The development of a Russian communication satellite of small class, operating in the geostationary and high-elliptical orbits

In 1994-1995 Lavochkin Association (Russia) together with the other enterprises in accordance with technical requirements of the Russian Space agency, developed a new Russian communication satellite of a small class that will operate in both the geostationary (GSO) and high-elliptical (HEO) orbits. This satellite may be injected into operational orbits using a SOYUZ-2 launch vehicle (LV) and a FREGAT upper stage (US) from Plesetsk and Baykonur space launch sites (SLS).The main reason for creating such a satellite was to decrease the cost of the support and development of the Russian communication geostationary satellites group.Russian satellites Horizont, Express, Ekran and Gals, which operate in GSO, are the basis of the space segment for communications, radio and TV broadcasting. All of these satellites are injected into GSO by the PROTON LV. PROTON is a launch vehicle of a heavy class. The use of a middle class LV instead of a heavy class will allow to reduce considerably the launch cost. The change of a heavy class LV to a LV of middle class determined one economic reason for this project. Besides, the opportunity to launch S/C into GSO from Russian Plesetsk SLS increases the independence of Russia in the domain of space communications, despite the presence of the contract with Kazachstan about the rent of Baykonur SLS. Finally, use of small satellites with a rather small number of transponders is more effective than the use of big satellites. It will allow also to increase a satellite group (by the launch of additional satellites) precisely in accordance to the development of the ground segment.     

机动再入飞行器自适应飞行控制系统设计

研究机动再入飞行器的制导控制问题。为了解决机动再入飞行器气动系数变化范围大、气动耦合严重和气动参数非线性过零常值大等恶劣条件下的控制，并且能充分利用飞行器可测量信息提高系统自适应能力，本文提出了状态方程参数辨识－－极点配置－－前馈补偿自适应控制的飞行控制系统的设计方法。通过对新型号再入飞行器的制导系统仿真，可以看出该控制系统使其有很好的飞行性能。     

机动再入飞行器的复合制导方案研究

对机动再入飞行器弧段的复合制导方案进行了研究，首先提出了通过高低空复合制导控制再入飞行器的终端速度和弹道倾角的思路；然后分别给出了高空最优制导律和大气厚再入最优制导律；最后对此复合制导方案进行了数字仿真。仿真结果表明此方案在理论上是可行的。     

再入制导和弹道跟踪误差分析

新一代可重复使用运载器对再入制导提出了更高地要求。目前的空间运输系统证明基于阻力加速度的制导方法是行之有效的。其基本概念是跟踪基准阻力加速度包线，在飞行过程中可根据需要更新这个包线。跟踪适当的阻力加速度包线保证了飞行器可以飞行准确的距离达到目标，同时满足弹道约束。在横向上，我们可采用类似于美国航天飞机的倾斜反转逻辑或航向角跟踪技术。本文推导出了基于反馈线性化的控制算法，并将其应用于可重复使用运载器纵向和横向的制导。最后，我们分析了阻力加速度跟踪的误差。     

高空高速无人飞行器热控制系统设计

针对飞行时间短、速度和高度变化快、表面温度波动大的无人飞行器UAV(Unmanned Aerial Vehicles)热控制系统设计难题,提出了一种可解决实际工程问题的热分析计算方法.即把热天工况、冷天工况和标准天工况作为设计/试验工况;采用参考温度法、高超音速工程预测法或计算流体动力学CFD(Computational Fluid Dynamics)数值模拟法,确定了飞行器表面温度分布,并把其作为后续热分析数学模型的外边界条件;分析结构热容量对瞬态热载荷的影响,建立与之相应的边值问题方程,并采用有限差分法求解;根据高空高速飞行特点及瞬态热载荷值,确定仪器设备舱调温系统方案.     

