不锈钢、钛合金导管高频钎焊工艺方法的改进

高频钎焊焊接方法在国内外进行研究的院校和公司相对较少，是一项较新的钎焊方法。国外在此项焊接工艺的研究和应用走在世界的前列。国内一直处于不断摸索和改进的过程中，焊接过程始终存在一些问题。通过本课题技术研究和相关的试验，详细地介绍了高频钎焊设备、工艺方法和高频钎焊工艺参数确定等方面的应用。     

简单实用的步进电机驱动电源

本文介绍了利用ＥＰＲＯＭ芯片构成步进电机的驱动电源，并对驱动电源及频率混同电路进行了分析和设计。     

Influence of ionospheric perturbations in GPS time and frequency transfer

The stability of GPS time and frequency transfer is limited by the fact that GPS signals travel through the ionosphere. In high precision geodetic time transfer (i.e. based on precise modeling of code and carrier phase GPS data), the so-called ionosphere-free combination of the code and carrier phase measurements made on the two frequencies is used to remove the first-order ionospheric effect. In this paper, we investigate the impact of residual second- and third-order ionospheric effects on geodetic time transfer solutions i.e. remote atomic clock comparisons based on GPS measurements, using the ATOMIUM software developed at the Royal Observatory of Belgium (ROB). The impact of third-order ionospheric effects was shown to be negligible, while for second-order effects, the tests performed on different time links and at different epochs show a small impact of the order of some picoseconds, on a quiet day, and up to more than 10 picoseconds in case of high ionospheric activity. The geomagnetic storm of the 30th October 2003 is used to illustrate how space weather products are relevant to understand perturbations in geodetic time and frequency transfer.     

Constant power H∞ stabilization control strategy on airborne pump supplying system

以机载泵源系统的恒功率控制为目标，针对作业任务中系统负载随时间变化的情况，采用使液压系统输出功率保持恒定的控制方式来达到充分利用发动机功率的目的，对于机载泵源控制系统的主要被控对象——轴向柱塞式变量泵，建立了其状态方程和流量输出方程，采用H。鲁棒镇定控制策略实时调节泵的排量，仿真结果表明：当负载变化时，系统能根据压力的变化快速转换到恒功率工作曲线下对应的流量状态，所设计的H。控制器能够减小干扰和模型参数不确定对系统稳定性的影响，具有良好的鲁棒性，表明该方法用于机载液压系统可以改善系统工作性能，提高系统功率的利用率。     

Relationship Between Corrosion Level of Steel Bar and Diameter of Corroded Sensing Steel Wire in Wireless Sensor

A kind of wireless sensor was previously developed,which is powered and transmit signals wirelessly instead of using an electrical connection to the embedded reinforcement.Based on this technique,the relationship between diameters of corroded sensing steel wires and corrosion levels of steel bars is established by experiments.Quadratic function is utilized to fit the experiment results,and the correlation coefficients are all larger than 0.95.Estimated corrosion levels of commonly used steel bars are given for different diameters of corroded sensing steel wires fractured due to corrosion.     

拓扑优化在机载计算机结构设计中的应用

为了解决机载计算机零件结构设计过程中出现的材料分布不合理及重量要求苛刻等问题，在设计过程中引入拓扑优化。介绍了基于变密度法的拓扑优化理论，以Hyperworks／Optistruct为拓扑优化分析平台，对某机载计算机零件进行了拓扑优化，确定了零件的最佳材料分布。结果表明：通过优化设计可以在保持零件基本结构性能的基础上减轻其重量。     

偏转弹头导弹控制系统设计与仿真

根据弹头的可偏转特性,利用无根多刚体系统动力学方法建立了偏转弹头导弹的动力学模型,并对通道间的耦合特性及弹头偏转对弹体运动的影响进行了分析。在此基础上,将通道间的耦合及弹头偏转对弹体运动的影响作为干扰项处理,将气动参数的非线性变化等效为标称参数的摄动,利用变结构控制理论设计了偏转弹头导弹的控制器。仿真结果表明,所设计的变结构控制器能够有效地减小和消除俯仰、偏航通道对滚转通道的耦合作用以及弹头偏转对弹体运动的影响,较好地抑制了导弹气动参数的摄动,具有较高的稳态精度和良好的动态性能。     

超声波流量计不同运算方式对比分析

温度漂移是影响超声波流量计测量精度的一个重要因素,本文从算法上提出一种不受其影响的数学模型,以使相应的硬件简单化.该方法已应用在超声波流量计中,收到了很好的效果.     

频率计数器在航天器信号频率测量中的适用性分析

从频率计数器的工作原理出发,分析了航天器测控通信中常用的调相信号、调频信号和相移键控信号的频率测量误差,给出了调相信号和调频信号的测量误差表达式。使用频率计数器对上述3种航天器信号进行了频率测量试验。理论分析和试验结果表明,频率计数器适用于航天器调相信号和调频信号的频率测量,不适用于相移键控信号的频率测量。在实际使用中,为保证测量精度,应根据被测信号的调制方式选择适当的测量方法。     

Monthly mean foF2 model for an African low-latitude station and comparison with IRI

We have employed the hourly values of the ionospheric F-region critical frequency (foF2) obtained from Ouagadougou ionosonde, Burkina Faso (geographic coordinates 12° N, 1.8° W) during the interval of 1985–1995 (solar cycle 22) and solar radio flux of 10 cm wavelength (F10.7) to develop a local model (LM) for the African low-latitude station. The model was developed from regression analysis method, using the two-segmented regression analysis. We validated LM with foF2 data from Korhogo observatory, Cote d’Ivorie (geographical coordinates 9.3° N, 5.4° W). LM as well as the International Reference Ionosphere (IRI) agrees well with observations. LM gave some improvement on the IRI-predicted foF2 values at the sunrise (06 LT) at all solar flux levels and in all seasons except June solstice. The performance of the models at the representing the salient features of the equatorial foF2 was presented. Considering daytime and nighttime performances, LM and IRI are comparable in low solar activity (LSA), LM performed better than IRI in moderate solar activity (MSA), while IRI performed better than LM in high solar activity (HSA). CCIR has a root mean square error (r.m.s.e), which is only 0.10 MHz lower than that of LM while LM has r.m.s.e, which is about 0.05 MHz lower than that of URSI. In general, our result shows that performance of IRI, especially the CCIR option of the IRI, is quite comparable with the LM. The improved performance of IRI is a reflection of the numerous contributions of ionospheric physicists in the African region, larger volume of data for the IRI and the diversity of data sources, as well as the successes of the IRI task force activities.