内并联型TBCC进气道方案设计及验证

提出了一种带可变几何泄流腔的内并联型涡轮基组合循环(TBCC)进气道设计方案.介绍了进气道的总体设计思路,给出了进气道的设计马赫数、转级马赫数及飞行轨迹,对不同来流条件下进气道的工作方式以及全马赫数范围进气道型面调整的安排进行了论述,确定了进气道主要气动参数与型面参数的选取原则.通过数值模拟和高速风洞试验的手段,对进气道设计方案的可行性进行了验证.数值模拟结果表明:当Ma₀≤2.5时,进气道的总压恢复系数均在0.8以上,当2.5<Ma₀≤4.5时,进气道的总压恢复系数均在0.3以上,符合进气道总体方案的要求;冲压模态下,冲压通道的出口马赫数均小于0.4,出口静压均大于0.5个标准大气压,均能满足冲压燃烧室的燃烧需求.风洞试验结果表明:模态转换过程中,进气道涡轮通道具有良好的进/发匹配特性,且进气道涡轮/冲压通道具有良好的相容性能.研究结果可为我国开展组合动力研究提供方案参考和技术储备.      

一种改进的直接转矩控制算法

分析了转矩角与定转子磁链角速度及电机速度的关系,提出一种新的直接转矩控制算法.通过转矩角增量和定转子磁链的位置,计算出补偿转矩和定子磁链的参考电压矢量,基于空间矢量调制技术实现对逆变器电压状态的控制,改善了系统的性能.给出了仿真结果,证明了算法的合理性和有效性.     

不同迎角的翼型气弹特性风洞实验研究

基于可在不同迎角下作沉浮、俯仰两自由度运动的翼段振动装置,在低速风洞中分别针对普通薄翼型NA-CA0012和风力机翼型NREL S809进行气动弹性测试,得到不同实验状态的气动弹性振动时域响应。分别观察到经典颤振和失速颤振现象,并证明了迎角改变对两种翼型颤振特性的影响。     

Magnetospheric disturbances associated with the 13 December 2006 solar flare and their ionospheric effects over North-East Asia

We present an observational study of magnetospheric and ionospheric disturbances during the December 2006 intense magnetic storm associated with the 4В/Х3.4 class solar flare. To perform the study we utilize the ground data from North–East Asian ionospheric and magnetic observatories (60–72°N, 88–152°E) and in situ measurements from LANL, GOES, Geotail and ACE satellites. The comparative analysis of ionospheric, magnetospheric and heliospheric disturbances shows that the interaction of the magnetosphere with heavily compressed solar wind and interplanetary magnetic field caused the initial phase of the magnetic storm. It was accompanied by the intense sporadic E and F2 layers and the total black-out in the nocturnal subauroral ionosphere. During the storm main phase, LANL-97A, LANL 1994_084, LANL 1989-046 and GOES_11 satellites registered a compression of the dayside magnetosphere up to their orbits. In the morning–noon sector the compression was accompanied by an absence of reflections from ionosphere over subauroral ionospheric station Zhigansk (66.8°N, 123.3°E), and a drastic decrease in the F2 layer critical frequency (foF2) up to 54% of the quite one over subauroral Yakutsk station (62°N, 129.7°E). At the end of the main phase, these stations registered a sharp foF2 increase in the afternoon sector. At Yakutsk the peak foF2 was 1.9 time higher than the undisturbed one. The mentioned ionospheric disturbances occurred simultaneously with changes in the temperature, density and temperature anisotropy of particles at geosynchronous orbit, registered by the LANL-97A satellite nearby the meridian of ionospheric and magnetic measurements. The whole complex of disturbances may be caused by radial displacement of the main magnetospheric domains (magnetopause, cusp/cleft, plasma sheet) with respect to the observation points, caused by changes in the solar wind dynamic pressure, the field of magnetospheric convection, and rotation of the Earth.     

激光外差干涉技术在固体发动机振动中的应用

利用激光外差干涉技术对工作中固体火箭发动机的振动频率及强度进行了研究。在实验室环境下建立一套激光外差干涉系统,对某型号发动机进行振动测量实验。实验表明,激光外差干涉测振系统测量带宽7.8 Hz,测量标准偏差小于5.6×10-8,振镜实验测量结果与振源频率相吻合,系统探测信号强度和物体振幅呈线性关系。激光外差干涉技术在发动机振动测量过程中具有一定的应用价值。     

基于粒子轨迹的结冰风洞收缩段优化设计数值模拟

为了研究收缩段型面和液滴轨迹特性对结冰风洞流场品质与结冰试验效果的重要影响,获得收缩段的优化设计参数,采用数值模拟方法,使用二维简化模型对3m×2m结冰风洞收缩段的流场特性进行了研究,对几种典型收缩曲线的流场进行了计算,对比了收缩曲线对沿轴向压力分布、出口截面速度分布、不同粒径云雾粒子的极限释放距离及试验段入口云雾粒子分布的影响,结果表明:三次曲线与x_m为0.4的五次曲线不能满足流场合格指标,其他曲线流场特性差别不大,维氏曲线具有最小极限释放距离,在收缩段出口,三次曲线和五次曲线粒子包络面积最大,综合比较,x_m为0.5的五次曲线能有效兼顾流场均匀性、极限释放距离和收缩段出口粒子包络面积比.      

某起动机转速切断装置自动测控系统设计

采用高速单片机C8051F020和VNH3SP30单封装全桥电机驱动芯片控制电机上升速度并进行转速等数据采集,设计出某飞机起动机部件-转速切断装置组件地面测控系统。实际使用证明该系统能确保转速上升斜率的一致性,捕捉到的切断转速值可靠,并且工作稳定、性价比高、人机界面友好。     

Designing method of acceleration and deceleration control schedule for variable cycle engine

Studies show that different geometries of a Variable Cycle Engine (VCE) can be adjusted during the transient stage of the engine operation to improve the engine performance. However, this improvement increases the complexity of the acceleration and deceleration control schedule. In order to resolve this problem, the Transient-state Reverse Method (TRM) is established in the present study based on the Steady-state Reverse Method (SRM) and the Virtual Power Extraction Method (VPEM). The state factors in the component-based engine performance models are replaced by variable geometry parameters to establish the TRM for a double bypass VCE. Obtained results are compared with the conventional component-based model from different aspects, including the accuracy and the convergence rate. The TRM is then employed to optimize the control schedule of a VCE. Obtained results show that the accuracy and the convergence rate of the proposed method are consistent with that of the conventional model. On the other hand, it is found that the new-model-optimized control schedules reduce the acceleration and deceleration time by 45% and 54%, respectively. Meanwhile, the surge margin of compressors, fuel–air ratio and the turbine inlet temperature maintained are within the acceptable criteria. It is concluded that the proposed TRM is a powerful method to design the acceleration and deceleration control schedule of the VCE.     

电推进静止轨道转移与空间环境分析

针对基于连续电推进的由GTO轨道向地球静止轨道的转移问题,考虑星上自主变轨的计算能力,将轨道转移简化为推力方向固定的两阶段变轨策略,对轨控方向角进行优化.针对电推进轨道转移持续时间长,受空间环境影响较大的特点,对轨道转移过程中卫星穿越电离层、地球辐射带的情况进行分析.最后,进一步探讨了利用远地点高度高于标准GTO的轨道作为初始轨道,用以降低空间环境对卫星影响的可行性.