Modeling novel methodologies for unmanned aerial systems–Applications to the UAS-S4 Ehecatl and the UAS-S45 Bálaam

The rising demand for Unmanned Aerial Systems(UASs) to perform tasks in hostile environments has emphasized the need for their simulation models for the preliminary evaluations of their missions. The efficiency of the UAS model is directly related to its capacity to estimate its flight dynamics with minimum computational resources. The literature describes several techniques to estimate accurate aircraft flight dynamics. Most of them are based on system identification. This paper presents an alternative methodology to obtain complete model of the S4 and S45 unmanned aerial systems. The UAS-S4 and the UAS-S45 models were divided into four sub-models, each corresponding to a specific discipline: aerodynamics, propulsion, mass and inertia, and actuator. The‘‘aerodynamic" sub-model was built using the Fderivatives in-house code, which is an improvement of the classical DATCOM procedure. The ‘‘propulsion" sub-model was obtained by coupling a two-stroke engine model based on the ideal Otto cycle and a Blade Element Theory(BET) analysis of the propeller. The ‘‘mass and the inertia" sub-model was designed utilizing the Raymer and DATCOM methodologies. A sub-model of an actuator using servomotor characteristics was employed to complete the model. The total model was then checked by validation of each submodel with numerical and experimental data. The results indicate that the obtained model was accurate and could be used to design a flight simulator.     

WSO-UV project

During last three decades, astronomers have enjoyed continuous access to the 100–300 nm ultraviolet (UV) spectral range where the resonance transitions of the most abundant atoms and ions (at temperatures between 3000 and 300 000 K) reside. This UV range is not accessible from ground-based facilities. The successful International Ultraviolet Explorer (IUE) observatory, the Russian ASTRON mission and successor instruments such as the Galaxy Evolution Explorer (GALEX) mission or the COS and STIS spectrographs on-board the Hubble Space Telescope (HST) prove the major impact of observations in the UV wavelength range in modern astronomy. Future access to space-based observatories is expected to be very limited. For the next decade, the post-HST era, the World Space Observatory – Ultraviolet (WSO–UV) will be the only 2-m class UV telescope with capabilities similar to the HST. WSO–UV will be equipped with instruments for imaging and spectroscopy and it will be a facility dedicated, full-time, to UV astronomy. In this article, we briefly outline the current status of the WSO–UV mission and the science management plan.     

Particle swarm optimization applied to hypersonic reentry trajectories

This paper presents the novel use of the particle swarm optimization(PSO)to generate the end-to-end trajectory for hypersonic reentry vehicles in a quite simple formulation.The velocitydependent bank angle profile is developed to reduce the search space of unknown parameters based on the constrained PSO algorithm.The path constraints are enforced by setting the fitness function to be infinite on condition that the particles violate the maximum allowable values.The PSO algorithm also provides a much easier means to satisfy the terminal conditions by adding penalty terms to the fitness function.Furthermore,the approximate reentry landing footprint is fast constructed by incorporating an interpolation model into the standardized bank angle profiles.Numerical simulations demonstrate that the PSO method is a feasible and flexible tool to generate the end-to-end trajectory and landing footprint for hypersonic reentry vehicles.     

基于多模型预测的再入飞行器制导方法

在具有控制和轨迹约束的再入制导中,提出了一种新的基于多模型预测再入飞行器纵向制导方法。首先对再入飞行器的纵向运动方程沿着标准轨道线性化,基于分段仿射约束系统建模理论逼近原非线性系统,并采用线性矩阵不等式(LMIs)优化技术离线将保证闭环系统稳定的终端二次代价项求出;然后,在每个制导周期内,基于多模型预测在线求解构造好的有限时域优化目标,从而获得控制量的增量,并把第一个控制增量分量与标准轨道的控制量叠加后形成全量控制,用于实际再入轨道的制导,而在下一个制导周期基于新的状态参数重复上面的优化过程。数字仿真结果证实了所提方法的有效性。     

高超声速飞行器控制面热防护系统地面试验研究

针对高超声速飞行器控制面研发手段中极其重要的地面试验技术,以X-37轨道飞行器为例,介绍了国外的最新研究进展和关键技术解决途径,以及指导地面试验研究的方法,并针对控制面方案在评估和鉴定中必不可少的高温模态试验,进行了综述和分析。