SRAM FPGA电离辐射效应试验研究

针对SRAM FPGA空间应用日益增多,以100万门SRAM FPGA为样品,进行了单粒子效应和电离总剂量效应辐照试验。单粒子试验结果是:试验用粒子最小LET为1.66 MeV·cm2/mg,出现SEU（单粒子翻转）;LET为4.17 MeV·cm2/mg,出现SEFI（单粒子功能中断）,通过重新配置,样品功能恢复正常;LET在1.66～64.8 MeV?cm2/mg范围内,未出现SEL（单粒子锁定）;试验发现,随SEU数量的累积,样品功耗电流会随之增加,对样品进行重新配置,电流恢复正常。电离总剂量辐照试验结果是:辐照总剂量75 krad(Si)时,2只样品功能正常,功耗电流未见明显变化。辐照到87 krad(Si)时,样品出现功能失效。试验表明SRAM FPGA属于SEU敏感的器件,且存在SEFI。SEU和SEFI会破坏器件功能,导致系统故障。空间应用SRAM FPGA必须进行抗单粒子加固设计,推荐的加固方法是三模冗余（TMR）配合定时重新配置（Scrubbing）。关键部位如控制系统慎用SRAM FPGA。     

航空发动机环形燃烧室噪声总声级的GMDH方法研究

采用数据处理的组合方法（GMDH）,研究航空发动机环形燃烧室测试数据。通过简单的二元二次回归原理来构造出下一代较为复杂的次级回归方程,并且利用＂优选原理＂淘汰掉次级回归方程中的那些不理想的项,得到燃烧室噪声总声级的高阶方程,获得较客观的描写复杂非线性系统的非线性模式。     

带导流叶排的轴流压气机级叶尖处理机匣容畸变特性

基于叶尖处理机匣轴流压气机叶排实验特性,应用畸变传递的矩阵分析模型,分析了进口导流叶排对叶尖处理机匣结构容总压畸变特性影响,初步建立了在进口导流叶排下几种处理机匣结构对总压畸变及其沿轴流压气机叶排衰减特性影响规律。计算结果表明,叶尖处理机匣虽均能有效提高压气机级的稳定工作范围,但削弱了转子叶排和静子叶排的抗总压畸变能力,这对设计合理的扩大轴流压气机稳定裕度处理机匣结构尤为重要。      

7一种双S形进气道流场特性殛控制的试验研究

In order to provide the line of-sight blockage of the engine face for an advanced Uninhabited Combat Air Vehicle(UCAV), a highly curved serpentine inlet is proposed and experimentally studied. Based on the static pressure distribut ion measurement along the wall, the flow separation is found at the top wall of the second S duct for the baseline inlet design, which yields a high flow distortion at the exit plane. To improve the flow uniformity, a single array of vortex generators (VGs) is employed within the inlet. In this experimental study, the effects of mass flow ratio, free stream Mach number, angle of attack and yaw on the performance of a serpentine inlet instrumented with VGs are obtained. Results indicate: (1) Compared with the baseline serpentine design without flow control the application of the VGs promotes the mixing of core flow and the low momentum flow in the boundary layer and thus prevents the flow separation. Under the design condition, the exit flow distortion (

) decreases from 11. 7% to 2.3% by using the VGs. (2) With the descent of the free stream Mach number the total pressure loss decreases. How ever, the circular total pressure distortion increases. When the angle of attack rises from - 4° to 8°, the total pressure recovery and the circular total pressure distortion both go down. In addition, with the increase of yaw the total pressure recovery is fairly constant, while the circular total pressure distortion ascends gradually. (3) When Ma₀=0.6-0.8, α= −4°-8° and β= 0°-6°, the total pressure recovery varies between 0.936 and 0.961, the circular total pressure distortion coefficient varies between 1.4% and 5.4% and the synthesis distortion coefficient has a ranges from 3.8% to 7.0%. The experimental results confirm the excellent performance of the newly designed serpentine inlet incorporating VGs.     

内反射红外光谱在污染物成分测试中的应用

介绍了内反射光谱的原理及其在放气沉积污染物成分测试中的应用。     

神经网络在逆变器控制中的应用

针对传统的基于最优消谐波理论的逆变器 ,应用了一种全新的神经网络控制器。当系统工作时 ,由在线神经网络实时调节逆变器输出电压的大小 ;同时各功率管的开关角由另一个神经网络通过对最优 PWM最优开关角的拟合 ,直接计算出来。整个控制系统具有结构简单、反应灵敏、调压精确、输出电能质量高且全数字化的特点。     

亚、跨、超音速风洞控制系统

利用ＰＣ总线工业控制计算机及有关功能组件，组成ＨＧ－４亚、跨、超音速风洞控制系统，实现超音速总压Ｐ０及亚、跨音速马赫数Ｍ自动调节，进一步提高吹风过程自动化。     

有理Bézier曲线的全正性与形状调控

本文证明了有理Bézier曲线的全正性,并由此推出有向角性质与变差减缩性质,还提出了对曲线形状进行调整与控制的几种方法。     

基于博弈均衡分析的电子战战法

用定量分析的方法开发电子战战法是海军战役规划中必须解决的重要问题.借助仿真和博弈分析的混合方法,在博弈效用函数计算的基础上,构建基于识别真、假目标以及火力命中目标概率的二人非零和(TPNZS)非合作博弈模型来开发电子战战法,对一个典型的舰载导弹防空系统的初步研究表明:电子进攻与电子防御的战法分别为π*=(0,π*2,1-π*2)=(0.0000,0.5890,0.4110)和Δ*=(0.0000,0.0000,Δ*3)=(0.0000,0.0000,1.0000).     

Three dimensional investigation of the shock train structure in a convergent–divergent nozzle

Three-dimensional computational fluid dynamics analyses have been employed to study the compressible and turbulent flow of the shock train in a convergent–divergent nozzle. The primary goal is to determine the behavior, location, and number of shocks. In this context, full multi-grid initialization, Reynolds stress turbulence model (RSM), and the grid adaption techniques in the Fluent software are utilized under the 3D investigation. The results showed that RSM solution matches with the experimental data suitably. The effects of applying heat generation sources and changing inlet flow total temperature have been investigated. Our simulations showed that changes in the heat generation rate and total temperature of the intake flow influence on the starting point of shock, shock strength, minimum pressure, as well as the maximum flow Mach number.