness under data link conditions. The effect is similar to the one caused by higher workload.     

气氧/甲烷与气氢/气氧喷注器燃烧特性对比研究

为了获得气氧/甲烷与气氢/气氧两种推进剂组合燃烧特性的异同,将氢/氧气-气啧注器的设计经验用于气氧/甲烷气-气喷注器设计,在同一燃烧室中针对气氧/甲烷与气氢/气氧同轴剪切喷注器燃烧特性开展了数值仿真与试验研究.结果表明:在喷注器设计参数相似的情况下,气氧/甲烷喷注器尺寸与气氢/气氧喷注器尺寸相当;在相同的燃烧室设计压力、结构尺寸,以及两种推进剂组合均完全燃烧的情况下,要产生相同的推力,气氧/甲烷(混合比3.5)推进剂流量约为氢/氧(混合比6.0)推进剂流量的1.27倍,气氧/甲烷燃烧所需燃烧室特征长度约为氢/氧燃烧室特征长度的1.48倍,气氧/甲烷燃烧室壁面热载约为氢/氧燃烧室壁面热载的一半.     

一种航路4D航迹预测的方法

4D航迹预测是空管自动化系统中的一项核心技术,能够提高空域的利用率和安全性。为了在航路上快速准确的预测航空器的飞行轨迹,提出一种预测航路4D航迹的方法。首先利用Supermap制作航路网络,然后根据航空器的性能参数,推测各时间点的航空器位置,从而得到航路上航空器的飞行航迹,并通过实例进行了说明,为航迹预测提供一定参考。