基于模板匹配整帧屏幕视频帧内无损编码方法

当前主流的视频压缩标准,如H.264、HEVC等,主要是针对摄像机拍摄的视频而设计的.而屏幕内容(SC)的视频是由计算机生成的,无噪声,要求更高的压缩效率,同时与摄像机拍摄的视频相比包含更多的结构相似性.提出了一种利用屏幕视频中相似性的模板匹配帧内编码方法,采用由21个像素点组成的模板,以像素点为最小单位对整帧进行模板匹配,并使用哈希函数实现高效的模板查找,最后对残差图像进行熵编码.实验结果显示,与标准的HEVC扩展方法相比,该方法在无损编码上压缩率可以提高一倍,编码时间减小了近一半.      

Traveling ionospheric disturbances observed at South African midlatitudes during the 29–31 October 2003 geomagnetically disturbed period

This paper presents traveling ionospheric disturbances (TIDs) observations from GPS measurements over the South African region during the geomagnetically disturbed period of 29–31 October 2003. Two receiver arrays, which were along two distinct longitudinal sectors of about 18°-20° and 27°-28° were used in order to investigate the amplitude, periods and virtual propagation characteristics of the storm induced ionospheric disturbances. The study revealed a large sudden TEC increase on 28 October 2003, the day before the first of the two major storms studied here, that was recorded simultaneously by all the receivers used. This pre-storm enhancement was linked to an X-class solar flare, auroral/magnetospheric activities and vertical plasma drift, based on the behaviour of the geomagnetic storm and auroral indices as well as strong equatorial electrojet. Diurnal trends of the TEC and foF2 measurements revealed that the geomagnetic storm caused a negative ionospheric storm; these parameters were depleted between 29 and 31 October 2003. Large scale traveling ionospheric disturbances were observed on the days of the geomagnetic storms (29 and 31 October 2003), using line-of-sight vertical TEC (vTEC) measurements from individual satellites. Amplitude and dominant periods of these structures varied between 0.08–2.16 TECU, and 1.07–2.13 h respectively. The wave structures were observed to propagate towards the equator with velocities between 587.04 and 1635.09 m/s.     

谈住宅小区给水方案设计

本文讨论了我市住宅小区生活、消防给水系统的水平和状况。     

轨姿控液体火箭发动机水击仿真模拟

以轨姿控液体火箭发动机为研究对象,根据模块化思想,利用AMESim建立了仿真平台,仿真计算了发动机系统工作中管路的水击压力。结果表明:轨控发动机的工作是引起大水击的主要因素。通过与理论计算和试验数据的对比表明,仿真模型较好地描述了管路水击的生成过程。介绍了减小系统水击量的措施。     

Ionospheric disturbances on 8 September, 2010: Was it connected with the incoming moderate Chongqing earthquake?

Earthquake prediction stimulates the searches for a correlation between seismic activity and ionospheric anomalies. Contrary to common focuses on strong earthquakes, we report the ionospheric disturbances, 2 days before a moderate Ms = 4.7 Chongqing earthquake (29.4°N, 105.5°E, depth = 7.0 km, occurred at 21:21 LT, 10 September, 2010) with the data of ground-based ionosondes and IGS receivers. The data covering the period under the quiet geomagnetic conditions and a geomagnetic storm was analyzed with upper and lower bounds. It is found that there were significant enhancements of foF2 and total electron content (TEC) on the afternoon of 8 September, 2010, with a limited area close to the epicentre, which was different from the feature of ionospheric perturbations triggered by the geomagnetic storm on 15 September. Taking into account the heliogeomagnetical condition, we conclude that the observed ionospheric enhancements were very likely associated with the forthcoming moderate Chongqing earthquake, which implies that the relationship between the amplitudes of ionospheric disturbances and earthquakes is very complicated.     

关于廊坊市水资源保护的几点设想

本文首先介绍了廊坊市水资源保护的严峻形势,接着又以实现"三个转变"、构筑"四个体系"、做好"五项工作"谈了关于做好廊坊市水资源保护工作的几点设想。     

浆料固相含量对多孔氮化硅陶瓷结构和性能的影响

以琼脂糖作为凝胶物质,采用凝胶注模工艺制备了多孔氮化硅陶瓷,通过改变浆料的固相含量,制备了不同性能的多孔氮化硅陶瓷.结果表明,随着浆料的固相含量从35vol％增加到45vol％,材料的气孔率从57.6％减小至40.8％,弯曲强度从96 MPa增加到178 MPa;大量的长棒状β-Si3N4晶粒从孔壁上生长出来,将气孔填充,其生长方式为溶解-沉淀-析出与气-液-固两种生长机制协同作用的结果.长棒状的氮化硅晶须和恰当的界面结合强度是多孔氮化硅陶瓷具有较高强度的主要原因.     

Assessment of the NeQuick model at mid-latitudes using GNSS TEC and ionosonde data

The modelling of the total electron content (TEC) plays an important role in global navigation satellite systems (GNSS) accuracy, especially for single-frequency receivers, the most common ones constituting the mass market. For the latter and in the framework of Galileo, the NeQuick model has been chosen for correcting the ionospheric error contribution and will be integrated into a global algorithm providing the users with daily updated information.     

模拟地热水温度对镀锌钢管腐蚀与结垢的影响

针对地热水环境中金属管道常见的腐蚀与结垢问题,采用扫描电子显微镜、能谱仪、X射线衍射仪等研究了不同温度的模拟地热水中镀锌钢管的腐蚀与结垢行为.结果表明:实验前期镀锌钢管的表面出现两种形貌("球"状和"针"状),不同温度的地热水中腐蚀与结垢产物的晶体形状不同,产物成分主要为Zn(OH)2,ZnO,CaCO3和MgCO3;镀锌钢管表面产物的分布对镀锌钢管在模拟地热水中的进一步腐蚀有一定程度的抑制;50℃地热水中的镀锌钢管表面的腐蚀坑面积较小,而在65℃和80℃地热水中腐蚀坑面积较大,镀锌钢管的腐蚀与结垢速度随地热水温度的升高而增大.     

试验台冷却水系统水击压力仿真研究

液体火箭发动机试验台冷却水供应管路具有长度长、管径大的特点.发动机试验过程中,由于阀门动作过快所产生的水击压力会对试验台冷却水供应系统的安全可靠运行产生严重影响.针对该问题,借助系统流动特性瞬态仿真软件,建立了某试验台冷却水供应系统水击压力仿真平台.通过特征线法对系统内水击压力的变化情况进行了仿真计算,并将仿真结果与放水试验时的实测值进行了对比分析,验证了所建立模型的计算准确性并分析了误差产生的主要原因.在此基础上,分析了关阀策略及管路配置对系统内水击压力的影响,提出了优化阀门动作顺序及开启手动旁通阀2种降低试验台冷却水系统水击压力的方法.仿真结果显示,通过采用以上2种方法能够有效降低水击压力峰值,同时增大其衰减速率.